Question is ⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be, Options are ⇒ (A) 0.4456°, (B) 1.4456°, (C) 2.4456°, (D) 3.4456°, (E) , Leave your comments or Download question paper.

Question is ⇒ An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be, Options are ⇒ (A) 0.4456°, (B) 1.4456°, (C) 2.4456°, (D) 3.4456°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An antenna has a gain of 44 dB. Assuming that the main beam of the antenna is circular in cross-section the beamwidth will be
A.	0.4456° [Wrong Answer]
B.	1.4456° [Wrong Answer]
C.	2.4456° [Correct Answer]
D.	3.4456° [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Z-inverse of the given Z-transform is _______
unit step
unit ramp
unit impulse
unit parabola

⇒ Which one of the following statement is correct?
Both Laplace's (L) and Poisson's (P) equation are non linear
L is non linear but P is linear
L is linear but P is non linear
L, P both is linear

⇒ The number of layers in a Shockley diode are
2
3
4
2 or 3

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ As the temperature increases the mobility of electrons __________ .
decreases because the number of carries increases with increased collisions
increases because the number of carries decreases with decreased collisions
remains same
none of the above

⇒ The total electrical energy emitted overall space from an electron of charge e and radius r is
e/ε₀r²
e²/ε₀r
e²/4pε₀r²
e²/8pε₀r

⇒ The function A e^st where s = s + jω represents
A phasor whose magnitude changes with time
A phasor whose frequency is ω
A phasor rotating in counterclockwise direction at angular frequency ω and whose magnitude increases with t
A phasor rotating in clockwise direction at angular frequency ω and whose magnitude increases with t

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ Tuned voltage amplifiers are not used
radio receivers
public address system
T.V. Receivers
band of freq. selected and amplified

⇒ In 8085 microprocessor system, can an input and output port have same port address?
Yes
No
Insufficient data
None of these

⇒

Assertion (A): Demorgan's first theorem replaces a NOR gate by bubbled AND gate.

Reason (R): Double complement of a variable equals the variable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A parallel plate capacitor has its length, width and separation doubled. It fringing effects are neglected, to keep the capacitance same, the dielectric constant must be
halved
kept the same
doubled
made 4 times

⇒ A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
5.85 V
6 V
5 V
10 V

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ The average value of the wavefor
2 V
0 V
4 V
3 V

⇒ As compared to BJT, MOSFET has
lower switching losses and higher conduction losses
higher switching losses and higher conduction losses
higher switching losses and lower conduction losses
lower switching losses and lower conduction losses

⇒ In following circuit, steady state is reached with S open, S is closed at t = 0, the current I at t = 0⁺ is give
9 Ω
6 Ω
7 Ω
10 Ω

⇒ Resistivity of semiconductors is around 100 Ω-m.
TRUE
FALSE

⇒ Power transistors are invariably provided with
soldered connections
heat sink
metallic casing
none of the above

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒ In following figure, what will be R₁ and R₂ for maximum symmetrical swing if V_CSat ≈ 0. Given that R_E = 200 Ω, R_C = 400 Ω, V_CC = 20 V, β
6 k
3 k, 6 k
9.9 k, 2.4 k
2.4 k, 9.9 k

⇒ A buffer amplifier should have
high output impedance and high input impedance
high output impedance and low input impedance
low output impedance an low input impedance
low output impedance and high input impedance

⇒ Which of these has 3 layers?
PIN diode
Zener diode
Schottky diode
Photo diode

⇒ When there is rapid attenuation of field inside the conductor, the field current are concentrated close to the surface of the conductor; this phenomenon is called
skin effect
EM concentration effect
Faraday's effect
Ohm's effect

⇒ Surface impedance at high frequencies is a consideration for
good conductors
semiconductors
dielectrics
ferrites

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ An electron shell corresponding to principal quantum number n can contain a maximum of
n² electrons
2n² electrons
2n electron
n³ electron

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒ Consider the following circuit configuration

common Emitter
common Base
emitter follower
emitter follower using Darlington pair.

The correct sequence in increasing order of I/P impedance of these configuration:
2, 1, 4, 3
1, 2, 4, 3
2, 1, 3, 4
1, 2, 3, 4