Question is ⇒ The emitter bias largely depends on, Options are ⇒ (A) gain, (B) signal input, (C) I<sub>E</sub>, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The emitter bias largely depends on, Options are ⇒ (A) gain, (B) signal input, (C) I<sub>E</sub>, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The emitter bias largely depends on
A.	gain [Wrong Answer]
B.	signal input [Wrong Answer]
C.	I_E [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Thyristors connected in series need :
static equalizing circuit
dynamic equalizing circuit
both static and dynamic equalizing circuits
none of the above

⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative

⇒

Assertion (A): The turn on time of SCR is about 1 to 4 ms.

Reason (R): The turn off time of SCR is about 10 to 300 ms.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The equivalent T circuit of this coupled network is shown in figure. Find the values of Z_A, Z_B and Z_{C-j, 6j, 2j
-j, 2j, 6j
j, 2j, - 6j
j, 2j, 6j}

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒

Match the following:

	List I (type of controller)		List II (Operation)
A.	Pneumatic controller	1.	Flexible operation
B.	Hydraulic controller	2.	High torque high speed operation
C.	Electronic controller	3.	Fire and explosion proof operation

A-1, B-3, C-2
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is
in the off-state
in the ON state
reverse biased
at the point of breakdown

⇒ In which of the following logical group instructions of 8085 do the contents of accumulator remain unchanged?
ORA r
ORA M
ORI data
CMP r

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?
Half wave rectifier
Full wave rectifier
Bridge type full wave rectifier
Three phase full wave rectifier

⇒ The pre-emphasis in FM aids in providing extra noise immunity by
emphasizing only the higher frequency components
emphasizing the entire frequency band
emphasizing only the lower frequency band
cutting down the low frequency noise

⇒ The logic performed by the high-noise immunity logic circuit shown belo
OR
AND
NOR
NAND

⇒ Above ferroelectric curie temperature, spontaneous polarization in ferroelectric materials becomes stronger.
TRUE
FALSE

⇒ In integral cycle control of ac regulators, the period of integral cycle control, i.e., (m + n) T should be
less than mechanical or thermal time constant of the system
more than the mechanical or thermal time constant of the system
more or less than the mechanical or thermal time constant
very high

⇒ The device having highest photo sensitivity is
photoconductive cell
photovoltaic cell
photodiode
phototransistor

⇒ In household energy meters the flux of series magnet is in phase with current but the flux of shunt magnet lags the voltage by 88°. The reading of energy meters
will be correct
will have a negative error
will have a positive error
may have positive or negative error

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T²I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	M^-1L^-2T⁴I²
D.	Reluctance	4.	ML²T^-3I^-2

A-1, B-2, C-3, D-4
A-2, B-1, C-3, D-4
A-4, B-2, C-3, D-1
A-2, B-4, C-3, D-1

⇒ If the minimum range of a radar is to be doubled, the peak power has to be increased by a factor of
2
4
8
16

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ A 2 bit binary multiplier can be implemented using
2 inputs ANDs only
2 I/P XOR and 4 I/P AND gate only
two 2 inputs NORs and One XNOR gate
XOR gates and shift registers

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ A single phase half wave rectifier is feeding a resistive load. When a = 0, dc output voltage is 127 V. When a = 30°, the dc output voltage will be about
127 V
120 V
110 V
100 V

⇒ To realize following function 'f'
3
6
4
10

⇒ The system in the given figure,
good gain and phase margin
poor gain and phase margin
good gain margin but poor phase margin
poor gain margin but good phase margin

⇒ Two resistances of 2 Ω each are connected in series. A shunt having zero resistance is connected across the combination. The overall resistance will be
4 Ω
1 Ω
0.5 Ω
zero

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?
Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease
Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒ Which of the following circuits come under the class of sequential logic circuits?
Full adder
Full subtractor
Half adder
J-K flip-flop
Counter
Select the correct answer from the codes given below:
1 and 2
1, 2 and 3
3 and 4
4 and 5

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ The series element in band pass filter is
capacitive
inductive
parallel combination of inductance and capacitance
series combination of inductance and capacitance

⇒ In the output of a DM speech encoder, the consecutive pulses are of opposite polarity during time interval t₁ < t < t₂. This indicates that during this interval
the input to the modulator is essentially constant
the modulator is going through slope overload
the accumulator is in saturation
the speech signal is being sampled at the Nyquist rate

⇒ The characteristics of a non-linear resistance is i = kv⁴. If i becomes 100 times, v becomes
about 100 times
about 10 times
about 3 times
about twice

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math