Question is ⇒ Interference generated by electrical equipment and automobile ignition systems when observed closed to earth is, Options are ⇒ (A) horizontally polarized, (B) vertically polarized, (C) polarized both horizontally, (D) not polarized, (E) , Leave your comments or Download question paper.

Question is ⇒ Interference generated by electrical equipment and automobile ignition systems when observed closed to earth is, Options are ⇒ (A) horizontally polarized, (B) vertically polarized, (C) polarized both horizontally, (D) not polarized, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Interference generated by electrical equipment and automobile ignition systems when observed closed to earth is
A.	horizontally polarized [Wrong Answer]
B.	vertically polarized [Correct Answer]
C.	polarized both horizontally [Wrong Answer]
D.	not polarized [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A delay equalizer is a
low pass filter
band pass filter
all pass filter
high pass filter

⇒ The electron and hole concentration in a intrinsic semiconductor are n_i and P_i respectively when doped with a P type material, these change to n and P, respectively. Then
n + P = n_i + P_i
n + n_i = P + P_i
nP_i = n_iP
n_P = n_i P_i

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒ In colour television V and U signals are
same as I and Q signal
same as R - Y and B - Y
modified I and Q signal
modified R - Y and B - Y

⇒ The maximum range of a radar is proportional to
square root of peak transmitted pulse power
fourth root of peak transmitted pulse power
peak transmitted pulse power
none of the above

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be
26 kHz
260 kHz
26 MHz
260 MHz

⇒ In 8086 a word OA 50 FH is stored in 02 and 03 memory locations. Then
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 02
OFH is stored at location 03 and 0 A 5 at location 02 and address of word in 02
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 03
OFH is stored at location 03 and 0 A 5 at location 02 and address of word is 03

⇒ Noise which assumes great importance at high frequencies is
flicker noise
Johnson noise
transit-time noise
shot noise

⇒ In indicating instruments the controlling torque is provided by a spring.
TRUE
FALSE

⇒ If f(t) = A d(t - a), F(s) is
A e^-as
A e^as
A a e^-as
Aa e^as

⇒ Even at room temperature, an intrinsic semiconductor has some holes. These holes are due to
electron
doping
thermal energy
free electrons

⇒ A string variable in Basic is
an alphabet followed by dollar sign
a digit followed by dollar sign
either (a) or (b)
neither (a) nor (b)

⇒ The current gain of a bipolar transistor drops at high frequencies because of
transistor capacitance
high current effects in the base
parasitic inductive elements
the early effect

⇒ In a series regulated power supply circuit the voltage gain of pass transistor satisfies the condition
A_v → ∞
1 << A_v → ∞
A_v ≈ 1
A_v << 1

⇒ In Z_RC (s) = 0 at s = ∞, the last element in first Cauer form is
R
C
R and C in series
R and C in parallel

⇒ Which of the following quantities cannot be measured/determined using Hall effect?
Type of semiconductor (p or n)
Mobility of charge carriers
Diffusion constant
Carrier concentration

⇒ Which of the following theorems is a manifestation of law of conservation of energy?
Tellegen's theorem
Reciprocity theorem
Thevenin's theorem
Norton's theorem

⇒ The highest modulation frequencies typically used in FM broadcast is
5 kHz
10 kHz
15 kHz
25 kHz

⇒ Most electromagnetic transmission in rectangular wave-guide uses
TE₁₀ mode
TE₀₁ mode
TE₂₀ mode
TE_₁₁ mode

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ In an underdamped RLC series circuit, the natural frequency is ω_n. The frequency of damped oscillations is
ω_n
less than ω_n
more than ω_n
2 ω_n

⇒ In a D-type latch EN = 1, D = 1, the O/P is
1
0
don't care
blocked

⇒ A computer monitor uses 180 W in normal operation and 20 W in sleep mode. The computer is on all the 24 hours but is in sleep mode for 18 hours a days. The energy units saved in 30 days are
0.54 units
86.4 units
2.88 units
4.8 units

⇒ For an n-channel JEFT having drain source voltage constant if the gate source voltage is increased (more negative) pinch off would occur for
high values of drain current
saturation values of drain current
zero drain current
gate current equal to the drain current

⇒ While keeping the down-link frequency constant, the diameter of a satellite antenna is reduced by half. To offer the same EIRP over the increased coverage area, the RF output power has to be increases by a factor of
2
4
8
16

⇒ A single phase full bridge inverter for R-L loads needs
4 thyristors
4 thyristors and 4 diodes
4 thyristors and 2 diodes
8 thyristors

⇒ The transfer function V₂/V₁ for figure
a zero at origin
a zero at infinity
no zero
a zero at j1

⇒

Assertion (A): Interfacing means synchronisation of digital information transmission between input output devices and computer.

Reason (R): A computer with higher bit word size executes programs at a faster rate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following integer expressions is incorrect in Pascal?
L div M + P
A * * B
A div B - C
A mod B