Question is ⇒ Which one of the following is a regulated power supply?, Options are ⇒ (A) IC 555, (B) IC 844, (C) IC 3080, (D) IC 723, (E) , Leave your comments or Download question paper.

Question is ⇒ Which one of the following is a regulated power supply?, Options are ⇒ (A) IC 555, (B) IC 844, (C) IC 3080, (D) IC 723, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which one of the following is a regulated power supply?
A.	IC 555 [Wrong Answer]
B.	IC 844 [Wrong Answer]
C.	IC 3080 [Wrong Answer]
D.	IC 723 [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 2 μF capacitor is shunted by a 1 kΩ maintained at temperature 400 K. The rms noise voltage across the capacitor over the entire frequency band is:
6.25 x 10^-8 V
5.25 x 10^-6 V
6.25 x 10^-6 V
5.25 x 10^-8 V

⇒ Bit is a unit of
entropy
information
channel capacity
rate of information

⇒ Decimal number 5436 when converted into 9's complement will become
4356
4653
4563
4655

⇒ In a TWT the amplitude of resultant wave travelling down the helix remains constant
TRUE
FALSE

⇒ The most serious problems in ac bridge measurement is
eddy currents
leakage current
residual magnetism
stray fields

⇒ When a capacitor is connected to the terminals of an ohmmeter, the pointer indicated a low resistance initially and finally come to infinity position. This shows that capacitor is
short circuited
all right
faulty
open circuited

⇒ The primary constants of a transmission line are
R and L
R, L and C
R and C
R, L, G and C

⇒ The number of programmable 16 bit registers of 6800 are
2
3
4
5

⇒ In figure, I_D = 4 mA. Then V_{S20 V
16 V
6 V
0.6 V}

⇒ Polarization is a measure of
dielectric constant per unit volume
voltage gradient to produce electrical breakdown
product of charge and distance
excess charge density

⇒ The integral of a unit impulse is unit step function.
TRUE
FALSE

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒ When a series RL circuit is switched on to a dc voltage, the rate of change of current is maximum at t = 0.
TRUE
FALSE

⇒ The log magnitude plot of the given figure is
type 0 system
type 1 system
type 2 system
either type 0 or type 1 system

⇒ In a ballistic galvanometer, a charge of 100 μC gives a first swing of 25°. The charge required to cause first swing of 50° is
200 μC
400 μC
50 μC
25 μC

⇒ In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.
TRUE
FALSE

⇒ ECL is a saturating logic.
TRUE
FALSE

⇒ If two network is connected in series-parallel connection then
h = [h_a] + [h_b]
[a_a] + [b_b]
[Z] = [Z_a] - [Z_b]
none

⇒ The no. of comparators required in a 3 bit comparator type ADC is
2
3
7
8

⇒

Assertion (A): The Fourier series of the wave shown in the figure does not contain even harmao
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Which of the statement is correct?
h and g matrices are inverse of each other
z and y matrices are inverse of each other
for reciprocal networks AD - BC = 1
ABCD parameters are used in transistor circuit

⇒ In an optional fiber the refractive index of cladding material should be
nearly 1
very low
less than that of core
more than that of core

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Bitwise inclusive OR
B.	&	2.	Bitwise AND
C.	\| \|	3.	Logical AND
D.	\|	4.	Logical OR

A-1, B-2, C-3, D-4
A-3, B-2, C-4, D-1
A-2, B-3, C-1, D-4
A-1, B-4, C-2, D-3

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling

⇒ Consider the following statements about diamagnetic material and diamagnetism.

The materials have negative magnetic susceptibility.
At very low temperature diamagnetic materials.

Which of the statements given above is/are correct?
1 only
2 only
Both 1 and 2
neither 1 nor 2

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a CE amplifier circuit the ac voltage between emitter and ground
is very high
may be high or low
is zero
depends on circuit configuration

⇒ In analog signal given below is sampled at such a rate that the samples of signal can be given to a collection of buffers having capacity of either 24 samples/sec. or 25 samples/sec. The sampling rate is minimum such that it fully utilizes the collection of both types of buffers m(t) = 2 sin 480pt + 3 sin 720 pt<
600 Hz
300 Hz
1200 Hz
2400 Hz

⇒ Consider the following in object oriented programming

Which of the above are correct?
All
1, 2 and 3 only
1 and 2 only
1, 2 and 4 only

⇒ Material which lack permanent magnetic dipoles are known as
paramagnetic
diamagnetic
ferromagnetic
ferrimagnetic

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math