Question is ⇒ For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (VSB > 0), the threshold voltage VT of the MOSFET will, Options are ⇒ (A) remain unchanged, (B) decrease, (C) change Polarity, (D) increase, (E) , Leave your comments or Download question paper.

Question is ⇒ For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (VSB > 0), the threshold voltage VT of the MOSFET will, Options are ⇒ (A) remain unchanged, (B) decrease, (C) change Polarity, (D) increase, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (V_SB > 0), the threshold voltage V_T of the MOSFET will
A.	remain unchanged [Correct Answer]
B.	decrease [Wrong Answer]
C.	change Polarity [Wrong Answer]
D.	increase [Wrong Answer]
View Answer 4 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): An op-amp amplifier can amplify dc signal

Reason (R): An op-amp amplifier is a direct coupled amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The unit of loudness is
phon
sone
decibel
mel

⇒ A network has only independent current sources and resistance. If values of all resistors are doubled, the values of node voltages
will become half
will remain unchanged
will become double
cannot be determined unless circuit configuration and values of resistors are known

⇒ A dc chopper is feeding an RLE load. The condition for maximum ripple is
a = 1
a = 0.8
a = 0.5
a < 0.5

⇒ Which SNR denotes excellent picture quality in TV?
50 dB
30 dB
15 dB
5 dB

⇒ As the ratio R_f/R_L increases the efficiency of a rectifier increases.
TRUE
FALSE

⇒ In a 100 turn coil, if the flux through each turn is (t³ - 2t)mW_b, the magnitude of the induced emf in the coil at a time of 4 sec is
46 mV
56 mV
4.6 V
5.6 V

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say

⇒ The integral of unit step function is a ramp of slope unity.
TRUE
FALSE

⇒ Two port network is said to be symmetrical if
Δ_h = 1
Z₁₁ = Z₂
A = Δ
all

⇒ Resistivity of metals is expressed in terms of
μ ohm
μ ohm/cm
μ ohm-cm
μ ohm-cm/°C

⇒ For a D/A converter, inputs and outputs are given. The output corresponding to digital input 01
2.0 V
2.5 V
3.0 V
4.0 V

⇒ What will be the propagation constant at 10 MHz?
3.4 radians/km
34.4 radians/km
344 radians/km
3440 radians/km

⇒ If σ is standard deviation, variation is
σ - 1
σ^1.5
σ²
σ³

⇒ When performing numerical calculations in floating point arithmetic

Error may occur due to finite representation of numbers.
Error may occur due to rounding.
Error may occur due to finite representation of inherently infinite process.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒

Assertion (A): Charge is dual of flux.

Reason (R): Short circuit is dual of open circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ When a constant voltage source and constant current source are in series, the current source is ineffective.
TRUE
FALSE

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ The units of μ₀ and μ_r are
H/m for both
H/m for μ_r and no units for μ₀
H/m for μ₀ and no units for μ_r
Wb/m for μ₀ and no units for μ_r

⇒ When a normal atom loses an electron
the atom loses one-proton simultaneously
rest of the electrons move faster
the atom becomes a positive ion
the atom becomes a negative ion

⇒ Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?
Computer communication system
Electromechanical communication system
PBX system
EPBX system

⇒ In a second order system with a unit step input, the speed of response is high if system is
overdamped
undamped system
critically damped
underdamped

⇒ In a D latch
data bit D is fed to S input and D to R input
data bit D is fed to R input and D to S input
data bit D is fed to both R and S inputs
data bit D is not fed to any input

⇒ The transition of electron from energy level W₁ to W₂ is associated with emission or absorption of electro magnetic radiation of frequency f such that
hf = |W₁ - W₂|
|W₁ - W₂|f = h
hf = 0.5|W₁ - W₂|
(hf)² = |W₁ - W₂|

⇒ Nichrome is used in
heater coils
underground cables
overheated wires
lamp filament

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ A sample of N type semiconductor has electron density of 6.25 x 10⁸/cm² at 300 K. If the intrinsic concentration of carriers in this sample is 2.5 x 10¹³/cm³ at this temperature, the hole density works out to be
10⁶/cm³
10⁸/cm³
10¹⁰/cm³
10^l2/cm³

⇒ The use of thermocouple meters for ac measurement leads to a scale which is
linear
square law
logarithmic
exponential

⇒ Which of the following is not an internal DOS command?
VER
COPY
MEM
DATE