Question is ⇒ Which of the following does not use the principle of change in inductance?, Options are ⇒ (A) LVDT, (B) Inductance displacement transducer, (C) Strain gauge, (D) Reluctance pick up, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following does not use the principle of change in inductance?, Options are ⇒ (A) LVDT, (B) Inductance displacement transducer, (C) Strain gauge, (D) Reluctance pick up, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following does not use the principle of change in inductance?
A.	LVDT [Wrong Answer]
B.	Inductance displacement transducer [Wrong Answer]
C.	Strain gauge [Correct Answer]
D.	Reluctance pick up [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As compared to MOS memories, bipolar memories have
slower access time but are cheaper
slower access time and are costly
faster access time and are cheaper
faster access time and are costly

⇒ When negative feedback is used the fractional changes in closed loop gain are desensitized by the factor (1 + A_vβ)
TRUE
FALSE

⇒ If initial value of PROD is zero and a program adds X to PROD, Y times we get the result
X + Y
XY
X / Y
X - Y

⇒ In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be
0.0125 μF
0.0311 μF
0.0521 μF
0.0622 μF

⇒

Match the following:

	List I (Laws of Boolean)		List II (Relation algebra)
A.	Distributive law	1.	x + x = x
B.	DeMorgans law	2.	x(y + z) = xy + xz
C.	Idempotent law	3.	(x) = x
D.	Involution law	4.	(x + y) = xy

A-1, B-2, C-3, D-4
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-4, B-1, C-2, D-3

⇒ The surface charge density on a conductor is 1.55 x 10^-9C/m². The conductor is immersed in water with ε = 78ε₀.The electric field will be __________ .
3 V/m
1.55 V/m
2 V/m
2.25 V/m

⇒ Which of the following statement about the amplitude limiter is not valid?
Leak type bias must be used
Output must be tuned
The circuit is always biased in class C, by virtue of the leak type bias
When the input increases past the threshold of limiting, the gain decreases to keep the output constant

⇒ Which of the following 8085 instructions does not belong to arithmetic group?
SHLD addr
SUI data
ADCM
INR r

⇒ Which of the following amplifiers has highest output impedance?
CE
CB
CC
Push pull

⇒ Radar antennas are usually
dipoles
yagi antennas
parabolic dishes
none of the above

⇒ When diodes are connected in series to increase voltage rating the peak inverse voltage per junction
should not exceed half the breakdown voltage
should not exceed the breakdown voltage
should not exceed one third the breakdown voltage
may be equal to or less than breakdown voltage

⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000

⇒ In the given circuit, the switch is open for a long time. At time t = 0, the switch is closed. What are the initial and final values of voltages across the induc
0 V and 0 V
0 V and 80 V
80 V and 0 V
80 V and 80 V

⇒ A single phase energy meter operates on induction principle.
TRUE
FALSE

⇒ In photoelectric emission the maximum kinetic energy of emitted electron is proportional to
f
f
f²
f³

⇒ In monostable multivibrator
has no stable state
has one stable state
has two stable states
switches automatically from one state to other state

⇒ The polar plot of transport lag is a unit circle.
TRUE
FALSE

⇒ A non-inverting voltage feedback amplifier is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter

⇒ In the given figure 15.6 shows a series, R - C circuit fed by a current source i(t). There is an initial voltage v₀. across the capacitor. The sy
is linear
is non linear
may be linear or non linear
is linear only if v₀ is zero

⇒ In a JFET, the drain current is maximum when
V_GS = V_DS
V_GS = pinch off voltage
V_GS = 0
V_GS is negative

⇒ If transfer function of a system is H(z) = 6 + z^-1 + z^-2 then system is
minimun phase
maximum phase
mixed phase
none

⇒ Which one of the following blocks is not common in both AM and FM receivers?
RF amplifier
Mixer
IF amplifier
Slope detector

⇒ The selectivity of a radio receiver is
its ability to reject adjacent unwanted signals
its ability to amplify weak signals
the frequency at which it gives maximum amplification to signal.
its ability to suppress noise.

⇒ At t = ∞; V_R2 and V_C wil
4, 4
2, 4
0, 2
2, 0

⇒ MOS circuits as compared to bipolar circuits take
more chip area
less chip area
same chip area
none of these

⇒ For the truth table of the given figure
A + B + C
A + BC
A
B

⇒ Calculate the electrostatic force of repulsion between two mica particles at a distance of 10^-13 m from each other. Charge on a particle is 3.2 x 10^-19 C. (relative permittivity for mica is 5)
1.843 x 10^-15 N
9.2 x 10^-2 N
14.41 x 10^-9 N
none of these

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ The stray capacitance between the last stage and the first stage of an oscillator may cause
unwanted low frequency oscillations
unwanted high frequency oscillations
unwanted oscillations at low and high frequencies
large feedback

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C