Question is ⇒ Modelling error may occur due to, Options are ⇒ (A) neglecting the nonlinear characteristics of plant, (B) inaccuracy of parameters, (C) change of plant characteristics with time, (D) any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Modelling error may occur due to, Options are ⇒ (A) neglecting the nonlinear characteristics of plant, (B) inaccuracy of parameters, (C) change of plant characteristics with time, (D) any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Modelling error may occur due to
A.	neglecting the nonlinear characteristics of plant [Wrong Answer]
B.	inaccuracy of parameters [Wrong Answer]
C.	change of plant characteristics with time [Wrong Answer]
D.	any of the above [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires
8 half adders and 4 OR gates
8 half adders and 3 OR gates
7 half adders and 3 OR gates
7 half adders and 4 OR gates

⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ Which of the following 8085 instructions do not effect CY flag?
SEE M
SEE R
DCRM
ADC M

⇒ __________ will have the least value of relative permeability.
Palladium
Silver
Cobalt
Iron

⇒ The directive gain of a transmitting antenna is
proportional to wavelength
inversely proportional to wavelength
proportional to square of wavelength
inversely proportional to square of wavelength

⇒ Which of the following statement about TRIAC is incorrect?
It is not particularly suited to A.C. or mains power control
Any one of its main terminals can be used either as cathode or as anode
It can be triggered in response to both positive and negative gate terminals
None of the above

⇒ The slope of log magnitude curve changes by - 40 dB/decade at a certain frequency and the error between asymptote and actual curve is positive. This means that
a double pole is present
a pair of complex conjugate poles is present
either (a) or (b)
neither (a) nor (b)

⇒ A rectangular metal waveguide filled with a dielectric of relative permittivity ε_r = 4, has the inside dimensions 3 x 1.2 cm, the cut off frequency for the dominant mode is
2.5 GHz
5 GHz
10 GHz
12.5 GHz

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil
12 MHz
24 MHz
3 MHz
1.5 MHz

⇒ The number of valence electrons in silicon atom is
4
2
1
zero

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ FIR digital filter having __________ stability than FIR filter.
good stability
poor stability
stability not guarnteed
poor stability

⇒

Assertion (A): For high frequency lines inductive reactance is very high as compared to ac resistance.

Reason (R): Due to skin effect ac resistance of line is higher than dc resistance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In microwave communication links the fading due to rain occurs. The methods to solve this problem include
antenna replacement and feed correction
amplitude trimming and phase correction
polarization shifting and code diversity
path diversity and frequency diversity

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ A MASER is a
low noise device
high noise device
medium noise device
may be either high or medium noise device

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ Which of the following represents the equivalent circuit of a crystal for crystal oscilla
Figure A
Figure B
Figure C
None of the above

⇒ The Ebers-moll equation for I_E in CB configuration is given by
I_E = a_nI_CI_EC0
I_E = a_II_C + I_C0
I_E = a_nI_C + I_C0(e^qVEB/KT-1)
I_E = a_II_C + I_E0(e^qV_EB/KT - 1)

⇒ For a stable system having two or more gain crossover frequencies the phase margin is measured at the highest crossover frequency.
TRUE
FALSE

⇒ The oscillator frequency is set for
best picture
max. sound
min. sound
sound in picture

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ A semiconductor Read-only-Memory basically is
a combinational logic circuit
a set of flip-flop memory elements
a sequential circuit with flip-flops and gates
none of the above

⇒ A rectangular waveguide having TE₁₀ mode as dominant mode is having a cut off frequency of 18 GHz for the TE₃₀ mode. The inner broad wall dimension of the rectangular waveguide is
5/3 cm
5 cm
5/2 cm
10 cm

⇒ If 137 + 276 = 435 how much is 731 + 672?
534
1403
1623
1513

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16