Question is ⇒ In following figure, what will be R1 and R2 for maximum symmetrical swing if VCSat ≈ 0. Given that RE = 200 Ω, RC = 400 Ω, VCC = 20 V, β, Options are ⇒ (A) 6 k, (B) 3 k, 6 k, (C) 9.9 k, 2.4 k, (D) 2.4 k, 9.9 k, (E) , Leave your comments or Download question paper.

Question is ⇒ In following figure, what will be R1 and R2 for maximum symmetrical swing if VCSat ≈ 0. Given that RE = 200 Ω, RC = 400 Ω, VCC = 20 V, β, Options are ⇒ (A) 6 k, (B) 3 k, 6 k, (C) 9.9 k, 2.4 k, (D) 2.4 k, 9.9 k, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In following figure, what will be R₁ and R₂ for maximum symmetrical swing if V_CSat ≈ 0. Given that R_E = 200 Ω, R_C = 400 Ω, V_CC = 20 V, β
A.	6 k [Wrong Answer]
B.	3 k, 6 k [Wrong Answer]
C.	9.9 k, 2.4 k [Wrong Answer]
D.	2.4 k, 9.9 k [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In LED the radiation is in
visible region
infrared region
both (a) and (b)
neither (a) nor (b)

⇒ For a transistor amplifier with self biasing network, the following components are used. R₁ = 4 kΩ, R₂ = 4 kΩ, R_C = 1 kΩ. The approximate value of the stability factor 'S' will be
4
3
2
1.5

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒ The switching expression corresponding
C D + B C
C ⊙ D
C ⊕ D
CD

⇒ Quality factor will be
a/b
b/a
b/a
ab

⇒ Thyristors connected in series need :
static equalizing circuit
dynamic equalizing circuit
both static and dynamic equalizing circuits
none of the above

⇒ When time constant T in any factor is varied, the shapes of log magnitude and phase angle curves remain the same.
TRUE
FALSE

⇒ ECL has high switching speed because the transistors are
switching between cutoff and saturation regions
switching between cutoff and active regions
switching between active and saturation regions
none of the above

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ Which junction has least junction capacitance?
Alloy
Grown
Diffused
Point contact

⇒ Piezoelectric materials serves as a source of
microwaves
ultrasonic waves
musical waves
resonant waves

⇒ A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make
1200 revolutions
1800 revolutions
2100 revolutions
2400 revolutions

⇒ An ideal op-amp requires
zero input offset voltage
low input offset voltage
high input offset voltage
infinite input offset voltage

⇒ IC counters are
synchronous only
asynchronous only
both synchronous and asynchronous
none of the above

⇒ Which of the following statement is incorrect?
Z₀ is an ac characteristic that is the same for any length of time
The characteristic impedance can be measured approximately with a sensitive ohm meter
A line terminated in its Z₀ is a flat or non-resonant line
A twin lead has higher Z₀ but lower losses than coaxial cable

⇒ In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .
low, low
high, high
low, high
high, low

⇒ Alternating current can induce voltage because it has magnetic field which is
constant
time varying
stronger field than D.C.
closed loop nature.

⇒ The electrochemical equivalent of a material
depends on its valency
depends on its atomic weight
depends on its valency and atomic weight
depends on the degree of hardness of the material

⇒ If Z is the number of zeros of 1 + G(s) H(s) in the right half s plane. N is the number of clockwise encircle elements of (-1 + jo) point. P is the number of poles of G(s) H(s) in right half s plane. The Nyquist stability criterion can be expressed as
Z = N + P
Z = P/N
Z = N - P
Z = PN

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒

Match the following:

	List I		List II
A.	IF noise	1.	Ganged tuning
B.	Image frequency	2.	Spurious response
C.	Station selector	3.	Leaky filter capacitor
D.	Excessive Hum	4.	Mixer stage

A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3

⇒ An AM signal and a narrowband FM signal with identical carriers, modulating signals and modulation index of 0.1 are added together. The resultant signal can be closely approximated by
Broadband FM
SSB with carrier
DSB-SC
SSB without carrier

⇒ For measurement of high voltage capacitors the suitable bridge is
Wien bridge
modified De Sauty bridge
Schering bridge
either (a) or (b)

⇒ An ammeter is
secondary instrument
absolute instrument
recording instrument
integrating instrument

⇒ NAND and NOR gates are universal gates.
TRUE
FALSE

⇒ The series element of a band stop filter is
capacitive
inductive
parallel combination of L and C
series combination of L and C

⇒ A line is excited by a 100 V, 200 ohm source and is terminated by 100 Ω resistance. If the voltage on line reaches steady value in 80 ns, the natural resonant frequency is
100 MHz
50 MHz
12.5 MHz
6.25 MHz

⇒ A system has 12 poles or 2 zeros. Its high frequency asymptote in its magnitude plot has slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ The peak factor is the ratio of
peak and rms values
peak and average values
rms and average values
none of the above

⇒ Which of the following is used in lightning arresters?
Thermistor
Photoconductor
Transistor
Varistor