Question is ⇒ A certain JK FF has tpd = 12 n sec the largest MOD counter that can be constructed from these FF and still operate up to 10 MHz is, Options are ⇒ (A) any, (B) 8, (C) 256, (D) 10, (E) , Leave your comments or Download question paper.

Question is ⇒ A certain JK FF has tpd = 12 n sec the largest MOD counter that can be constructed from these FF and still operate up to 10 MHz is, Options are ⇒ (A) any, (B) 8, (C) 256, (D) 10, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A certain JK FF has t_pd = 12 n sec the largest MOD counter that can be constructed from these FF and still operate up to 10 MHz is
A.	any [Wrong Answer]
B.	8 [Wrong Answer]
C.	256 [Correct Answer]
D.	10 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): L[af₁(t) + bf₂(t)] = aF₁(s) - bF₂(s)

Reason (R): Initial value theroem enables us to find the value of f(t) at t = 0 directly from F(s)

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In CCIR-B system, the time between start of one H syn. pulse and next is
64 μs
6.4 μs
640 μs
0.64 μs

⇒ A junction Field Effect Transistor can operate in
depletion mode only
enhancement mode only
depletion and enhancement modes
neither depletion nor enhancement modes

⇒ Debye temperature of metals is
about 10 K
about 200 K
about 600 K
about 2 K

⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
will be quarter
will be doubled
will increase by 50 percent
will increase by 25 percent

⇒ The units of thermal capacitance are
k cal/°C
°C/k cal
°C sec/k cal
none of the above

⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is
50 Hz
0 Hz
100 Hz
75 Hz

⇒ Audio systems use transverse recording.
TRUE
FALSE

⇒ While obtaining minimal SOP expression
all do not care terms are ignored
all do not care terms are treated as 1
all do not care terms are treated as 0
only such do not care terms which aid minimization are treated as 1

⇒ For an m x n matrix A, the eigen values are the roots of the characteristic equation
|I - A|
|λI - A| = 0
|λA - I| = 0
|A - I| = 0

⇒ Consider the following statements

An iron cored choke is non linear and passive device.
A carbon resistor kept in sunlight is a time invariant and passive device.
A dry cell is a time varying and active device.
An air capacitor is time invariant and passive device.

Of these statements
1, 2, 3 and 4 are correct
1, 2, 3 are correct
1, 2, 4 are correct
2 and 4 are correct

⇒ A system is highly oscillatory if
gain margin is high
gain margin is close to 1
gain margin is close to 1 or phase margin is zero
gain margin is high and phase margin is 180°

⇒

Assertion (A): F(s) is valid throughout s plane except at poles of F(s).

Reason (R): £[f₁(t) + f₂(t)] = £[f₁(t)] + £[f₂(t)]

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The function shown in figure, can represent a probability density function for A ________
A = 1/4
A = 1/6
A = 1/8
A = 1/2

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒ In figure V_CEQ for each transisto
V_CC
0.5 V_CC
0.75 V_CC
0.25 V_CC

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be
448 kHz
555 kHz
625 kHz
712 kHz

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ It is desired to design a phase shift oscillator using an FET having a g_m = 5000 μSiemen, r_d = 40 kΩ and feedback circuit value of R = 10 K. Then value of C for oscillator operation at 1 kHz and that of R_D for A = 40 to ensure oscillator action are
6.4 nF, 80 K
6.5 nF, 10 K
6.5 pF, 10 K
65 pF, 80 K

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ In the given figure, the combinations of two non touching loop
1
2
3
4

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The reflection coefficient will be
0.08 + j 0.32
0.32 + j 1.38
0.70 - j 2.97
1.1 + j 0.32

⇒

Assertion (A): JFET is a voltage controlled device.

Reason (R): The drain current can be controlled by controlling V_GS.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒ In the circuit of figure the current through 5 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ For an R-C impedance function, the residues at all poles are
real
imaginary
real and positive
positive