Question is ⇒ A lag compensator provides attenuation in, Options are ⇒ (A) very low frequency range, (B) low frequency range, (C) high frequency range, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ A lag compensator provides attenuation in, Options are ⇒ (A) very low frequency range, (B) low frequency range, (C) high frequency range, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A lag compensator provides attenuation in
A.	very low frequency range [Wrong Answer]
B.	low frequency range [Wrong Answer]
C.	high frequency range [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Dolby system of noise reduction divides the total audio spectrum into
8 frequency bands
4 frequency bands
2 frequency bands
none of the above

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ For small size high frequency coils, the most common core material is
air
ferrite
powdered iron
steel

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For a superconductor, magnetisation M in a field H is
extremely small
- H
- I
zero

⇒ In the equivalent circuit of a moving coil cone type loudspeaker, the mass of the moving system is represented by
a resistance
a capacitance
an inductance
a conductance

⇒ In the circuit figure LED will be on when v_{1less than 6 V
more than 6 V
less than 12 V
more than 12 V}

⇒ Consider the following C program int
All
1, 2, 3 only
2, 3, 4 only
1, 2, 4 only

⇒ A Ge diode operated at a junction temperature of 27°C. For a forward current of 10 mA, V_D is found to be 0.3 V. If V_D = 0.4 V then forward current will be
400 mA
475 mA
477 mA
480 mA

⇒ On the basis of the type of chemical bonds, solids may be classified into
ionic crystals
ionic and valence crystals
ionic crystal, valence crystals and metals
ionic crystals, valence crystals, metal and vander wall crystals

⇒ Which one is correct option?
Phase velocity is greater than light velocity
Group velocity is greater than light velocity
Phase velocity is equal to group velocity
Phase velocity is less than light velocity

⇒ Coupling and bypass filters can be a source of
low-frequency parasitics
high-frequency parasitics
carrier frequency parasitics
none of the above

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ A proportional controller is basically
an amplifier with adjustable gain
an integrating amplifier
an amplifier with infinite gain
an amplifier with almost zero gain

⇒ The output V-I characteristics of an Enhancement type MOSFET has
only an ohmic region
only a saturation region
an ohmic region at low voltage value followed by a saturation region at higher voltages.
an ohmic region at large voltage values. Preceded by a saturation region at lower voltages.

⇒ Generally a servomotor operates at
high torque and high speed
low torque and low speed
low torque and high speed
high torque and low speed

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε₀. The surface charge density on the conductor is ((ε₀ = 10^-9/36p)F/m)
0 c/m²
2 c/m²
1.8 x 10^-11 c/m²
1.14 x 10^-9 c/m²

⇒ When a potential is applied across an intrinsic semiconductor, holes flow
towards positive terminal
away from positive terminal
in the external circuit only
none of the above

⇒ In Z_RC (s) = 0 at s = ∞, the last element in first Cauer form is
R
C
R and C in series
R and C in parallel

⇒ In a communication system, noise is most likely to affect the signal
at the receiver
at the transmitter
at the information source
in the channel

⇒ Saturation region of a JFET is also known as
source region
analog region
pinch off region
ohmic region

⇒ Kirchoff's laws are applicable to
dc circuits
circuits with sinusoidal excitation only
dc circuits and circuits with sinusoidal excitation
circuits with any excitation

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine

⇒ For a Mod 64 parallel counter we need
6 flip flops
6 flip flops and 2 AND gates
6 flip flops and 4 AND gates
none of the above

⇒ A compensator has its pole and zero as shown in the given fi
lag compensator
lead compensator
lead-lag compensator
series compensator

⇒ In sound recording the degree of pre-emphasis is about 6 dB/ octave.
TRUE
FALSE

⇒ In a coaxial cable, braided copper is used for
conductor
shield
dielectric
jacket

⇒ When UJT is used for thyristor gate signal, the output of UJT is
sine wave
square wave
saw tooth wave
either (a) or (c)