Question is ⇒ Thermal runaway is not possible in FET, because as the temperature of FET increases., Options are ⇒ (A) the mobility decreases, (B) the transconductance increases, (C) impedance of the source, (D) power dissipation in the chip, (E) , Leave your comments or Download question paper.

Question is ⇒ Thermal runaway is not possible in FET, because as the temperature of FET increases., Options are ⇒ (A) the mobility decreases, (B) the transconductance increases, (C) impedance of the source, (D) power dissipation in the chip, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Thermal runaway is not possible in FET, because as the temperature of FET increases.
A.	the mobility decreases [Wrong Answer]
B.	the transconductance increases [Correct Answer]
C.	impedance of the source [Wrong Answer]
D.	power dissipation in the chip [Wrong Answer]
View Answer 3 -14 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
498 ± 8
498 ± 4
498 ± 11
498 ± 13

⇒ In figure what is value of I_C if β_dc = 100. Neglect V_{BE5 mA
5 μA
10 mA
10 μA}

⇒ Which of the following pulse-time modulation is least used?
PDM
PPM
PWM
PAM

⇒ The number of accumulators in 6800 are
2
3
1
4

⇒ Multiplex techniques are used for
low density communications
low density point-to-point communications
high-density point-to-point communications
all of the above

⇒ A helical antenna is used for satellite tracking due to its
good front to back ratio
broad bandwidth
circular polarization
both (a) and (b)

⇒ For the system in the given figure, the characteristic equation
s² + s(3 + 6a) + 6 = 0
s² + s(3 + 12a) + 12 = 0
s² + 3s = 0
s² + 6s = 0

⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
1.2 kΩ
80 Ω
50 W
0

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ For a system to be designated as hi-fi, the signal to noise ratio should be at least
25 dB
50 dB
75 dB
100 dB

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon

⇒ Which of following antenna not produces circular polarisation?
Helical
Parabolic
Disc
Yagi

⇒ In a class C amplifier, full cycle conductor of the current is achieved by employing
tuned circuit
transformers
complementary pair
Push pull configuration

⇒ Which one of the following can be used as parallel to series converter?
Decoder
Digital counter
Multiplexer
Demultiplexer

⇒ A λ/4 long high frequency transmission line is terminated into one impedance Z_R. If Z₀ be the characteristic impedance of the line, then input impedance Z_in is
Z_oZ_R
Z²_R/Z_o
Z²₀/Z_R
Infinity

⇒ An alternating current or voltage is that which
changes in magnitude only
changes in direction only
both (a) and (b)
has a random movement of electrons

⇒ The main function of a balanced modulator is to
produce balanced modulation of a carrier wave
produce 100% modulation
suppress carrier signal in order to create a single-sideband or double sideband
limit noise picked by a receiver

⇒ Norton's theorem reduces a two terminal network to
a constant current source and an impedance is parallel
a constant current source and an impedance in series
a constant voltage source and an impedance in parallel
a constant voltage source and an impedance in series

⇒ The organisatioion of Intel memory chip 127256 is
32 K x 8
16 K x 8
32 K x 4
16 K x 4

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the value of propagation constant P will be
15.9 radians/km
31.8 radians/km
63.6 radians/km
105.4 radians/km

⇒ In a class C power amplifier the input signal has a frequency of 250 kHz. If the collector current pulses are 0.1 μs wide, the duty cycle of current waveform is
0.5
0.25
0.025
0.0025

⇒ The device most likely to be found in an SSB transmitter is
class C audio amplifier
tuned modulator
class B RF amplifier
class A RF amplifier

⇒ When a constant voltage source and constant current source are in series, the current source is ineffective.
TRUE
FALSE

⇒ An electric charge Q is placed in a dielectric medium which of the following quantities are independent of the dielectric constant ε of the medium
electric potential V and electric field intensity E
displacement density D and displacement φ
electric field intensity E and displacement φ
electric potential V and displacement φ

⇒ An oscilloscope has an input impedance consisting of 1 MΩ and 20 pF is parallel. A high impedance probe connected to input of this oscilloscope has a 10 MΩ series resistance. This 10 MΩ series resistance
may not be shunted
should be shunted by 2 pF capacitor
should be shunted by 20 pF capacitor
should be shunted by 200 pF capacitor

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒ Short circuited stubs are preferred to O.C stubs because
O.C stubs are incapable of giving full range of reactances
O.C stubs are liable to radiate
O.C stubs are difficult to make and connect
none of the above

⇒ In a digital counter the number of flip-flops is
always 2
always even
always odd
equal to the number of bits required in the final binary count

⇒ The storage battery used in power stations and substations is generally
nickel cadmium battery
lead acid battery
zinc carbon battery
zinc carbon or lead acid battery