Question is ⇒ A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is, Options are ⇒ (A) 16, (B) 1.6, (C) 3.2, (D) 60, (E) , Leave your comments or Download question paper.

Question is ⇒ A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is, Options are ⇒ (A) 16, (B) 1.6, (C) 3.2, (D) 60, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is
A.	16 [Correct Answer]
B.	1.6 [Wrong Answer]
C.	3.2 [Wrong Answer]
D.	60 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz

⇒ Which of the following devices has the 'negative resistance' characteristic?
Reflex klystron
Gunn diode
P-N-P transistor
Magnetron

⇒ The function of duplexer in a RADAR is
to permit the use of same antenna for transmission and reception
to provide gain to the transmitted power
to amplify the received signal
both (b) and (c)

⇒ As per Hall effect, if any specimen carrying a current I is applied in a transverse magnetic field B, then an electric field E is induced in the specimen in the direction.
parallel to I
perpendicular to B and parallel to I
parallel to I and B
perpendicular to both I and B

⇒ When sources of different frequencies feed a network the only method of solution is superposition theorem.
TRUE
FALSE

⇒

Assertion (A): A JFET behaves as a resistor when V_GS < V_P.

Reason (R): When V_GS < V_P, the drain current in a JFET is almost constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The circuit of figure is ca
diode bias
current mirror
complementary mirror
none of the above

⇒ A TV receiver has 20 kV EHT supply and total beam current (for 3 electron guns) of 1500 μA. The power handled by IHVT is
3 W
30 W
300 W
0.3 W

⇒ Ferromagnetic materials show hysteresis in B - H characteristic. As the magnetic field in increased slowly from zero value, what is the first process which sets the material to give net magnetization?
Growth of favourably oriented domains at the cost of other domains by reversible boundary displacements
Growth of favourably oriented domains at the cost of other domains by irreversible boundary displacements
Domain wall orientation
A combination of processes (a) and (c) above

⇒ A Darlington circuit is obtained by connecting
two CB stages in cascade
two CE stages in cascade
a CE stages followed by CB stage
two emitter follower in cascade

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In figure the voltage distribution on a vertical earthed antenna is represented
curve A
curve B
curve C
curve D

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒ A capacitor behave to d.c. as
short-circuit
an open-circuit
it behaves to a.c.
none of these.

⇒ In a parallel resonant circuit, the circuit current at resonance is maximum.
TRUE
FALSE

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ A 200 Hz sound wave is to be transmitted by a 1000 kHz radio wave using frequency modulation. The instantaneous frequency variation will be
100 times a second
200 times a second
400 times a second
1000 times a second

⇒

Assertion (A): Magnetron is generally used in n mode.

Reason (R): Frequency for p mode can be easily separated from adjacent modes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒ For a P-N diode, the number of minority carriers crossing the junction depends on
forward bias voltage
potential barrier
rate of thermal generation of electron hole pairs
none of the above

⇒ When a plane wave is incident normally from dielectric '1' (μ₀, ε₁) onto dielectric '2' (μ₀, ε₂) the electric field of the transmitted wave is 2 times the electric field of the reflected wave. The ratio ε₂/ε₁ is
0.5
1
2
4

⇒

Assertion (A): Stubs, directional couplers and baluns are very commonly used in communication systems

Reason (R): Characteristic impedance of a line is an important parameter.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Energy = voltage x charge.
TRUE
FALSE

⇒ In a digital circuit, a clock is a
crystal type
multivibrator
flip-flop
free running multivibrator

⇒ In pulse width modulation of chopper
T is kept constant and T_on is varied
T_on is kept constant T is varied
both T and T_on are varied
either T or T_on is varied

⇒ A transistor has a power rating of 8 W for a case temperature of 25°C. If derating factor is 30 mW/°C, the power rating for 55°C, case temperature is
8 W
7.5 W
7.1 W
6.8 W

⇒ An op-amp integrating circuit uses
an inductor
a capacitor
both inductor and capacitor
none of the above

⇒ In figure we need an ac ground. The proper value of
1000 μF
100 μF
10 μF
1 μF

⇒ Trinitron is a monochrome picture tube.
TRUE
FALSE