Question is ⇒ In order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instructions are needed?, Options are ⇒ (A) El only, (B) SIM only, (C) El and SIM only, (D) None, (E) , Leave your comments or Download question paper.

Question is ⇒ In order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instructions are needed?, Options are ⇒ (A) El only, (B) SIM only, (C) El and SIM only, (D) None, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In order to enable RST 5.5, RST 6.5 and RST 7.5 interrupts, which of the following instructions are needed?
A.	El only [Wrong Answer]
B.	SIM only [Wrong Answer]
C.	El and SIM only [Correct Answer]
D.	None [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The purpose of impedance matching in an amplifier circuit is to achieve
high efficiency
reduce distortion
maximum power transfer
none of the above

⇒ The number of variables in a function is odd and the number of minterms with even number of 0's are same as the number of minterms with odd number at 1 's, the expression formed can be represented in __________ as well as __________ form.
exclusive - OR, NOR
equivalence, exclusive - OR
AND, coincidence
OR, exclusive - OR

⇒ Which quantity controls the effectiveness of LED in emitting light?
Applied voltage
Current
Extent of doping
Temperature

⇒ In modern MOSFET_S, the material used for the gate is
high purity silicon
high purity silica
heavily doped polycrystalline silicon
epitaxial grown silicon

⇒ Which of the following characteristic are necessary for a sequential circuit?

It must have 6 gates
It must have feedback
Its output should depend on past value

Which of the above statements are correct?
1, 2, 3
1, 2
2, 3
1, 3

⇒ In a half wave diode rectifier circuit the current flows in the load circuit for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ A loop antenna is a commonly used for
radar
direction finding
satellite communication
all of the above

⇒ The HV and other voltage supplies for a TV receiver are obtained from IHVT. The full name for this device is
Internal high voltage transformer
Integrated high voltage transformer
Instant high voltage transformer
Interleaved high voltage transformer

⇒ In a CE amplifier connection, the emitter is at ground potential for
AC quantities
DC quantities
all quantities
none of the quantities

⇒ Strip lines are used at
microwave frequency
low frequency
High frequency
at any frequency

⇒ 10's complement of 16₁₀ is
83₁₀
84₁₀
38₁₀
48₁₀

⇒ The code which provides for parity check is
Baudot
ASCII
EBCDIC
Excess-3

⇒ Figure shows an R-L circuit. The current is i = 1 - e^-t. The rate of change of current at t = 1 secon
1 A/s
0.63 A/s
0.37 A/s
0

⇒ Which pair is correctly matched?
Symmetrical two port AD - BC = 1
Reciprocal two port z₁₁ = z₁₂
Inverse hybrid parameter A, B, C, D
hybrid parameter (V₁, I₂) = f(I₁, V₂)

⇒

Assertion (A): Doping level in extrinsic semiconductors is very small.

Reason (R): Additional of impurity in the ratio of 1 part in 10⁸ parts increases the number of charge carriers by about 20.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): Electric coupling, magnetic coupling and ground loop can cause unwanted high frequency oscillations.

Reason (R): Hartley oscillator uses a tapped inductor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A two port network is said to be reciprocal if
h₁₂ = - h₂₁
AD - BC = 1
y₁₂ = y₂₁
all

⇒ The core of a coil has a length of 10 cm. The self inductance is 8 mH. If the core length is doubled, all other quantities remaining the same, the self inductance will be
32 mH
16 mH
8 mH
4 mH

⇒ Household taperecorders generally use
crystal microphone
moving coil microphone
condenser microphone
cardioid microphone

⇒ The range of values of a and b for which the linear time invariant system with impulse respon
|a| > 1, |b| > 1
|a| < 1, |b| < 1
|a| < 1, |b| > 1
|a| > 1, |b| < 1

⇒ An instruction used to set the carry flag in a computer can be classified as
data transfer
arithmetic
Logical
program control

⇒ Heat in calories = I²Rt/4.186.
TRUE
FALSE

⇒ As the reverse voltage is increased, the depletion layer
becomes narrow
widens
remains the same
reduce to zero

⇒ The maximum permissible distance between two samples of a 2 kHz signal is
1000 μ sec
500 μ sec
250 μ sec
2000 sec

⇒ The V-i relation for a varistor is
i = kvⁿ
v = kiⁿ
i = kv³
v = ki³

⇒ The Ebers-moll equation for I_E in CB configuration is given by
I_E = a_nI_CI_EC0
I_E = a_II_C + I_C0
I_E = a_nI_C + I_C0(e^qVEB/KT-1)
I_E = a_II_C + I_E0(e^qV_EB/KT - 1)

⇒

Assertion (A): In loss of charge method, it is preferable to use an electronic voltmeter.

Reason (R): The resistance of electronic voltmeter is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒ The ALU carrier out arithmetic and logic operations (OR AND, NOT, etc.) it processes
decimal numbers
binary numbers
hexadecimal numbers
octal numbers

⇒ The radiation resistance of a resonant long wire antenna of half wavelength (λ/2) is given
73 Ω
120 p
377 Ω
7.3 Ω