Question is ⇒ If Va0, Va1, Va2 are sequence components of Va and Ia0, Ia1, Ia2 are sequence components of Ia, then total 3 phase power P is given by, Options are ⇒ (A) P = Va0Ia0 + Va1Ia1 + Va2Ia2, (B) P = Va0Ia0 + Va1Ia1 + Va2Ia2*, (C) P = 3(Va0Ia0 + Va1Ia1 + Va2Ia2), (D) P = 3(Va0Ia0 + Va1Ia1 + Va2Ia2*), (E) , Leave your comments or Download question paper.

Question is ⇒ If Va0, Va1, Va2 are sequence components of Va and Ia0, Ia1, Ia2 are sequence components of Ia, then total 3 phase power P is given by, Options are ⇒ (A) P = Va0Ia0 + Va1Ia1 + Va2Ia2, (B) P = Va0Ia0 + Va1Ia1 + Va2Ia2*, (C) P = 3(Va0Ia0 + Va1Ia1 + Va2Ia2), (D) P = 3(Va0Ia0 + Va1Ia1 + Va2Ia2*), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If V_a0, V_a1, V_a2 are sequence components of V_a and I_a0, I_a1, I_a2 are sequence components of I_a, then total 3 phase power P is given by
A.	P = V_a0I_a0 + V_a1I_a1 + V_a2I_a2 [Wrong Answer]
B.	P = V_a0I_a0 + V_a1I_a1 + V_a2I_a2^* [Wrong Answer]
C.	P = 3(V_a0I_a0 + V_a1I_a1 + V_a2I_a2) [Wrong Answer]
D.	P = 3(V_a0I_a0 + V_a1I_a1 + V_a2I_a2^*) [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The common-drain amplifier, better known as the source follower, has a voltage gain __________ and the output signal is __________ with the input signal.
approaching unity, in phase
approaching unity, out of phase
is very high, in phase
is very high, in reverse phase

⇒ A limiter circuit can be built using a diode and resistance.
TRUE
FALSE

⇒ For an ideal noise free transistor amplifier the noise factor is
zero
zero dB
1 dB
depends on other factors

⇒ When the emitter current of a transistor is changed by 1 mA, its collector current changes by 0.990 mA. The common-emitter short-circuit current gain is
1
199
99
9.9

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒ In which configuration is ac collector voltage zero?
CE
CB
CC
none of the above

⇒

Assertion (A): For Diamond, μ_r = 1

Reason (R): Diamond is a diamagnetic material.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following flip-flop do not have race problem?
T flip-flop
D flip-flop
JK flip-flop
Master-slave flip-flop

⇒ A Darlington pair consist of
two CB amplifiers
two CC amplifiers
two cascaded CC amplifiers
two cascaded CE amplifiers

⇒ A fully controlled bridge converter feeds a highly inductive load such that the load current can be assumed to be constant. The wave shape of input current is
dc
sinusoidal
rectangular
none of the above

⇒ In figure, the current through 2 Ω resistanc
zero
-2A
2A
1A

⇒ A blank EPROM has
all bits set to logical 0
all bits set to logical 1
half the total number of bits set to 0 and remaining half to logical 1
either (a) or (b)

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point

⇒ In given figure the switch was closed for a long time before opening at t = 0. The voltage V_x at t = 0^{+25 V
50 V
-50 V
0 V}

⇒ The maximum positive and negative numbers which can be represented in 2's complement form using n bits are respectively
+(2^{n + 1} - 1), - (2^{n - 1} - 1)
+(2^{n + 1} - 1), - 2^{n - 1}
+2^{n - 1}, - 2^{n - 1}
+2^{n + 1}, - (2^{n - 1} + 1)

⇒ 1111 + 11111 =
101111
101110
111111
11111

⇒ Which of these has degenerate p and n materials?
Zener diode
PIN diode
Tunnel diode
Photo diode

⇒ - ve feedback in an amplifier
reduces gain
increase frequency and phase distortion
reduce bandwidth
increase noise

⇒

Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-length

Reason (R): When line is terminated in resistance R_L, the standing wave ratio is SWR = Z₀/R_L or R_L/Z₀

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Among the logic families, the family which can be used at very high frequency greater than 100 MHz in a 4 bit synchronous counter is
TTL
CMOS
ECL
TTLLS

⇒ At a temperature of about 1 K, aluminium is a
conductor
insulator
photoconductor
superconductor

⇒ A mod 4 counter will count
from 0 to 4
from 0 to 3
from any number n to n + 4
none of the above

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ The sensitivity of a superheterodyne receiver is determined by
the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ In waveguide Degenerate modes are
two mode having same cut off frequency
two mode having same power
two mode having same phase velocity
it is a hypothetical mode

⇒ What is the numerical aperture an optical fiber when critical angle is 30°?
0.5
0.704
0.866
0.2

⇒ What is the addressing mode used in instruction MOV M, C?
Direct
Indirect
Induced
Immediate

⇒ In Z_RC (s) = constant at s = 0, the last element in first Foster cauer realization is
R
C
R and C in series
R and C in parallel

⇒ Find equivalent capacitance if each capacitance is
56 F
6/5 F
6/10 F
5/12 F