Question is ⇒ A 2 bit binary multiplier can be implemented using, Options are ⇒ (A) 2 I/P only, (B) 2 I/P XORs and 4 I/P and gates only, (C) two 2 I/Ps NOR and one XNOR gate, (D) XOR gates and shift Register, (E) , Leave your comments or Download question paper.

Question is ⇒ A 2 bit binary multiplier can be implemented using, Options are ⇒ (A) 2 I/P only, (B) 2 I/P XORs and 4 I/P and gates only, (C) two 2 I/Ps NOR and one XNOR gate, (D) XOR gates and shift Register, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 2 bit binary multiplier can be implemented using
A.	2 I/P only [Wrong Answer]
B.	2 I/P XOR_s and 4 I/P and gates only [Correct Answer]
C.	two 2 I/P_s NOR and one XNOR gate [Wrong Answer]
D.	XOR gates and shift Register [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The noise figure of multicavity klystron amplifier is very low
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Output of signal generator	1.	Modulated
B.	Error signal from a synchro	2.	Digital
C.	Output of a JK flip flop	3.	Analog
D.	Signal received by radar	4.	Stoichastic

A-1, B-3, C-2, D-4
A-3, B-1, C-2, D-4
A-3, B-1, C-4, D-2
A-1, B-3, C-4, D-2

⇒ Which of the following is used in temperature alarm circuits?
Thermistor
Photoconductor
Transistor
Varistor

⇒ What will be the propagation constant at 10 MHz?
3.4 radians/km
34.4 radians/km
344 radians/km
3440 radians/km

⇒ Consider the sequence x(n) whose fourier transform X(e^jω) is depicted for - p ≤ ω ≤ p as shown in fig
1 - True, 2 - True, 3 - True, 4 - True
1 - False, 2 - True, 3 - False, 4 - True
1 - True, 2 - False, 3 - True, 4 - False
1 - False, 2 - False, 3 - False, 4 - True

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ Following figure repres
AND
OR
NAND
NOT

⇒ A half wave diode rectifier uses a diode having forward resistance of 50 ohms. The load resistance is also 50 ohms. Then the voltage regulation is
0.2
0.5
1
2

⇒ Consider the following statements:

In the 2's complement representation, negative numbers are stored in sign magnitude form.
Taking 2's complement is equivalent to sign change.
In a 4 bit complement representation of a binary number A.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.

Of these, the only true statements are
(I) and (III)
(I) and (IV)
(II) and (III)
(II) and (IV)

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ Fidelity of a receiver represents
the sensitivity expressed in terms of voltage that must be applied to the receiver input to give a standard output
the extent to which the receiver is capable of distinguishing between the desired signal and other frequencies
the variation of the output with the modulation frequency when the output impedance is a resistance
none of the above

⇒ I = dq/dt.
TRUE
FALSE

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ An accelerometer has a seismic mass of 0.05 kg and spring constant of 3 x 10⁵ N/m. If maximum displacement of mass is ± 1 mm, the maximum acceleration which can be measured is
30 m/s²
60 m/s²
90 m/s²
120 m/s²

⇒ The two port networks are connected in cascade, the combination is to be represented as a single two-Port network. The parameters of the network are obtained by multiplying the individual matrix
z-parameter
h-parameter
y-parameter
ABCD parameter

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2

⇒ Which of the following is open loop system?
Wind screen wiper
Aqualing
Respiratory system of animal
System for controlling antirocket missiles

⇒ Consider a 565 PLL with R_T = 10 kΩ and C_T = 0.01 μF. What is the output frequency of the VCO?
10 kHz
5 kHz
2.5 kHz
1.25 kHz

⇒ IF V_CC = 15 V, V_CEQ = 5 V and I_CQ = 50 mA, the efficiency in class A operation is
1
0.5
0.25
0.167

⇒ An unmodulated voltage 10 V effective is applied to a dioxide detector in which load resistance is 4 x 10^-5 ohms. A micrometer shows that the rectified DC current in this resistance is 30 A. The efficiency of detection is
0.34
0.555
0.688
0.847

⇒ A pulse train can be delayed by a finite number of clock periods by using
serial in-serial out shift register
parallel in serial out shift register
serial in-parallel out shift register
parallel in parallel out shift register

⇒ The current gain of a BJT is
g_m r₀
g_m/r₀
g_m r_p
g_m/r_p

⇒ Which of these has highly doped p and n region?
PIN diode
Tunnel diode
Schottky diode
Photodiode

⇒ Permeability is analogous to
conductivity
resistivity
retentivity
coercivity

⇒ The SID data received is
LSB first
LSB last
1
none of these

⇒ Consider the differential amplifier shown in figure. (Assume β is very hi
2 mA
1 mA
0.5 mA
3 mA

⇒ Which of the following components is essential for a voltage multiplier circuit?
Resistor
Inductor
Capacitor
Both (a) and (c)

⇒ If any term in the first column of a Routh array becomes zero, then
Routh criterion cannot be used to determine stability
Routh criterion can be used by substituting a small positive number for zero and completing the array
Routh criterion can be used by substituting a big positive number for zero and completing the array
Routh criterion can be used by substituting a small negative number for zero and completing the array