Question is ⇒ Which of the following is not a conducting material?, Options are ⇒ (A) Copper, (B) Tungsten, (C) Germanium, (D) Platinum, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is not a conducting material?, Options are ⇒ (A) Copper, (B) Tungsten, (C) Germanium, (D) Platinum, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is not a conducting material?
A.	Copper [Wrong Answer]
B.	Tungsten [Wrong Answer]
C.	Germanium [Correct Answer]
D.	Platinum [Wrong Answer]
View Answer 3 -5 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The characteristic equation of flip-flop gives the next state Q_{N + 1} in terms of present state Q_N and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?
Q_N+1 = JQ_N + KQ_N
Q_N+1 = J + KQ_N
Q_N+1 = KQ_N + JQ_N
Q_N+1 = K + JQ_N

⇒ In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 Ω. The value of ΔR will be
2 Ω
3 Ω
4 Ω
1 Ω

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒ Sound waves are electromagnetic waves.
TRUE
FALSE

⇒ In figure if C is replaced by short circuit then R_B wil
425 K
412 K
474 K
400 K

⇒ In a 741 OP-amp, there is 20 dB/decade fall-off starting at a relatively low frequency. This is due to
applied load
internal compensation
impedance of the source
power dissipation in the chip

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒ Hystresis loss least depends on
frequency
magnetic field intensity
volume of the material
grain orientation of material

⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒

Assertion (A): In a magnitude comparator IC the cascading inputs provide a means to cascade the 4 bit comparators

Reason (R): A magnitude comparator has three outputs, A = B, A > B and A < B

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A pulse stretcher is same as a
free running multivibrator
bistable multivibrator
monostable multivibrator
latch

⇒ VSB modulation is preferred in TV because
it reduces the bandwidth requirement to half
it avoids phase distortion at low frequencies
it results in better reception
none of the above

⇒ A step up chopper can give an output voltage
higher than input voltage
lower than input voltage
both higher and lower input voltage
all of the above

⇒ A unipole is also known as
omnidirectional radiator
unidirectional radiator
line radiator
none of the above

⇒ For signal diodes the PIV rating is usually in the range
1 V to 10V
10 V to 30V
30 V to 150V
150 V to 400V

⇒ A circuit has two branches 1 and 2 in parallel. If |Q₁| = 8 KVAR and |Q₂| = 6 KVAR, the magnitude of total kvar drawn form supply will be
14 KVAR
2 KVAR
zero
14 or 2 KVAR

⇒ In a computer the data transfer between hard disk and CPU is nearly the same as that between diskette and CPU.
TRUE
FALSE

⇒ An air gap provided in the iron core of an inductor prevents
flux leakage
hysteresis loss
core saturation
heat generation

⇒ Tropospheric scatter is used with frequencies in the
HF
VHF
UHF
VLF

⇒ To produce magnetic flux, mmf is necessary.
TRUE
FALSE

⇒ It is required to measure the true open circuit emf of a battery. The best device is
dc voltmeter
ammeter and known resistance
dc potentiometer
either (a) or (c)

⇒ The number of bits in a nibble is
8
4
2
16

⇒ When a current flows through a coil of insulated wire, the coil shows the properties of a magnet.
TRUE
FALSE

⇒ The Clapp oscillator shown in figure will operat
4.6 kHz
46 kHz
460 kHz
4600 kHz

⇒ The contents of stack location 2109 H after the call operation wil
1111
1010101
100000
100010

⇒ A power factor meter has
one current and one pressure circuit
one current circuit and two pressure circuits
two current circuits and two pressure circuits
two current circuits and one pressure circuit

⇒ Gray code is used in devices which convert analog quantities to digital signal because it is
more error free
much simpler than binary code
superior to Excess-3 code
absolutely error free

⇒ In 8086 the number of bytes which can be addressed directly is about
1000
10000
100000
one million