Question is ⇒ The number of digits in octal system is, Options are ⇒ (A) 8, (B) 7, (C) 9, (D) 10, (E) , Leave your comments or Download question paper.

Question is ⇒ The number of digits in octal system is, Options are ⇒ (A) 8, (B) 7, (C) 9, (D) 10, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The number of digits in octal system is
A.	8 [Correct Answer]
B.	7 [Wrong Answer]
C.	9 [Wrong Answer]
D.	10 [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The power dissipated per gate
is constant at all frequencies
increases with frequency
decreases with frequency
may increase or decrease with frequency

⇒ Radar principle is used in
detection of aircraft
burglar alarms
garage door openers
all of the above

⇒ The figure shown below is designed to act as a constant current source across the load resistor. The β of transistor is 50. What is the value of load curr
1.96 mA
2 mA
2.04 mA
None

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A sine wave with slew rate distortion looks like
step wave
square wave
triangular wave
cosine wave

⇒ An arithmetic statement in C must be
integer mode arithmetic statement
real mode arithmetic statement
mixed mode arithmetic statement
any of the above

⇒ The percentage saving in power of 100% modulated suppressed carrier AM signal is
100
75
66.6
50

⇒ Degaussing in a picture tube means
Adding magnetism in mask and mounting frame
Removing residual magnetism in mask, shield etc...
Increasing resistance of coils to decrease time constant
Decreasing resistance of coils to increase time constant.

⇒ In a communication system, a process in which statistical averages and time averages are equal is called as,
stationary
ergodic
Gaussian
BIBO stable

⇒ A notch filter is sometimes used in communication receivers to
reduce receiver gain at some specific frequency
increase receiver gain at some specific frequency
made selectivity more precise
spread the bandwidth

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ For the port shown, the short circuit network function at port 2 is give
s + 1/4
s + 4
4s + 1
s + 16

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the guide wavelength for dominant mode.
13.5 m
3 m
88/3 m
3/88 m

⇒ Which of the following statement number is not valid in Basic
12
521
662512
99999

⇒ The logic realized by the circuit shown in figure belo
F = A - C
F = A + C
F = B ⊙ C
F = B ⊕ C

⇒ Which of the following is true as regards photo emission?
Velocity of emitted electrons is dependent on light intensity
Rate of photo emission is inversely proportional to light intensity
Maximum velocity of electron increases with decreasing wave length
Both holes and electrons are produced

⇒ In a transistor CE mode, V_CC = +30 V. If the transistor is in cut off region, V_CE =
+30 V
+20 V
10 V
zero

⇒

Assertion (A): A 3 phase wattmeter consists of two wattmeters mounted in one case.

Reason (R): Power measurement in a 3 phase circuit can be conveniently done by two wattmeter method.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A balanced modulator circuit uses
two identical diodes with same V-I characteristics
two triodes with different V-I characteristics
two diodes with different V-I characteristics
a diode and a triode

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ Number of fundamental cut-sets of any graph will be
same as the number of twigs
same as the number of tree branches
same as the number of nodes
equal to one

⇒ A λ/8 section of transmission line is determined of load impedance of (2 - j 5) Ω. If characteristic impedance of line is 10 Ω. Then input impedance of line is
10 Ω
(6.9 + j 7.24) Ω
(1.75 + j 3.098) Ω
(2 - j 5) Ω

⇒ In which counter does the maximum frequency depend on the modulus?
Synchronous
Ripple
Both synchronous and ripple
Neither synchronous nor ripple

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ In case of low level amplitude modulation system, the amplifiers following the modulated stage must be
class C amplifiers
linear devices
non-linear devices
harmonic devices

⇒ A voltage V(t) which is a Gaussian ergodic random process with a mean of zero and a variance of 4 volt² is measured by a true rms meter. The reading will be
0
4
2
16

⇒ If an amplifier with gain of - 100 and feedback of β = - 0.1 has a gain change of 20% due to temperature the change in gain of the feedback amplifier will be
0.0002
0.02
0.001
0.0001

⇒ In which of the following semiconductor are holes majority carriers
intrinsic
extrinsic
p type
n type

⇒

Assertion (A): Negative values of incremental operator in DO loop are allowed in Fortran 77 but not in earlier versions of Fortran.

Reason (R): Fortran 77 has better array facilities than earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct