Question is ⇒ Computers 'Basic input output system' is generally stored in RAM chips., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Computers 'Basic input output system' is generally stored in RAM chips., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Computers 'Basic input output system' is generally stored in RAM chips.
A.	TRUE [Correct Answer]
B.	FALSE [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A circuit has two branches in parallel and each branch has only one element. The applied voltage and source current are v = 200 sin (200t + 30°) and i = 50 sin (200t + 50°). If one branch has capacitor, the other branch contains
resistance
inductance
capacitance
resistance or capacitance

⇒ Discharge breakdown in insulators is due to voids.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Tangent galvanometer	1.	Can be used for dc only
B.	Moving coil instrument	2.	Integrating instrument
C.	Household energy meter	3.	Used for voltage measurement only
D.	Electrostatic instrument	4.	Absolute instrument

A-1, B-2, C-3, D-4
A-4, B-1, C-2, D-3
A-1, B-2, C-4, D-3
A-4, B-1, C-3, D-2

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ If the potential functions V₁ and V₂ satisfy Laplace's equation within a closed region and assume the same values on its surface, then which of the following is correct?
V₁ and V₂ are identical
V₁ is inversely proportional to V₂
V₁ has the same direction as V₂
V₁ has the same magnitude as V₂ but has different direction

⇒ In sinusoidal PWM for inverters the width of different pulses are not the same.
TRUE
FALSE

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ The forbidden energy gap between the valence band and conduction band will be least in case of
metals
semiconductors
insulators
all of the above

⇒ A communication satellite is a repeater between
a transmitting station and a receiving station
a transmitting station and many receiving station
many transmitting station and many receiving station
none

⇒ A mod 4 counter will count
from 0 to 4
from 0 to 3
from any number n to n + 4
none of the above

⇒ The current wave in figure is passed through 3 H inductor. The voltage across inductance during the period 2 < t < 3 second
12 V
- 12 V
6 V
- 6 V

⇒ ECL has high switching speed because the transistors are
switching between cutoff and saturation regions
switching between cutoff and active regions
switching between active and saturation regions
none of the above

⇒ The signal define by the equations u(t - a) = 0 for t < a and u(t - a) = 1 for t ≥ a is
a unit step function
a shifted unit step function orginating at t = a
a pulse function
none of the above

⇒ Counterpoise is used in coils having
high resistivity
low resistivity
medium resistivity
both (b) and (c)

⇒ The instrument used to check insulation of household wiring is
megger
ohmmeter
multimeter
high resistance voltmeter

⇒ In the given figure the E and H lines in a coaxial c
The radial lines are E lines and circular lines are H lines
Radial lines are H lines and circular lines are E lines
The directions of E and H lines are wrong
Radial lines may be E and H lines depending an direction of current

⇒ The encapsulation of transistor is necessary for
preventing radio interference
preventing photo-emission effects
avoiding loss of free electrons
mechanical ruggedness

⇒ The impedance parameter z₂₁ is
transfer impedance at port 1 with port 2 open circuited
transfer impedance at port 1 with port 2 short circuited
transfer impedance at port 2 with port 1 open circuited
transfer impedance at port 2 with port 1 short circuited

⇒ PCM employing 4 bit code is used to send data having frequency range from 0 to 2 kHz. The minimum required bandwidth of carrier channel is
2 kHz
4 kHz
8 kHz
16 kHz

⇒ Microprocessor 8088 has
16 bit registers and 16 bit data bus
8 bit registers and 8 bit data bus
8 bit registers and 16 bit data bus
16 bit registers and 8 bit data bus

⇒ Consider the following instruction of 8085 μp :

MOV M, A
AODC
MVI A, FF
CMP M

Which of these cause change in the status of flag(s)?
1 and 2
1, 2 and 3
3 and 4
2 and 4

⇒ The voltage gain of which transistor configuration is less than unity?
CB
CE
CC
None

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit
has low input impedance
has high input impedance
has very low input impedance
may have either low or high input impedance

⇒ A decoder can be used as a demultiplexer.
TRUE
FALSE

⇒ Which of the following operations will give the result 2 in C?
42857
4.0 / 2
4.0 / 2.0
4 / 2.0

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ Which of the following devices has metal-silicon junction?
General purpose power diode
Schottky diode
SCR
MOSFET

⇒ Space communication links are being increasingly moved into Ka-band (200-30 GHz) because it
offers a much wider available bandwidth
does not suffer from atmospheric at tenuation
permits the use of smaller antenna
does not suffer from rain attenuation

⇒ Find resistance R_B to bring transistor to threshold of saturation (V_CB = 0), V_BE = 0.7 V, a =
1.5 KΩ
15 KΩ
10 KΩ
1 KΩ

⇒ The integral of k δ(t) is
a step function of magnitude k
a step function 'of magnitude 1/k
a ramp of slope k
a ramp of slope 1/k