Question is ⇒ The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is, Options are ⇒ (A) [0, - 2 + 2j, 2, - 2 - 2j], (B) [2, 2 + 2j, 6, 2 - 2j], (C) [6, 1 - 3j, 2, 1 + 3], (D) [6, - 1 + 3j, 0, - 1 - 3j], (E) , Leave your comments or Download question paper.

Question is ⇒ The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is, Options are ⇒ (A) [0, - 2 + 2j, 2, - 2 - 2j], (B) [2, 2 + 2j, 6, 2 - 2j], (C) [6, 1 - 3j, 2, 1 + 3], (D) [6, - 1 + 3j, 0, - 1 - 3j], (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is
A.	[0, - 2 + 2j, 2, - 2 - 2j] [Wrong Answer]
B.	[2, 2 + 2j, 6, 2 - 2j] [Wrong Answer]
C.	[6, 1 - 3j, 2, 1 + 3] [Wrong Answer]
D.	[6, - 1 + 3j, 0, - 1 - 3j] [Correct Answer]
View Answer 12 -12 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which mode is usually preferred for cascading?
CE
CB
CC
Any of the above

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ In FDM systems used for telephone, which modulation scheme is adopted?
AM
DSB-SC
SSB-SC
FM

⇒ Silicon is not suitable for fabrication of light emitting diodes because it is
an indirect band gap semiconductor
direct band gap semiconductor
wideband gap semiconductor
narrowband gap semiconductor

⇒ Maximum power transfer theorem finds application in
power circuits
distribution circuits
communication circuits
both power and communication circuits

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒ The generic microprocessor contains a zero and a carry flag. These are located on
interrupt control
status register
either (a) or (b)
none of the above

⇒ In an insulated gate FET, the polarity of inversion layer is the same as that of
minority carriers in source
majority carriers in source
charge on gate electrode
minority carriers in drain

⇒ In semiconductor strain gauge
resistance increases with strain
resistance decreases with strain
resistance increases with strain in p type and decreases with strain in n type
resistance increases with strain in n type and decreases with strain in p type

⇒ A photoconductor is a
conductor
semiconductor
insulator
superconductor

⇒ The function of a choke in a fluorescent lamp is
at the time of starting only
during the working of time but not at starting time
both at the time of starting and during working
none of the above

⇒ In EM waves, polarization
is always vertical in an isotropic medium
is caused by reflection
is due to transverse nature of waves
results from longitudinal nature of waves

⇒

Match the following:

	List I		List II
A.	C	1.	7 eV
B.	Si	2.	1.15 eV
C.	Ge	3.	0.75 eV
D.	Sn	4.	0.1 eV
E.	Pb	5.	0 eV

A-2, B-3, C-4, D-5, E-1
A-1, B-2, C-3, D-4, E-5
A-3, B-1, C-2, D-5, E-4
A-4, B-5, C-1, D-2, E-3

⇒ ABCD + AB C D =
ABC
ABCD
A B D
ABCD

⇒ Identification of highest priority interrupt can be achieved in a minimum time by which of the following schemes?
Hardwired polling
Priority encode circuit
Software polling
Subdivision of interrupt register into a number of sub registers which are checked parallely

⇒ The effect of earth's magnetic field on radiowaves is minimum when
the electric field lines of radio waves and flux line of earth's magnetic field are in the same direction
the electric field lines of radio waves and flux lines of earth's magnetic field are at right angles
the electric field lines of radiowaves and flux lines of earth's magnetic field oppose each other
both (b) and (c)

⇒ The amplitude of a random signal uniformly distributed between - 5 V and
0.0333 V
0.05 V
0.0667 V
0.10 V

⇒ The characteristic equation of a closed loop system is (s + 2) (s + 3) + K = 0. The centroid of the asymptotes in root locus is:
2.5
-2.5
0.5
-0.5

⇒ In figure V_i may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω

⇒ The divergence of a vector is a scalar, while the curl of a vector is another
scalar
vector
unit vector
none of the above

⇒ If an additional two diodes were used to connect the 1 kW load across a bridge rectifier circuits, utilizing the full secondary of the transformer, how much d.c. power could be delivered using a transformer with the rating of 105 VA?
35 W
60 W
85 W
100 W

⇒ The minority carrier life time and diffusion constant in a semiconductor material are respectively 100 microsecond and 100 cm²/sec. The diffusion length is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ If H(s) is positive real, 1/H(s)
is positive real
is not positive real
may or may not be positive real
must possess some other properties also if it is to be positive real

⇒

Assertion (A): A common collector amplifier is used for matching a high impedance source to a low impedance load

Reason (R): A common collector amplifier has a near unity voltage gain

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In 8085 microprocessor, the interrupt enable flip-flop is reset by
DI instruction only
system RESET only
interrupt acknowledgment only
all of the above

⇒ Semiconductor ROM's are sometimes preferred to semiconductor RAM's because
ROM's are cheaper than RAMs
ROMs are faster
ROMs do not require power supply for their operations
Programs stored in ROMs cannot be altered either by the power failure or by the user

⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r^-n is
absolutely integrable
absolutely summable
unity
< 1

⇒ Modulation is also called detection.
TRUE
FALSE

⇒ The logic represented by the abbreviation ECL is
Emitter Coupled Logic
Electron Carrier Logic
Encoding Clock Logic
Electrostatic Channel Logic

⇒ Value of 'K' for the system for which the system is stab
K < 1
K > 1
K < 2
K > 2