Question is ⇒ A series R-C circuit with R = 3 Ω and XC = 4 Ω at 50 Hz is supplied with a voltage V = 50 + 141.4 sin 314 t. What is the RMS value of the current flowing through the circuit?, Options are ⇒ (A) 0.208333333333333, (B) 0.416666666666667, (C) 20 A, (D) 22-36 A, (E) , Leave your comments or Download question paper.

Question is ⇒ A series R-C circuit with R = 3 Ω and XC = 4 Ω at 50 Hz is supplied with a voltage V = 50 + 141.4 sin 314 t. What is the RMS value of the current flowing through the circuit?, Options are ⇒ (A) 0.208333333333333, (B) 0.416666666666667, (C) 20 A, (D) 22-36 A, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A series R-C circuit with R = 3 Ω and X_C = 4 Ω at 50 Hz is supplied with a voltage V = 50 + 141.4 sin 314 t. What is the RMS value of the current flowing through the circuit?
A.	0.208333333333333 [Wrong Answer]
B.	0.416666666666667 [Wrong Answer]
C.	20 A [Correct Answer]
D.	22-36 A [Wrong Answer]
View Answer 1 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a synchro transmitter, which coil acts as primary?
Rotor
Stator
Partly rotor and partly stator
Tertiary

⇒ Some ceramic materials become superconducting
below liquid helium temperature
between liquid helium and liquid nitrogen temperature
above liquid nitrogen but below room temperature
at room temperature

⇒ Which of the following is not a valid variable name in C?
1 a
a 1 2
a b 123
a b c 123

⇒ An astable multivibrator circuit using IC 555 timer is shown below. Assume that the circuit is oscillating stea
3 V to 5 V
3 V to 6 V
3.6 V to 6 V
3.6 V to 5 V

⇒ Some of MOS families are PMOS, NMOS, CMOS. The family dominating the LSI field where low power consumption is necessary is
NMOS
CMOS
PMOS
both NMOS and CMOS

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
5.12 W
21.78 W
2.56 W
16.81 W

⇒

Assertion (A): In C a variable name can have upto 8 characters and special symbols can also be part of variable name.

Reason (R): In C a type declaration at the beginning of program indicates the type of variable name used in the program.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒

Assertion (A): In root locus the breakaway and break in points either lie on real axis or occur in complex conjugate pairs.

Reason (R): All root locus asymptotes intersect on real axis.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ When subjected to alternating stresses, an insulating material is characterised by complex dielectric constant ∈^'_r - j∈^"_r . In such materials, the dielectric losses under alternating stress is proportional
∈^"_r
both ∈^'_r and ∈^"_r
∈^'_r
(∈^"_r)²

⇒ Which of the following is used in integrated circuits?
Microstrip line
Coaxial line
Twin wire line
Shield cable

⇒ For a second order system ω_n is natural frequency, ω_d is frequency of damped oscillations and ζ is damping factor. Then
ω_d = ω_n ξ
ω_d = ω_n (1 - ξ)²
ω_d = ω_n (1 - ξ)^0.5
ω_d = ω_n (1 - ξ²)^0.5

⇒ In the below figure the average load current is 15 A. The rms value of transformer secondary current
15 A
10.61 A
7.5 A
14.14 A

⇒ In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ
TRAP
INTR
RST 7.5
RST 5.5

⇒ A transistor has two p-n junctions. The batteries should be connected such that
both junctions are forward biased
both junctions are reverse biased
one junction is forward biased and the other is reverse biased
either (a) or (b)

⇒ In a polyatomic gas, the types of polarization which exist together are
electronic and orientational
electronic and ionic
ionic and orientational
electronic, orientational and ionic

⇒

Assertion (A): Silicon is preferred over germanium in manufacture of semiconductor devices.

Reason (R): Forbidden gap in silicon is more than that in germanium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 'n' bit sequence generator employing SR flip-flop has maximum length of the sequence as :
2ⁿ
n
2ⁿ - 1
2ⁿ^-1

⇒ In a half wave rectifier, the load current flows
only for the positive half cycle of the input signal
only for the negative half cycle of the input signal
for full cycle
for less than fourth cycle

⇒ The main advantage of CC amplifier is
High input impedance and low output impedance
Low input impedance and high output impedance
High voltage gain
High current gain

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ Which of the following term applies to troposcatter propagation?
SIDs
Faraday rotation
Atmospheric storms
Fading

⇒ In a Parallel connection of circuit the bandwidth in terms of R, L, C is
B = 1/RC
B = 1/RL
B = 1/RLC
B = RLC

⇒ The feedback control system shown in figure is sta
for all K ≥ 0
only if K ≥ 1
only if 0 ≤ K < 1
only if -1 ≤ K < 1

⇒ An intrinsic silicon sample has 2 million free electrons. The number of holes in the sample is
2 million
almost zero
more than 2 million
less than 2 million

⇒ Loss of charge method is suitable for medium resistances.
TRUE
FALSE

⇒ The equation D = ∈₀∈_r E refers only to isotropic materials.
TRUE
FALSE

⇒ For a sine wave the average value is calculated over half the cycle.
TRUE
FALSE

⇒

Assertion (A): A band elimination filter attenuates signals whose frequencies lie between the cutoff frequencies.

Reason (R): A band elimination circuit is very different from band pass circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which is correct for a driving point function?
If the real part of a pole or zero is zero, that pole must be simple
If the real part of a pole or zero is zero, that pole or zero must be simple
If the real part of a zero is zero, that pole or zero must be simple
If the real part of a zero is zero that zero must be simple