Question is ⇒ Assertion (A): Synchronous counter has higher speed of operation than ripple counter Reason (R): Synchronous counter uses high speed flip flops., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Synchronous counter has higher speed of operation than ripple counter Reason (R): Synchronous counter uses high speed flip flops., Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Synchronous counter has higher speed of operation than ripple counter Reason (R): Synchronous counter uses high speed flip flops.
A.	Both A and R are correct and R is correct explanation of A [Wrong Answer]
B.	Both A and R are correct but R is not correct explanation of A [Wrong Answer]
C.	A is true, R is false [Correct Answer]
D.	A is false, R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n

⇒ In 8085, which instructions are useful for writing and using subroutines?
CALL
RET
CALL and RET
none of the above

⇒ In a positive edge triggered D flip flop
D input is called direct set
Preset is called direct reset
Present and clear are called direct set and reset respectively
D input overrides other inputs

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
1/C
(A - 1)/C
1/B
(D - 1)/C

⇒ The kinetic energy of free electrons in a metal is (where k is the de-Broglie wave number of the electron)
inversely proportional to k
inversely proportional to square of k
proportional to k
proportional to the square of k

⇒ In the circuit of figure the switch is closed at t = 0, At t = 0⁺ this current through inductanc
0
0.416666666666667
6.67 A
5.1 A

⇒

Assertion (A): Radio transmission is by sky waves

Reason (R): Waves having frequencies higher than 30 MHz penetrate the atmosphere and do not return to earth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ In a diode rectifier with a capacitance input filter, a surge current is likely to flow when the circuit is switched on. The cause of this surge current is
the non linear behaviour of diodes
the capacitor acts as a short circuit at the instant of switching,
the inductance of leads
both (a) and (b)

⇒ A conductor has a cylindrical shape with a diameter d. Its resistance is 2 Ω. It is recast into a cylindrical conductor of diameter 0.3d. The resistance of new conductor is likely to be
less than 2 Ω
less than 0.6 Ω
between 2 and 100 Ω
more than 100 Ω

⇒ Which of the following is known as insulated gate FET?
JFET
MOSFET
Both JFET and MOSFET
None of the above

⇒ In a 4 bit ripple counter using flip flops with t_pd = 40 ns, the maximum frequency can be
1.25 MHz
3.25 MHz
6.25 MHz
12.5 MHz

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6

⇒ In VHS format each video head is tilted from azimuth by
20°
10°
6°
1°

⇒ In common base amplifier the current gain is less than one, but the voltage gain may be anywhere from
0.5 to 1
1 to 5
5 to 10
50 to 2000

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ An antenna array pattern is to used for increasing
gain
directivity
directive gain
all

⇒ In figure, V_{0zero
5.7 V
6.9 V
12.6 V}

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒ In p mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to
one pole/cycle
two pole/cycle
four pole/cycle
six pole/cycle

⇒ In a cellular communication system, path loss between transmitter and receiver is due to
scattering from building, trees, vehicles and other structure
reason at (a) above and due to reflections from ground only
reason at (a) and (b) above along with reflections from ionosphere only
reasons at (a), (b) and (c) above along with loss due to surface wave phenomenon

⇒ Transistor are free from which type of noise?
Resistance noise
Partition noise
Flicker noise
Shot noise

⇒ In all pure metals, temperature coefficient of resistance is positive.
TRUE
FALSE

⇒ Read the following statements: Dual slope ADC provides

higher speed as compared to other ADC
very good accuracy
good rejection of power supply
better resolutions compared to other ADC for the same number of bits

Which of the above are correct?
1 and 2
2 and 3
1, 2, 3
1, 2, 3, 4

⇒ Which of these has a layer of intrinsic semiconductor?
Zener diode
PIN diode
Photo diode
Schottky diode