Question is ⇒ Kell factor is about, Options are ⇒ (A) 5, (B) 3, (C) 0.7, (D) 0.2, (E) , Leave your comments or Download question paper.

Question is ⇒ Kell factor is about, Options are ⇒ (A) 5, (B) 3, (C) 0.7, (D) 0.2, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Kell factor is about
A.	5 [Wrong Answer]
B.	3 [Wrong Answer]
C.	0.7 [Correct Answer]
D.	0.2 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Two port circuits are connected in parallel. To determine the response, it is more convenient to use
O.C. impedance parameters
S.C. admittance parameters
ABCD parameters
h parameters

⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
0.004 Ω
0.005 Ω
0.05 Ω
0.1 Ω

⇒ For attenuation of high frequencies we should use
shunt capacitance
series capacitance
inductance
resistance

⇒ The assigned carrier frequency of an FM broadcast station is 96.3 MHz. Its FM signal has a centre frequency of
10 MHz
455 kHz
48.15 MHz
96.3 MHz

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. In receivers operating upto the limit of shortwave broadcasting the local oscillator often used is
Armstrong oscillator
Colpitts oscillator
Clapp oscillator
Ultra Audio oscillator

⇒ If x₁(t) = 2 sin pt + cos 4 pt and x₂(t) = sin 5 pt + 3 sin 13 pt then
x₁, x₂ both periodic
x₁ x₂ both not periodic
x₁ periodic, x₂ not periodic
x₁ is not periodic ; but x₂ is periodic

⇒ A loop antenna may be of
square on triangular shape
hexagonal shape
circular shape
any of the above

⇒ If figure, I = 2A if R = 20 Ω. When R = 10 Ω current I
0.0416666666666667
0.0833333333333333
2.5 A
0.125

⇒ Two port Z parameter not exist for the circuit if
Δz = 0
Δz
Δz = 1
always exist

⇒ Tesla is a unit of
flux
field strength
flux density
MMF

⇒ In radio receiver, the maximum contribution to noise is from
mixer stage
power supply
power amplifier
equally from above three

⇒ Wheatstone bridge is suitable for low resistances.
TRUE
FALSE

⇒ In a backward wave oscillator the efficiency
is much higher than in TWT
is much lower than in TWT
is almost the same as in TWT
either (a) or (b)

⇒ Two coils having self inductances of 10 mH and 40 mH are mutually coupled. The maximum possible mutual inductance is
40 mH
20 mH
10 mH
5 mH

⇒ A class B chopper operates in third quadrant.
TRUE
FALSE

⇒ Zener breakdown occurs
due to rapture of covalent band
mostly in germanium junctions
in lightly doped junctions
due to thermally generated minority carriers

⇒ The capacitor filter provides poor voltage regulation because
the increase in ripple with load current causes a decrease in average voltage
the increase in ripple with load current causes a increase in average voltage
filter promotes ripple at peak voltage
none of the above

⇒ Assuming a minimum angle of elevation of 5°, a geosynchronous satellite remains in line-of-sight for __________ percentage of Earth's surface.
30.3
42.4
50
25

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒ In which of the transformer is the secondary nearly short circuited under normal operating conditions?
CT
PT
Distribution transformer
Power transformer

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ The circuit diagram shown in the figure consists of transistors
parallel connection
cascade connection
darlington connection
series connection

⇒ For a BJT, under the saturation condition,
I_C = βI_B
I_C = aI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ In a resistance loaded, RC coupled amplifier the d.c. component is blocked by
Transistor
C_C
R_B
R_C

⇒ Free electrons exist in
first band
second band
third band
conduction band

⇒ For the differential equation (D³ - D² + D -1) [y(t)] = 0 the root of auxiliary equation
-j, j, 1
-j, j, 2
1, 2, j
1, 2, -j

⇒ Voltage V_L in the circuit when V_s < 0 where D is an ideal diode. (Take R₁ = R_s = R_L = 1 &o
0
1
1.5
cannot find

⇒ If number of information bits is 4, the parity bits in Hamming code are located at bit positions __________ from the LSB.
1, 2, 5
1, 2, 4
1, 2, 3
1, 2