Question is ⇒ If A = 3 + j1, A4 =, Options are ⇒ (A) 3.16 ∠18.4°, (B) 100 ∠73.72°, (C) 100 ∠18.4°, (D) 3.16 ∠73.22°, (E) , Leave your comments or Download question paper.

Question is ⇒ If A = 3 + j1, A4 =, Options are ⇒ (A) 3.16 ∠18.4°, (B) 100 ∠73.72°, (C) 100 ∠18.4°, (D) 3.16 ∠73.22°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If A = 3 + j1, A⁴ =
A.	3.16 ∠18.4° [Wrong Answer]
B.	100 ∠73.72° [Correct Answer]
C.	100 ∠18.4° [Wrong Answer]
D.	3.16 ∠73.22° [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following

A signal f(t) and its Hilbert transform f_h(t) have the same energy density spectrum
A signal f(t) and its Hilbert transform, f_h(t) have the same auto correlation function
A signal f(t) and its Hilbert transform are mutually orthogonal

Which of the above are true?
1, 2 and 3
1 and 2 only
1 only
2 and 3 only

⇒ In a platinum RTD, the change in resistance for a temperature rise of 50° C is about
0.02
0.1
0.2
0.4

⇒ Some words like READ, WRITE, STOP etc. cannot be used as variable names in Fortran 77.
TRUE
FALSE

⇒ In the above case if another sine wave corresponding to 40% modulation is transmitted simultaneously, the total radiated power will be
9.9 kW
10.15 kW
10.84 kW
18.4 kW

⇒

Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.

Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A typical error rate on satellite circuits is one bit error in
10⁷
10³
10²
10¹⁰

⇒ Which of the following 8085 instructions do not effect CY flag?
SEE M
SEE R
DCRM
ADC M

⇒ Which of the following should be used in order to prevent overloading or the last IF amplifier in a receiver?
Variable selectivity
Variable sensitivity
Double conversion
Squelch

⇒ The advantage of using crystal oscillator is that it
requires low d.c. supply voltage
works at high frequency
gives high output voltage
gives constant frequency of oscillations

⇒ If J, I and a denote current density, current and area of cross section of a conductor, then
J = Ia
J = I/a²
J = I/a
J = Ia²

⇒ Which binary subtraction is incorrect?
100101 - 100011 = 000000
10000000 - 01000000 = 1000000
10111110.1 - 101011.11 = 110010.11
11111111 - 1111111 = 10000000

⇒ In a conductor the current flow is due to
holes
electrons
ions
electrons and ions

⇒ Which of the following pairs are correctly matched?

Brune's realisation : realisation with ideal transformer.
Cauer realisation : ladder realisation.
Bott Duffin realisation : with non ideal transformer.

Select the answer using the following codes:
1, 2 and 3
2 and 3
1 and 3
1 and 2

⇒ In a micro computer the control bus
transmits and receives control signals between processor and other devices
transmits and receives control signals, also sends and receives data
transmits and receives control signals, sends and receives data and transmits address of the device
none of the above

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ In a complex wave, the negative half of the wave is a reproduction of the positive half wave. Then
the wave contains only fundamental and third harmonic
the wave does not contain even harmonics
the wave does not contain odd harmonics
the wave does not contain triple harmonics

⇒ In graphical analysis of BJT amplifier the slope of ac line is more than that of dc load line.
TRUE
FALSE

⇒ The snubber circuit consists of
a capacitor connected in series with thyristor
a capacitor connected in parallel with thyristor
a resistor and capacitor in series connected across thyristor
none of the above

⇒ A voltage V_BB is applied across the terminals of a UJT. The emitter voltage at peak point is
hV_BB
(h + 1) V_BB
hV_BB + V_D
V_D

⇒ Common emitter transistor has
high current and high voltage gain
low current gain and low voltage gain
high current gain and low voltage gain
low current and voltage gain

⇒ A voltage V(t) which is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt² is measured by a true rms meter. The reading will be
0
4
2
16

⇒ Most of the amplification of the received signal is obtained in a superheterodyne receiver from the
IF stage
RF stage
power amplification stage
none of the above

⇒ Consider the following program in Ba
60, 20, 20, 30, 10
10, 30, 20, 20, 60
60, 20, 30, 10, 20
60, 30, 10, 20, 20

⇒ Two similar coils have self inductance of 1 mH each. Coefficient of coupling is 0.5. The mutual inductance M is
0.25 mH
0.5 mH
0.707 mH
1 mH

⇒ An audio signal is band limited to 4 kHz. It is sampled at 8 kHz. What will be the spectrum of the sampled signal?
-4 kHz to 4 kHz
-8 kHz to 8 kHz
every 4n kHz repeating
every ± 8 kHz and operating as well as at zero (k integer)

⇒ Non-coherently detection is not possible for
PSK
ASK
FSK
both (a) and (c)

⇒ In the interconnection of ideal sources shown in the figure, it is known that the 60V source is absorbing p
0.416666666666667
13 A
15 A
18 A

⇒ Which of the following microphones works on the piezoelectric effect?
Carbon
Condenser
Moving coil
Crystal

⇒ When a series RL circuit having power factor angle 0 is switched on to an ac voltage V_m sin (ωt + Φ), the transient term is zero if Φ = 0.
TRUE
FALSE

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50