Question is ⇒ Which is a valid Java variable?, Options are ⇒ (A) 1 a b, (B) 56 a , (C) a 56, (D) 5 a 6, (E) , Leave your comments or Download question paper.

Question is ⇒ Which is a valid Java variable?, Options are ⇒ (A) 1 a b, (B) 56 a , (C) a 56, (D) 5 a 6, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which is a valid Java variable?
A.	1 a b [Wrong Answer]
B.	56 a [Wrong Answer]
C.	a 56 [Correct Answer]
D.	5 a 6 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In which of the following devices can the operation be visualised in terms of a series feedback loops?
TWT
Reflex klystron
Klystron amplifier
Backward wave oscillator

⇒ The scale of PMMC instrument is linear.
TRUE
FALSE

⇒ A typical microcomputer has 65, 536 registers in its memory. It will be specified as
65.536 memory
65.536 K memory
64 K memory
8 K memory

⇒ For underdamped second order systems the rise time is the time required for the response to rise from
0% to 100% of its final value
10% to 90% of its final value
5% to 95% of its final value
either (a) or (b)

⇒ In a CE transistor amplifier, when collector-emitter voltage increases
the instantaneous operating point moves up the load line
the instantaneous operating point moves down the line
load current increases
none of the above

⇒

Assertion (A): The angular momentum of an atom is due to three contributions viz. orbital, electron spin and nuclear spin.

Reason (R): The nuclear spin magnetic moment is much more than electron spin magnetic moment.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The standard FORTRAN exponential form of decimal number 0.0000437 is
4.37 E - 5
4.37 E - 4
43.7 E - 5
43.7 E - 4

⇒ The conversion or collector circuit efficiency is a measure
how successfully the active device converts D.C. power to A.C. signal power
how much distortion in output is reduced with respect to input
how successfully the active device converts A.C. power to D.C. signal power
none of the above

⇒ A generator is feeding power to a transmission line of characteristic impedance Z₀. The line is terminated in impedance Z_L. Standing waves will be set up if
Z_L = Z₀
Z_L < Z₀
Z_L > Z₀
both (b) and (c)

⇒ The principal of locality of reference justifies the use of
interrupts
DMA
virtual memory
cache memory

⇒ A three stage telephone switching structure is to have 128 input and 128 output terminals. It has been found that at peak time the utilization probability is 0.1. The number of intermediate links required for non-blocking configuration is 15. If the actual number of intermediate links is 5, the probability of blocking of call is
0.01
0.005
0.002
0.001

⇒ A λ/4 long high frequency transmission line is terminated into one impedance Z_R. If Z₀ be the characteristic impedance of the line, then input impedance Z_in is
Z_oZ_R
Z²_R/Z_o
Z²₀/Z_R
Infinity

⇒ Which converters uses integrating op-amp?
Parallel A/D converter
Single slope A/D converter
Dual slope A/D converter
Both (b) and (c)

⇒ A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is
6 mV
12 mV
24 mV
3 mV

⇒ The percentage saving in power when the carrier and one of the sidebands are suppressed in an AM wave modulated to a depth of 100% will be nearly
0.5
0.66
0.75
0.83

⇒

Assertion (A): In Fortran 77 the statement IMPLICIT INTEGER (A - E) identifies all variable name which begin with A, B, C, D, or E as being of integer type.

Reason (R): IMPICIT statement in Fortran 77 is an improvement over earlier versions of Fortran.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ A photo diode is
forward biased
reverse biased
either forward or reverse biased
unbiased

⇒ What are the contents of the accumulator after the RIC has been executed?
40 H
41 H
42 H
43 D

⇒ Calculate the stability factor and change in I_C from 25°C to 100°C for, β = 50, R_B/ R_E = 250, ΔI_C0 = 19.9 nA for emitter bias configuration.
42.53, 0.85 μA
40.91, 0.58 μA
40.91, 0.58 μA
41.10, 0.39 μA

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ In figure V_CEQ for each transisto
V_CC
0.5 V_CC
0.75 V_CC
0.25 V_CC

⇒ The oscillator shown in figure
Colpitt's oscillator
Hartley oscillator
Tuned emitter oscillator
Clapp oscillator

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13

⇒ Frequency shifting keying is basically a method involving
amplitude modulation
frequency modulation
phase modulation
none of the above

⇒ Power factor of the following circuit will be unity
inductance
capacitance
resistance
both (a) and (b)

⇒ In setting up 'for' loops in Pascal, the initial and final values of index may be
integer constants
Integer constants or integer variable names
integer constants or integer variable names or integer expressions
integer constants or real constants

⇒ The Boolean expression B⊕E is a simplified version of expression ABE + BCDE+ BC D E + A B D E + B C D E + A B D E then which of the following choice is correct?

don't care conditions doesn't exist
don't care conditions exist
d( 16, 18, 20, 23, 27, 29) is the set of don't care conditions
d( 16, 20, 22, 27, 29) is the set of don't care conditions

1 only
2 and 3 only
2 and 4 only
data insufficient

⇒ The Boolean expression Y = (A + B + AB) C then Y will be equal to
AC
BC
C
none