Question is ⇒ When the gate terminal of MOSFET is positive, it is said to operate in, Options are ⇒ (A) depletion mode, (B) conduction mode, (C) enhancement mode, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ When the gate terminal of MOSFET is positive, it is said to operate in, Options are ⇒ (A) depletion mode, (B) conduction mode, (C) enhancement mode, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When the gate terminal of MOSFET is positive, it is said to operate in
A.	depletion mode [Wrong Answer]
B.	conduction mode [Wrong Answer]
C.	enhancement mode [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Padders are used in a receiver to
discard the carrier
facilitate tracking
filter the input signal
suppress noise

⇒ The reading of the voltmeter V in figure should be __________ v
60
10
66
0

⇒ A conductor is said to be perfect if it has __________ conductivity
finite
infinite
unity
zero

⇒ The service area of a TV transmitter is a little beyond radio horizon.
TRUE
FALSE

⇒ The current wave shown in figure is applied at t = 0 to a 0.1 F capacitor. At t = 1 s, the voltage across capacito
0 V
10 V
20 V
40 V

⇒ In a FM signal, the modulation index increases, then the power
increases
decreases
remains constant
none of the above

⇒ If G(s)H(s) = K (T₁s + 1)/[s² (T₂s + 1)] the system stability depended an relative magnitudes of T₁ and T₂.
TRUE
FALSE

⇒ The resistance of a 125 Ω strain gauge changes by 1 ohm for 4000 micro strain. The gauge factor is
1.5
2
2.5
3

⇒ For BJT, under saturation condition
I_C = βI_B
I_C > bI_B
I_C is independent of all other parameters
I_C < βI_B

⇒ An RLC series circuit is excited by 200 V, 100 Hz supply. The current is 20 A. If R = 10 Ω, X_L = 50 Ω, X_C is
10 Ω
14.14 Ω
7.07 Ω
50 Ω

⇒ In a TV receiver there is no raster, no picture and no sound. The most likely defective stage is
power supply unit
video output circuit
horizontal oscillator
balun

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ The spectrum of the white noise and an impulse function is similar in following aspects
both have similar magnitude spectrum
both have similar magnitude and Phase spectrum
no relation
similar phase spectrum

⇒ The OP-AMP circuit shown above represen
high pass filter
low pass filter
band pass filter
band reject filter

⇒ Consider the following stateme
1, 2, 3
1, 3, 4
2, 3, 4
1, 2, 4

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒ The total bandwidth needed for an AM signal at 55.25 MHz with 0.5 MHz video modulation is
0.25 MHz
0.5 MHz
1 MHz
10 MHz

⇒

Match the following:

	List I		List II
A.	CLP	1.	Measure of μP clock speed
B.	SHELL	2.	Double sided double density
C.	DSDD	3.	Allows you to specify file as command processor
D.	Megahertz	4.	Microcode stored in ROM

A-4, B-3, C-2, D-1
A-3, B-4, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1

⇒ Pick the correct statement with respect to following fig
both the circuit are not identical filter Ckts
identical filter circuit at all frequencies
identical filter circuit at low frequency
identical filter circuit at high frequency

⇒ A 400 W carrier is modulated to a depth of 75 percent. The total power in modulated wave will be
38.5 W
400 W
512.5 W
615.5 W

⇒ As regards dielectric constant ε_r
the units are farads/m
the units are newton/coulomb
it is dimensionless
the units are farads

⇒

Assertion (A): A series RLC circuit resonates when excited by variable frequency source.

Reason (R): Resonant frequency is geometric mean of half power frequencies.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure V_CEQ for each transisto
V_CC
0.5 V_CC
0.75 V_CC
0.25 V_CC

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
sin ω₁t + sin ω₂t

⇒ In figure the rms valu
5
2.5
2.5
50

⇒ Logarithmic amplifiers are used in
adders
dividers
multipliers
all of the above

⇒ Two wattmeter method is suitable only for balanced loads.
TRUE
FALSE

⇒ The colour subcarrier and sidebands produced by its modulation with the chrominance signals are accommodated in the standard channel width by the process of
frequency adjustment
frequency interleaving
frequency changing
frequency amalgamation

⇒ In the given figure the circuits for input impedance of a microwave device with output ports match terminated. The devic
E plane tee
H plane tee
magic tee
hybrid ring

⇒

Assertion (A): Silicon is the most favoured semiconductor material.

Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true