Question is ⇒ The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10<sup>6</sup> rad/sec. The possible combination of R, L,, Options are ⇒ (A) 2.5Ω, 0.2 mH, 200 pF, (B) 5 kΩ, 0.2 mH, 200 pF, (C) 5 kΩ, 0.2 mH, 200 μF, (D) 5 kΩ, 0.1 mH, 0.4 μF, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10<sup>6</sup> rad/sec. The possible combination of R, L,, Options are ⇒ (A) 2.5Ω, 0.2 mH, 200 pF, (B) 5 kΩ, 0.2 mH, 200 pF, (C) 5 kΩ, 0.2 mH, 200 μF, (D) 5 kΩ, 0.1 mH, 0.4 μF, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit in figure, is to be scaled to an impedance level of 5kΩ and resonant frequency of 5 x 10⁶ rad/sec. The possible combination of R, L,
A.	2.5Ω, 0.2 mH, 200 pF [Wrong Answer]
B.	5 kΩ, 0.2 mH, 200 pF [Correct Answer]
C.	5 kΩ, 0.2 mH, 200 μF [Wrong Answer]
D.	5 kΩ, 0.1 mH, 0.4 μF [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following quantities cannot be measured/determined using Hall effect?
Type of semiconductor (p or n)
Mobility of charge carriers
Diffusion constant
Carrier concentration

⇒ A capacitance transducer has two plates each of area 5 mm². The coil gap is 2 mm. Displacement sensitivity due to change in gap length is
11.1 pF/cm
44.2 pF/cm
52.3 pF/cm
66.3 pF/cm

⇒ Which one of the following devices is not used as the controller in a stabilizer?
DIAC
TRIAC
SCR
Power transistor

⇒ In the given figure, if R = X_C, voltage gai
0 dB
3 dB
-3 dB
20 dB

⇒ If x^k = a^k and k &g
TRUE
FALSE

⇒ An incremental model of a solid state device is one which represents the
ac property of the device at desired operating point
dc property of the device at all operating points
complete ac and dc behaviour at all operating points
ac property of the device at all operating points

⇒ In a JFET, the lower end is called the __________ and the upper end is called the __________ .
source, channel
channel, drain
source, drain
drain source

⇒ A CE amplifier is the most common BJT amplifier.
TRUE
FALSE

⇒ If R, L, C are in parallel, the currents through L and C are equal in magnitude at resonance.
TRUE
FALSE

⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate
12000 bps
1000 bps
6000 bps
3000 bps

⇒ Consider the following statements, SWR of a transmission line is infinite when the load is

a short circuit
a complex impedance
an open circuit
a pure reactance

Which of the above statements are correct?
1 and 3 only
1, 2, 3
2, 3, 4
1, 2, 4

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ In FORTRAN 77 FLOAT (-28) gives the value
28
-28
-28
none of the above

⇒ A transmission line has Z₀ = 300 Ω and Z_L = (300 - j300) ohm. The transmission coefficient is
1.265 ∠ - 18.43°
1.01 ∠ - 10°
1.14 ∠ 66.68°
1.09 ∠ 66.68°

⇒ TTL XOR gate is very suitable as LCO driver.
TRUE
FALSE

⇒ A frequency multiplier stage should operate as
class A
class AB
class C
either of the above

⇒ In 8085 microprocessor, what is the length of PC (program counter)?
6 bits
8 bit
12 bits
16 bits

⇒ An n type silicon bar 0.1 cm long and 100 μm² in cross-sectional area has a majority carrier concentration of 5 x 10²⁰/m³ and the carrier mobility is 0.13 m⁰/V-s at 300k. If the charge of an electron is 1.6 x 10^-19 coulomb, then the resistance of the bar is
10⁶ ohm
10⁴ ohm
10^-1 ohm
10^-4 ohm

⇒ The absorption of radio waves by the atmosphere depends on
the polarization of the waves
the polarization of the atmosphere
frequency of the waves
their distance from the transmitter

⇒ A pulse train with a 1 MHz frequency is counted using a 1024 modulus ripple counter using JK flip flops. The maximum propagation delay for each flip-flop should be
1 μs
0.5 μs
0.2 μs
0.1 μs

⇒ In hexadecimal number system, A is equal to decimal number
10
11
17
18

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

⇒ The boundary conditions at the interface between two dielectrics in an electric field are given by
D_normal = 0, E_tangential = 0
D_normal = 0, E_normal = 0
D_tangential = 0, E_tangential = 0
D_tangential = 0, E_normal = 0

⇒ The maximum signal propagation time of a geosynchronous satellite transmission is about __________ millisecond.
540
270
135
1080

⇒ An electron rises through a voltage of 100 V. The energy acquired by it will be
100 eV
100 joules
(100)^1.2 eV
(100)^1.2 joules

⇒ The spins in a ferrimagnetic material are
all aligned parallel
partially aligned antiparallel without exactly cancelling out sublattice magnetisation
randomly oriented
all aligned antiparallel such that the sublattice cancels out exactly

⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)

⇒ The time constant of an R.C. circuit increases if the value of resistance is
increased
decreased
either of the above
none of the above

⇒ The IF bandwidth of a radar receiver is inversely proportional to
pulse interval
pulse width
PRF
none of the above