Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | As compared to the number of network elements in Brune synthesis, the number of network elements Bott-and Duffin in realization is |

A. | more [Correct Answer] |

B. | less [Wrong Answer] |

C. | equal [Wrong Answer] |

D. | any of the above [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit

has low input impedance

has high input impedance

has very low input impedance

may have either low or high input impedance

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is

0.3 V

0.5 V

1 V

1.5 V

⇒ Specific resistance of silver is about

0.16 x 10

^{-8}Ω-m

1.64 x 10

^{-8}Ω-m

16 x 10

^{-8}Ω-m

164 x 10

^{-8}Ω-m

⇒ The output voltage of a charger is

less than battery voltage

same as battery voltage

more than battery voltage

same or more than battery voltage

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to

first Bohr radius

second Bohr radius

third Bohr radius

either first or second Bohr radius

⇒ The ionosphere plays a significant role in radio wave propagation at

high frequency

ultra-high frequencies

microwave frequency

optical frequencies

⇒ The capacitors C

_{1}, C

_{3}, C

_{4}and C

_{5}have a capacitance of 4 μF each and the capacitor C

_{2}has a capacitance of 10 μF. The effective capacitance (in μF) between the points X and Y will

4 μF

6 μF

3 μF

8 μF

⇒ Which junction transistor is preferred for high input and low output impedances?

Common emitter

Common base

Common collector

Any of the above

⇒ The orbital period of a geostationary communication satellite is

12 hours

24 hours

36 hours

48 hours

⇒ In a thyristors are

*i*=

*kv*. The value of

^{a}*a*is

about 0.5

about 2

about 5

about 20

⇒ A transmission line has a characteristic impedance of 50 Ω and a resistance of 0.1 Ω/m, if the line is distortion less, the attenuation constant (in Np/m) is

500

5

0.014

0.002

⇒ What is the propagation constant for air filled wave guide with dimensions

*a*= 1.59" and

*b*= 0.795" at 4.95 GHz. The wave impedance is

400.94 Ω

562.94 Ω

502.80 Ω

492.80 Ω

⇒ The contents of the program counter after the call operation point to the first instruction on

stack

subroutine

either of the above

none of the above

⇒ The colour on the extreme left in general purpose fixed resistors represents

first significant digit

tolerance

wattage rating

voltage rating

⇒ A network has only independent current sources and resistance. If values of all resistors are doubled, the values of node voltages

will become half

will remain unchanged

will become double

cannot be determined unless circuit configuration and values of resistors are known

⇒ For VLF antennas radiation resistance is usually of the order of

less than one ohm

13 to 20 ohms

around 100 ohms

more than 200 ohms

⇒ A transmission line having 50 Ω impedance is terminated in a load of (40 +

*j*30) Ω. The VSWR is

*j*0.033

0.8.+

*j*0.6

1

2

⇒ Lag compensation permits a high gain at low frequencies.

TRUE

FALSE

⇒ A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of load current is

40 A

20 A

0.416666666666667

0.208333333333333

⇒ If sound intensity is 8 W/m

^{2}, the dB level of this sound is about

5 dB

50 dB

129 dB

1290 dB

⇒ Consider the following program in C

0.2

0

3

⇒ In a capacitor filter, the time constant R

_{L}C should be small.

TRUE

FALSE

⇒ Consider the following statements, regarding an OP AMP:

- All types of negative feedback reduce non-linear distortion.
- All types of negative feedback reduce the output offset voltage.
- Non-inverting (current and voltage) feedback increases the input impedance.
- Inverting (current and voltage) feedback decreases input impedance.

1 only

2 and 3 only

2 and 4 only

1, 2, 3 and 4

⇒ Which of the following is used in automatic control of street lights?

Thermistor

Photoconductor

Transistor

Varistor

⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be

26 kHz

260 kHz

26 MHz

260 MHz

⇒ How many interrupts are there of 8085 μP?

4

5

6

8

⇒ In two level logic, logic race does not occur.

TRUE

FALSE

⇒ Three Mod-16 counters are connected in cascade. The maximum counting range is

16

256

4096

none of the above

⇒ In a minimum function

the degree of numerator and denominator are equal

the degree of numerator and denominator are unequal

the degree of numerator is one more than degree of denominator

the degree of numerator is one less than degree of denominator

⇒ In an

*n*type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be

0.35 eV below conduction band

about 0.32 eV below conduction band

about 0.32 eV above conduction band

about 0.1 eV below conduction band