Question is ⇒ A 2 bit binary multiplier can be implemented using, Options are ⇒ (A) 2 inputs ANDs only, (B) 2 inputs XORs and 4 input AND gates only, (C) Two 2 inputs NORs and one XNOR gate, (D) XOR gates and shift registers, (E) , Leave your comments or Download question paper.

Question is ⇒ A 2 bit binary multiplier can be implemented using, Options are ⇒ (A) 2 inputs ANDs only, (B) 2 inputs XORs and 4 input AND gates only, (C) Two 2 inputs NORs and one XNOR gate, (D) XOR gates and shift registers, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 2 bit binary multiplier can be implemented using
A.	2 inputs ANDs only [Wrong Answer]
B.	2 inputs XORs and 4 input AND gates only [Wrong Answer]
C.	Two 2 inputs NORs and one XNOR gate [Correct Answer]
D.	XOR gates and shift registers [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒ For dielectrics in alternating field, polarizability a_e is a complex quantity. The imaginary part of a_e is zero for
ω = 0
ω → ∞
ω = 0 and ω → ∞
ω = natural frequency ω₀

⇒ In figure the trace on the CRO wil
half rectifier wave
clamped wave
no trace at all
either (a) or (b)

⇒ Consider the following stateme
1, 2 and 3
1 and 2 only
2, 3 and 4
2, 3 and 4

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ The emitter follower is widely used in electronic instrument because
its voltage gain is less than unity
its voltage gain is very high
its O/P Impedance is low and input impedance is high
its O/P Impedance is high and I/P impedance is low

⇒ In 8085 microprocessor system, what will be the total delay provided by the following loop.3.154 msec
3.514 msec
2.644 msec
3.166 msec

⇒ (FE35)₁₆ XOR (CB15)₁₆ is equal to
(3320)₁₆
(FE35)₁₆
(FF50)₁₆
(3520)_l6

⇒ The total power radiated from an antenna system is determined by imagining that the antenna is at the centre of a very large
sphere
rectangle
square
ellipse

⇒ Two coils having self inductances of 10 mH and 40 mH are mutually coupled. The maximum possible mutual inductance is
40 mH
20 mH
10 mH
5 mH

⇒ The smallest change in sound intensity that can be detected by human ear is __________ dB.
1
3
10
20

⇒ The word enhancement mode is associated with
tunnel diode
MOSFET
JFET
photo diode

⇒ The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300 K will be (in m²/s)
0.4
0.16
0.04
0.01

⇒ A super heterodyne receiver has an input circuit tuned to a 570 KHz signal. If the intermediate frequency of the amplifier is tuned to 455 KHz. The quality factor Q for a Image Rejection ratio of 125?
100
56.81
42.74
87

⇒ The colour code on a carbon resistor is yellow-violet-orange. The value of resistance is
17000 Ω
27000 Ω
37000 Ω
47000 Ω

⇒ The order of the differential equa
1
2
3
4

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase-shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ Fourier transform is defined for
periodic
non-periodic
finite duration
all

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease

Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒ In a mod-12 counter the input clock frequency is 10 kHz. The output frequency is
0.833 kHz
1.0 kHz
0.91 kHz
0.77 kHz

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ The self inductances of two coils are 27 H and 3 H. If the winding or coils is such that 50% of flux of one links the other, the mutual inductance is
30 H
24 H
9 H
4.5 H

⇒ In figure, the value of R shoul
0.2 Ω
0.1 Ω
0.05 Ω
0.1 Ω

⇒ If the changes in zener current in a voltage regulator circuit are too large, it can be corrected by using a
emitter follower
CE amplifier
capacitor
either (a) or (b)

⇒ Which one of the following statement is correct?
Both Laplace's (L) and Poisson's (P) equation are non linear
L is non linear but P is linear
L is linear but P is non linear
L, P both is linear

⇒ The radiation resistance of a doublet antenna of length dl is proportional to
δ l
(δ l)²
(δ l)³
(δ l)⁰⁵

⇒ Thermistors are made of
pure metals
pure insulators
tintered mixture of metallic oxides
pure semiconductors

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒ Volt is equivalent to
joule/coulomb
joule/watt
joule/ampere
joule/volt

⇒ The effective length of an 1/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.34λ² and η = 120p) is __________ .
0.6348 λ
0.5133 λ
0.1587 λ
0.3714 λ