Question is ⇒ Magnetic effect of current is used in generators but not in motors., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ Magnetic effect of current is used in generators but not in motors., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Magnetic effect of current is used in generators but not in motors.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As the firing of a thyristor is delayed, the output voltage of a controlled rectifier decreases.
TRUE
FALSE

⇒ In which of the following is the width of junction barrier very small?
Tunnel diode
Photo diode
PIN diode
Schottky diode

⇒

Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The number of spectral component of impulse wave is
1
0
2
∞

⇒ A constant k low pass T section filter has a characteristic impedance of 600 p at zero frequency. At f = f_c the characteristic impedance is
600 Ω
zero
infinite
more than 600 ohms

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch

⇒ The FM broadcast band is from
550 to 1600 kHz
88 to 108 kHz
88 to 108 MHz
1600 kHz to 59.75 MHz

⇒ Examine the following statements

Air and gases are compressible.
Air, gases and some liquids are compressible.
Oil can function as hydraulic fluid as well as lubricator.

Which of the above statements are correct?
3 only
2 and 3 only
1 and 3 only
2 only

⇒ A TEM wave incident obliquely on a dielectric boundary with ε_r1 = 2 and ε_r2 = 1, the angle of incidence for total reflection is
30°
60°
45°
90°

⇒ The complement of exclusive OR function is
AB + A B
AB + A B
A B + A
AB + A B

⇒ An SCR is triggered at 40° in the positive half cycle only. The average anode current is 50 A. If the firing angle is changed to 80°, the average anode current is likely to be
50 A
25 A
less than 50 A but more than 25 A
less than 25 A

⇒ The attenuation factor in parallel plane guides is given by
a = power lost/power transmitted
a = 2 x power lost/power transmitted
a = power lost per unit length/2 x power transmitted
a is always constant

⇒ In the diode circuit shown in figure the diodes are ideal. The impedance seen by source is
1 k ohm
2 k ohm
0.5 k ohm
infinite

⇒ In 8085, Whenever a signal is received at TRAP terminal its program execution is transferred to a subroutine on address __________ .
0000 H
0024 H
002 CH
provided by the address generation logic

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ In 8085 stack pointer is
4 bit register
8 bit register
16 bit register
32 bit register

⇒ Pulse modulation is often used in
microwave band
FL band
telegraphy
telephony

⇒ For the system of the given figure the closed loop poles are locate
s = 0 and s = -2
s = 0, s = -l ± j3
s = -1 ± j3
s = -2 and s = -1 ± j3

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ The pole zero plot in the given figure is
non-minimum phase function
minimum phase function
all pass function
either (a) or (b)

⇒ Full duplex operation
requires modems at both ends of circuit
requires two pairs of cables
can transfer data in both directions simultaneously
all of the above

⇒ Power handling capacity of wire wound potentiometer used in control systems is about
0.1 W
5 W
25 W
100 W

⇒ Lower chip area requirements of MOS is advantage in
low power circuits
high power circuits
repetitive operation circuits
large scale integration

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of
30 Ω
10 Ω
9 Ω
zero

⇒ In a DM system, the granular noise occurs when modulating signal
decrease Rapidly
increase
has high frequency component
change within step size

⇒ Gold is often diffused into silicon PN junction devices to
increase the recombination rate
reduce the recombination rate
make silicon a direct gap semiconductor
make silicon semimetal

⇒ In a TWT the amplitude of resultant wave travelling down the helix
increases exponentially
increases linearly
decreases exponentially
is almost constant

⇒ In a receiver, at higher frequencies
tracking will be improved
tracking will be poor
selectivity will be poor
image frequency rejection will be poor

⇒ The ratio of the diffusion coefficient in a semiconductor has the units
V^-1
em.V^-1
V.cm^-1
V.s