Question is ⇒ The phenomenon of overlap in converter operation due to, Options are ⇒ (A) source resistance, (B) source inductance, (C) both source resistance and source inductance, (D) high value of firing angle, (E) , Leave your comments or Download question paper.

Question is ⇒ The phenomenon of overlap in converter operation due to, Options are ⇒ (A) source resistance, (B) source inductance, (C) both source resistance and source inductance, (D) high value of firing angle, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The phenomenon of overlap in converter operation due to
A.	source resistance [Wrong Answer]
B.	source inductance [Correct Answer]
C.	both source resistance and source inductance [Wrong Answer]
D.	high value of firing angle [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If the time is counted from the instant when an ac wave is at its peak value, we get a
sine wave
cosine wave
distorted sine wave
none of the above

⇒ The sampling frequency in CD is 10 kHz.
TRUE
FALSE

⇒ A multilevel decoder is more costly as compared to single level decoder.
TRUE
FALSE

⇒ Which of the following statement is false?
A stationary process is always a ergodic process
A ergodic process is always a stationary random process
It is possible to have a stationary random
None of the above

⇒ If (225)_Y = (165)₈ find value of Y
7
8
9
11

⇒ The magnitudes of OC and SC input impedances of a transmission line an 100 Ω and 25 Ω. The characteristic impedance is
25 Ω
50 Ω
75 Ω
100 Ω

⇒ A(A + B) =
A
A B
AB
AB

⇒ Which of the following statement number is not valid in Basic
12
521
662512
99999

⇒

Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ It f(t) is an odd function, the coefficients F_n in the exponential form of Fourier series
are real
are imaginary
are complex
may be real or imaginary

⇒ The use of a capacitor filter in a rectifier circuit gives satisfactory performance only when the load
current is high
current is low
voltage is high
voltage is low

⇒ In a conductor the current flow is due to
holes
electrons
ions
electrons and ions

⇒ For a BJT, avalanche multiplication factor depends on
V_CE
V_CB
V_BE
none

⇒

Match the following:

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
30 μC each
60 μC each
30 μC and 60 μC respectively
60 μC and 30 μC respectively

⇒ For the compensator in the given figure the maximum phase lea
sin^-1 (1/3)
30°
45°
60°

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ 50 independent low pass signals of bandwidth W, 2W, 3W, W, 2W, 3W, W, 2W, 3W Hz are to be time division multiplexer on a common channel using PAM. To achieve this, the minimum transmission capacity of the channel should be __________ .
1 Hz
12 Hz
3 Hz
6 Hz

⇒ Which of these commutation methods uses two leads?
Class A
Class B
Class C
Class D

⇒ What are the counting stages (Q₁, Q₂) for the counter shown in the figure be
11, 10, 00, 11, 10, ...
01, 10, 11, 00, 10, ...
00, 11, 01, 10, 00, ...
01, 10, 00, 01, 10, ...

⇒ The forbidden band in semiconductors is of the order of
6 eV
1 eV
10 eV
0.01 eV

⇒

Assertion (A): In class C amplifier the efficiency is more than that for other classes of amplifiers

Reason (R): In class C amplifier we can get high efficiency over a wideband

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In circular waveguide the attenuation of TE₀₁ mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TE_Q1 mode are completely circumferential.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The EHT voltage in a picture tube of TV is
about 1000 kV
about 100 kV
about 15 kV
about 1 kV

⇒ 11101₂ x 10001₂ =
111101101
111101100
11110
1100110

⇒ A DAC has full scale output of 5 V. If accuracy is ± 0.2% the maximum error for an output of 1 V is
5 mV
10 mV
2 mV
20 mV

⇒ The circuit shown in the figure, with R = 1/3 Ω, L = 1/4H, C = 3F has input voltage v(t) = sin2t. The resulting current i(t
5 sin (2t + 53.1°)
5 sin (2t - 53.1°)
25 sin (2t + 53.1°)
25 sin (2t - 53.1°)

⇒ If sound wave has an intensity of 10 Pa. The dB level is about
1.139 dB
11.39 dB
113.9 dB
1139 dB

⇒ The two port networks are connected in cascade, the combination is to be represented as a single two-Port network. The parameters of the network are obtained by multiplying the individual matrix
z-parameter
h-parameter
y-parameter
ABCD parameter

⇒ Calculate i(t) for t ≥ 0, assuming the switch has been in position A for a long time at t = 0, the switch is moved to positio
1 + e^{-5 x 10³t}
e^{-5 x 10³t}
1.11 e^{-5 x 10³t}
1.11 (1 - e^{-5 x 10³t})