Question is ⇒ A potential difference is developed across a current carrying metal strip when the strip is placed in a transverse magnetic field. The above effect is known as, Options are ⇒ (A) Fermi's effect, (B) Photo electric effect, (C) Joule's effect, (D) Hall's effect, (E) , Leave your comments or Download question paper.

Question is ⇒ A potential difference is developed across a current carrying metal strip when the strip is placed in a transverse magnetic field. The above effect is known as, Options are ⇒ (A) Fermi's effect, (B) Photo electric effect, (C) Joule's effect, (D) Hall's effect, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A potential difference is developed across a current carrying metal strip when the strip is placed in a transverse magnetic field. The above effect is known as
A.	Fermi's effect [Wrong Answer]
B.	Photo electric effect [Wrong Answer]
C.	Joule's effect [Wrong Answer]
D.	Hall's effect [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A dominant wave is characterised by which of the following?
No attenuation
Lowest cut off wavelength
Highest cut off wavelength
All of the above

⇒ For the wave shown in figure, the average valu
14.14 A
15 A
17.17 A
19.19 A

⇒ With negative feedback the closed loop gain is always less than open loop gain.
TRUE
FALSE

⇒ A white noise X(t) with two-sided power spectral density 1 x 10^-10 W/Hz is input to a filter whose magnitude squared response is shown be
5 x 10^-7W
1 x 10^-6W
2 x 10^-6W
5 x 10^-6W

⇒ The ASCII code is for information interchange by a binary code for
alphabet only
number only
alpha-numeric and other common symbols
none of these

⇒ The equivalent unit of joule is
newton
newton-meter
newton-metre²
none of the above

⇒ If temperature is increased, the temperature coefficient of a metal
increases
decreases
may increase or decrease
remains constant

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?
Half wave rectifier
Full wave rectifier
Bridge type full wave rectifier
Three phase full wave rectifier

⇒ An R-L circuit has an initial current of 5 A. In the s-domain equivalent circuit, the voltage source to take into account the initial current has a strength of
5L volts
5/L volts
5L² volts
5/L² volts

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ Which of the following is equivalent to AND-OR realization?
NAND-NOR
NOR-NOR
NOR-NAND
NAND-NAND

⇒ Following state diagram shows clocked sequential circ
6
7
5
4

⇒ Dielectric strength of polythene is around
10 kV/mm
40 kV/mm
100 kV/mm
140 kV/mm

⇒ The correct relation between energy and charge is
Energy = voltage/charge
Charge = Energy x voltage
Energy = voltage (charge)^0.5
Energy = voltage x charge

⇒ For ideal performance, a filter should be terminated in characteristic impedance.
TRUE
FALSE

⇒ In 8086
the registers SI and DI are used for string operation
the registers CS and DS are used for string operation
the registers SS and ES are used for string operation
the registers SI and SP are used for string operation

⇒ If X(z) = (1 - az^-1)^-1 and |a| < |z|, the initial value x₀ = 0
TRUE
FALSE

⇒ If 10 V is the peak voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit), then the maximum voltage on the reverse biased diode will be
20 V
14.14 V
10 V
7.8 V

⇒ If 1.5% of the output of an amplifier is feedback positively to the input, the minimum gain required of the amplifier for oscillations to occur, is
16.6
44.4
66.6
75

⇒ The internal structure of PL A is similar to
RAM
ROM
both RAM and ROM
neither RAM nor ROM

⇒ For the system with given characteristic equat
3, 2, 0
4, 0, 1
3, 0, 2
4, 1, 0

⇒ Which one of the following devices is not used as the controller in a stabilizer?
DIAC
TRIAC
SCR
Power transistor

⇒ An electromechanical device which actuates a train of step angular movements in response to a train of input pulses on one to one basis is
synchro control transformer
LVDT
stepper motor
tacho generator

⇒ The two terms used to describe performance of a directional coupler are
coupling and directivity
gain and coupling
gain and directivity
gain and isolation

⇒

Assertion (A): SUS is a PUT and avalanche diode connected between gate and cathode

Reason (R): SBS has two SUS inbuilt together and connected in anti-parallel

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ How many maximum number of functions can be defined with two symbols which are Boolean in nature:
4
8
2
16

⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000

⇒ A sinusoidal signal with peak to peak amplitude of 1.536 volt is quantized into 128 levels using a mid-rise uniform quantizer. The quantization noise power is
0.768 V
48 x 10^-6 V
12 x 10^-6 V
3.072 Volt

⇒ For a sinusoidal input, the circuit shown in the figure will act
Pulse generator
Full wave rectifier
Ramp generator
Voltage Doubler