Question is ⇒ The input voltage for starting oscillations in an oscillator is caused by, Options are ⇒ (A) negative feedback, (B) positive feedback, (C) noise voltage in resistors, (D) a special generator, (E) , Leave your comments or Download question paper.

Question is ⇒ The input voltage for starting oscillations in an oscillator is caused by, Options are ⇒ (A) negative feedback, (B) positive feedback, (C) noise voltage in resistors, (D) a special generator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The input voltage for starting oscillations in an oscillator is caused by
A.	negative feedback [Wrong Answer]
B.	positive feedback [Wrong Answer]
C.	noise voltage in resistors [Correct Answer]
D.	a special generator [Wrong Answer]
View Answer 4 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks

⇒ Out of modes TE₂₀ and TE₃₀ of propagation of electromagnetic engery
both have the same cutoff frequency
TE₂₀ has lower cut off frequency as compared to TE₃₀
TE₃₀ has lower cutoff frequency as compared to TE₂₀
either (a) or (c)

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Secondary emission is always decremental.
TRUE
FALSE

⇒ A constant k band stop filter has cutoff frequencies of 1000 and 4000 Hz. The attenuation will be maximum when frequency is
4000 Hz
3000 Hz
2000 Hz
1000 Hz

⇒ The resistance of the aluminium conductor (r = 2.83 x 10^-8 Ωm) in figur
0.001 Ω
less than 0.001 Ω
more than 0.001 Ω
more than 0.002 Ω

⇒ A microprocessor is generally
single chip SSI
single chip MSI
single chip LSI
any of the above

⇒

Match the following:

	List I (Instrument)		List II (Parameters)
A.	Moving coil galvanometer	1.	High inertia, soft spring control
B.	Ballistic galvanometer	2.	No control, high damping
C.	Vibration galvanometer	3.	Soft spring control, critical damping
D.	Moving coil flux meter	4.	Low inertia, tuned spring control

A-4, B-2, C-3, D-1
A-1, B-3, C-2, D-4
A-2, B-1, C-4, D-3
A-3, B-1, C-4, D-2

⇒ In TV transmission the modulation schemes for video and audio are respectively
FM and AM
FM and FM
AM and FM
AM and AM

⇒ Two similar coupled coils are connected in series. The total inductance in series aiding connection is 100 mH. If currents is 3 A, the energy stored in magnetic field is
0.9 J
0.45 J
0.225 J
1.8 J

⇒ Dynamic memory cells are constructed using
FETs
MOSFETs
Transistors
Flip flops

⇒ In the sale of diamonds the unit of weight is carat. One carat is equal to
100 mg
150 mg
200 mg
500 mg

⇒ The ASCII code is for information interchange by a binary code for
alphabet only
number only
alpha-numeric and other common symbols
none of these

⇒ RAMs can be built with bipolar or CMOS transistor RAMs that are not possible with bipolar transistors are
SRAM
SRAM, DRAM
DRAM
PROM

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Figure represen
JFET shunt switching circuit
JFET series switching circuit
JFET analog switch
multiplexing

⇒ A NAND gate has 3 inputs and one output. The number of thyristors required for this gate are
1
2
3
3 or 4

⇒ Find R_{AB2 Ω
1.5 Ω
3 Ω
None of the above}

⇒ Which distortion is least objectionable in case of audio amplifiers?
Phase distortion
Frequency distortion
Harmonic distortion
Inter-modulation distortion

⇒ Which of the following statements is non-executable in FORTRAN 77?
DO
ASSIGN
END
DIMENSION

⇒ If the target area is small compared to wavelength of radar the situation is called
resonance region
Rayleigh region
optical region
binomial region

⇒ A system with transfer function H(z) has impulse response h(.) defined as h(2) = 1, h(3) = -1 and h(k) = 0 otherwise. Consider the following statem
Only S2 is true
Both S1 and S2 are false
Both S1 and S2 are true, and S2 is a reason for S1
Both S1 and S2 are true, but S2 is not a reason for S1

⇒ Barkhausen criterion is 1 + A_vβ = 0.
TRUE
FALSE

⇒ The number of stator field windings in an ac tachometer are
1
2
3
4

⇒ A nibble corresponds to
2 successive bits of data
4 successive bits of data
8 successive bits of data
16 successive bits of data

⇒ Consider the following statements as regards pulse repetition frequency

Pulse interval should be as large as possible so that a pulse returns before next pulse is transmitted
Greater the number of pulses reflected from a target, greater is the probability of distinguishing it from the noise

Which of the above are correct?
1 only
2 only
both 1 and 2
neither 1 nor 2

⇒ The current distribution along a travelling wave antenna can be written in the form
f(z) = f₀e^-jβ_z
f(z) = f₀ sin β_z
f(z) = f₀
f(z) = f₀ cos (ωt - β_z)

⇒ An intrinsic silicon sample has 1 million free electrons at room temperature. As the temperature is increased
the number of free electrons increases
the number of free electrons increases but the number of holes decreases
the number of free electrons and holes increase by the same amount
the number of free electrons and holes increase but not by the same amount

⇒ If a RAM has 34 bits in its MAR and 16 bits in its MDR, then its capacity will be
32 GB
16 GB
32 MB
16 MB

⇒ In the graph shown in the figure, for the tree with branches b, d and f the fundamental loops would inclu
abf, def, bdea
bdc, def, fba
abde, def, cdb
cea, bdea, abbf