Question is ⇒ A heterodyne frequency changer is called a, Options are ⇒ (A) Modulator, (B) Mixer, (C) Demodulator, (D) Frequency translator, (E) , Leave your comments or Download question paper.

Question is ⇒ A heterodyne frequency changer is called a, Options are ⇒ (A) Modulator, (B) Mixer, (C) Demodulator, (D) Frequency translator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A heterodyne frequency changer is called a
A.	Modulator [Wrong Answer]
B.	Mixer [Correct Answer]
C.	Demodulator [Wrong Answer]
D.	Frequency translator [Wrong Answer]
View Answer 4 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The Kirchoff's laws fail in which of the following circuits?
Linear circuits
Non-linear circuits
Lumped parameters circuits
Distributed parameters circuits

⇒ The probability giving distribution of electrons over a range of allowed energy levels is known as
Maxwell's Distribution
Fermi-Dirac Distribution
Richardson Dushman Distribution
none of the above

⇒ The primary reason for the widespread use of Si in semiconductor device technology is
abundance of Si on the surface of earth
larger band gap of Si in comparison to Ge
favourable properties of Silicon-dioxide (SiO₂)
lower melting point

⇒ A 10 MHz square wave clocks 5 bit ripple counter. The frequency of the 3rd FF output is
2 MHz
1.25 MHz
50 MHz
615 kHz

⇒ Consider the following logical IF statement in FORTRAN 77 IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 13, 11, 13
IF (SALT - PEPPER) 13, 11, 11
IF (SALT - PEPPER) 11, 13, 13

⇒ Regarding TASI which one of the following statements is wrong?
It snatches the channel in his speech and may allocate it to another speaker needing it.
The same speaker is reassigned a channel almost instantly when he speaks again even when the circuit is heavily loaded.
It increases the overall utilization of the transmission channel
Intercontinental callers sometimes confuse the effects of TASI with the effects of satellite delay.

⇒ Let f₁(t) = G₁(t) + 4, f₂(t) = G₂(t) + 3. If G₁(t) and G₂(t) are uncorrected then the correlation between f₁(t) and f₂(t) are
12
7
6
zero

⇒ The kinetic energy of free electrons in a metal is (where k is the de-Broglie wave number of the electron)
inversely proportional to k
inversely proportional to square of k
proportional to k
proportional to the square of k

⇒ Evaluate the value of 2 [u (t - 1) - u (1 - 2t)] (u ( t + 1) + u (t)) at t = 3 sec.
0
4
∞
1

⇒ The merging of a hole and an electron is called
recombination
covalent bonding
thermal union
none of the above

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ As the area of a public meeting increases the amplifier power output required increases.
TRUE
FALSE

⇒ Elements R, L, C are connected in parallel and excited by a dc current I. If i_R, i_L and i_C are the currents through R, L, C respectively then at t = 0
i_R > i_L > i_C
i_L > i_R > i_C
i_C = 0
i_C = I

⇒ As regards ferromagnetic Curie temperature Q_f and paramagnetic curie temperature θ
Q_f > θ
θ > Q_f
θ equal to or less than Q_f
θ may be equal to less than or more Q_f

⇒ Which of the following is used in temperature alarm circuits?
Thermistor
Photoconductor
Transistor
Varistor

⇒ Multiple member of antennas are arranged in arrays in order to enhance what property?
Both directivity and bandwidth
Only directivity
Only bandwidth
Neither directivity nor bandwidth

⇒ Consider the following statements

Gunn diode can be used in combinational logic circuits.
Gunn diode can be used in sequential logic circuits.
Both Gunn diode and GaAs Mesfet can be used in logic circuits.

Which of the above statements are correct?
1, 2, and 3
1 and 2 only
2 and 3 only
1 and 3 only

⇒ In figure base current is 10 μA and β_dc = 100. Then V_{E5 V
10 V
15 V
20 V}

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R

⇒

Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): A Darlington amplifier has very low output impedance

Reason (R): The circuit has a low resistance R_E between emitter and ground

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The transient currents are due to
resistance of the circuit
impedance of the circuit
voltage applied to the circuit
changes in stored energy in inductors and capacitors

⇒ Which element exhibits the property of inertia?
Resistance
Capacitance
Inductance
Both resistance and inductance

⇒ Crompton potentiometer has
14 coils and a slide wire all having the same resistance
14 coils and a slide wire but the resistance of slide wire is half that of each coil
14 coils each of different resistance
14 coils out of which 7 coils have resistance which is twice that of remaining 7 coils

⇒ The velocity factor of a transmission line
mainly depends on the skin effect
is always higher for a solid dielectric than for air
mainly depends on the dielectric constant of the material used
increases the velocity along the transmission line

⇒ If too large current passes through the diode
all electrons will leave
all holes will freeze
excessive heat may damage the diode
diode will emit light

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒

Match the following:

	List I		List II
A.	Word wrap	1.	interleaved execution of two or more programs by the same computer
B.	Client	2.	automatically moves a word to the next line if it does not fit in the current line
C.	Multitasking	3.	an application receiving data
D.	Landscape	4.	orientation of worksheet

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1
A-2, B-3, C-1, D-4

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ A coil resonates at 1 MHz with a resonating capacitance of 72 pF. At 500 pF, resonance is obtained with a resonating capacitor of 360 pF. The self capacitance of coil is
12 pF
24 pF
30 pF
72 pF