Question is ⇒ When an SCR is in forward blocking mode, the applied voltage, Options are ⇒ (A) appears across only one junction, (B) is equally shared by two junctions, (C) is equally shared by three junctions, (D) may appear across one or more junctions, (E) , Leave your comments or Download question paper.

Question is ⇒ When an SCR is in forward blocking mode, the applied voltage, Options are ⇒ (A) appears across only one junction, (B) is equally shared by two junctions, (C) is equally shared by three junctions, (D) may appear across one or more junctions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When an SCR is in forward blocking mode, the applied voltage
A.	appears across only one junction [Correct Answer]
B.	is equally shared by two junctions [Wrong Answer]
C.	is equally shared by three junctions [Wrong Answer]
D.	may appear across one or more junctions [Wrong Answer]
View Answer 5 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a NAND SR latch of input is the normal resting state of inputs is
S = R = 1
S = 0, R = 1
S = 1, R = 0
S = R = 0

⇒ The parameter h₁₁ for CB circuit is higher than that for CE circuit.
TRUE
FALSE

⇒ Schrodinger wave equation is partial differential equation.
TRUE
FALSE

⇒

Assertion (A): Integral control action is sometimes called reset control.

Reason (R): Reset rate is expressed as number of repeats per unit time.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ An FM signal with deviation δ is passed through mixer. Its frequency is reduced five fold. The deviation in output of mixer is
0.28
δ
5 δ
very very high

⇒ Which of the following operations will give the result 2 in C?
42857
4.0 / 2
4.0 / 2.0
4 / 2.0

⇒ So-called 'grounded' antennas are often found insulated from the ground electrically.
TRUE
FALSE

⇒ In a half bridge inverter the gate pulses of the two thyristors have a phase displacement of
60°
90°
120°
180°

⇒ The maximum number of AM broadcast stations that can be accommodated in a 100 kHz bandwidth for the highest modulating frequency of 5 kHz will be
100
20
10
1

⇒ The number of electrons in motion at the instant of positive peak of a symmetrical ac wave is the same as that at the instant of negative peak.
TRUE
FALSE

⇒ The poles with greater displacement from the real axis correspond to
higher frequencies of oscillations
stable response
lower frequencies of oscillations
unbounded output

⇒ A device which converts BCD to seven segment is called
encoder
decoder
multiplexer
none of these

⇒ A narrow band FM does not have the following feature
it has two sidebands
both sideband equal in magnitude
both sideband have same Phase Difference
it does not show Amplitude variation

⇒ In disc mounting of SCR
SCR is clamped on one side of disc shaped heat sink
SCR is clamped between two disc shaped heat sinks
The SCR has low current rating
None of the above

⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization

⇒ The forbidden energy gap between the valence band and conduction band will be wide in case of
semiconductors
all metals
good conductors of electricity
insulators

⇒ For the discrete time system of the given fig
y_k = 0.5 u_{k - 2} - u_k - 0.25 y_k - 1
y_k = 0.5 u_k_{- 1} - u_k - 0.25 y_k - 1
y_k = 0.5 u_k - u_k_{- 1} - 0.25 y_k - 1
y_k = 0.5 u_k_{- 1} - u_k_{- 1} - 0.25 y_k - 1

⇒ For a symmetrical network
h₁₁ = h₂₂
h₁₂ = h₂₁
h₁₁ h₂₂ - h₁₂ h₂₁ = 0
h₁₁ h₂₂ - h₁₂ h₂₁ = 1

⇒

Assertion (A): FET is a unipolar device.

Reason (R): BJT is bipolar device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be
100 V
88 V
50 V
25 V

⇒ The power to the portable unit of a cordless telephone is provided by
pencil cells
dry cells
rechargeable cells
AC mains

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Figure shows characteristics curves for bipolar transistor. These curves
output characteristics of n-p-n transistor (common base)
output characteristics of p-n-p transistor (common base)
output characteristics of n-p-n transistor (common emitter)
output characteristics of p-n-p transistor (common emitter)

⇒ If an inductance L is connected in one arm of bridge and resistance R₁, R₂, R₃ in other three arms
the bridge cannot be balanced
the bridge can be balanced
the bridge is balanced for some specified value of frequency
the bridge is balanced for some specific values of R₁, R₂, R₃

⇒ A trigonometric function is synonyms to
orthogonal function
triangular function
singular function
none of the above

⇒ The rms voltage measured across each of the circuit element in figure is as shown, when the circuit is excited by a sinusoidal voltage E_s, the rms value of the source voltage e_{s10 volt
2 volt
E_s
5 volt}

⇒ Which is the displacement transducer with excellent sensitivity, linearity and resolution?
Incremental encoder
Absolute encoder
LVDT
Strain gauge

⇒ MS Access is a DBMS software.
TRUE
FALSE

⇒ A single phase full wave regulator feeds a resistive load. The firing angle of thyristors is 90°. The input power factor is
1
0.707 lagging
0.5 lagging
0.2 lagging

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300 K will be (in m²/s)
0.4
0.16
0.04
0.01