Question is ⇒ The properties of JFET resemble those of, Options are ⇒ (A) thermionic values, (B) N-P-N transistors, (C) P-N-P transistors, (D) unijunction transistor, (E) , Leave your comments or Download question paper.

Question is ⇒ The properties of JFET resemble those of, Options are ⇒ (A) thermionic values, (B) N-P-N transistors, (C) P-N-P transistors, (D) unijunction transistor, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The properties of JFET resemble those of
A.	thermionic values [Wrong Answer]
B.	N-P-N transistors [Correct Answer]
C.	P-N-P transistors [Wrong Answer]
D.	unijunction transistor [Wrong Answer]
View Answer 2 -8 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For satellite transmission, analog signals may be converted into digital form with the help of
modem
transponder
codec
compandor

⇒ The degradation of satellite solar cells with time is mainly due to
their bombardment by electrons
collection of meteoric dust
increase in resistivity of silicon
gradual leakage of charge carriers from the semiconductor material

⇒ At room temperature, the current in intrinsic semiconductor is due to
holes
electrons
ions
holes and electrons

⇒ A 3 bit up-down counter can count from
000 to 111
111 to 000
000 to 111 and also from 111 to 000
none of the above

⇒ A signal x₁(t) and x₂(t) constitute the real and imaginary parts respectively of a complex valued signal x(t). What form of waveform does x(t) possess?
Real symmetric
Complex symmetric
Asymmetric
Conjugate symmetric

⇒ Cache memory size is about
a few KB
about 500 KB
about 1 MB
about 50 MB

⇒ QAM stands for
Quasi-Amplitude Modulation
Quadrature Angle Modulation
Quadrature Amplitude Modulation
None of the above

⇒ To cover all inhabited regions of the Earth, the number of geosynchronous communication satellites required
5
3
10
2

⇒

Assertion (A): The output voltage of an inverter can be controlled by PWM technique

Reason (R): In a current source inverter the input current is constant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a series RLC circuit for lower frequency power factor is ________
leading, Lagging
lagging, Leading
independent of frequency
same

⇒ Which one of the following pairs is not correctly matched?
NaCl : Diamagnetic
Gd : Paramagnetic
Ferrite : Ferrimagnetic
Cr₂ O₃ : Ferromagnetic

⇒ Which are of the following oscillators is well suited for the generation of wide range audio-frequency sine waves?
RC phase-shift oscillator
Wien-bridge oscillator
Colpitts oscillator
Hartley oscillator

⇒ In a self bias circuit for CE amplifier, the emitter resistance is made three times the original value. The collector current will
remain the same
become three times
decrease
become one-third

⇒ Thyristors connected in series need :
static equalizing circuit
dynamic equalizing circuit
both static and dynamic equalizing circuits
none of the above

⇒ If transmission path, in PCM, is very long then
repeater stations are used
pulse width may be increased
pulse amplitude is increased
pulse spacing is reduced

⇒ The system of the given fi
has two poles and one zero in left half plane
has two poles and one zero in right half plane
has two poles in left half plane and zero in right half plane
none of the above

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ In push pull amplifier, each transistor conducts for
180°
360°
90°
45°

⇒ For VLF antennas radiation resistance is usually of the order of
less than one ohm
13 to 20 ohms
around 100 ohms
more than 200 ohms

⇒ The voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit) is 25 volts. The maximum voltage on the reverse biased diode will be
100 V
50 V
25 V
12.5 V

⇒ In a series L-C circuit fed by ac voltage, voltage drops across L and C are 40 V and 30 V respectively. The supply voltage is
70 V
10 V
50 V
1.333 V

⇒ In a micro computer the control bus
transmits and receives control signals between processor and other devices
transmits and receives control signals, also sends and receives data
transmits and receives control signals, sends and receives data and transmits address of the device
none of the above

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ When a unit step voltage drives a lag network the output
remains constant at unit step value
increases exponentially from zero to final value
decreases exponentially from 1 to 0
either (b) of (c) depending on values of R and C

⇒ In FM modulation pre-emphasis is done for
high frequency components
low frequency components
middle frequency components
both (a) and (b)

⇒ The two outputs of RS flip-flop are
always low
always high
either low or high
always complementary

⇒ In Z_RC (s) has a pole at s = ∞, the last element in first Foster realization is
R
C
R and C in series
R and C in parallel

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ A constant k low pass filter has f_c = 1000 Hz. At f = 500 Hz, the phase shift is
p
zero
more than p
less than p

⇒ If V = 4 in the figure, the value of I_S is given
0.25
5/2 A
0
None of these