Question is ⇒ Find value, Options are ⇒ (A) 1A, (B) 0A, (C) 0.45 A, (D) None of these, (E) , Leave your comments or Download question paper.

Question is ⇒ Find value, Options are ⇒ (A) 1A, (B) 0A, (C) 0.45 A, (D) None of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Find value
A.	1A [Wrong Answer]
B.	0A [Wrong Answer]
C.	0.45 A [Correct Answer]
D.	None of these [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following refers to SSB suppressed carrier amplitude modulated system?
A3E
H3E
J3E
C3F

⇒

Assertion (A): Interfacing means synchronisation of digital information transmission between input output devices and computer.

Reason (R): A computer with higher bit word size executes programs at a faster rate.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about g_m r_d

Reason (R): A common source amplifier is a source follower circuit

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The resonance frequency of the circui
5.4 Kn₂
4.5 Kn₂
5 Kn₂
∞

⇒

Assertion (A): If an atom of polarizability a is placed in homogeneous field E, the energy stored is 0.5 aE².

Reason (R): Capacitance of an isolated conducting sphere R in vacuum is 4 p∈₀ R farads.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Typical size of digital IC is about
1″ x 1″
2″ x 2″
0.1″ x 0.1″
0.001″ x 0.001″

⇒ The core of a coil has a length of 10 cm. The self inductance is 8 mH. If the core length is doubled, all other quantities remaining the same, the self inductance will be
32 mH
16 mH
8 mH
4 mH

⇒ For a sine wave the average value is calculated over half the cycle.
TRUE
FALSE

⇒ A uniform plane magnetic wave incident normally on a plane surface of a dielectric material is reflected and the percentage of reflected power is 75% What is VSWR?
14
1.4
15
13

⇒ Figure shows a self bias circuit for FET amplifier, I_D = 4 mA. Then I_{S4 mA
2 mA
0.4 mA
0.2 mA}

⇒ Figure shows four D type FFs are connected as a shift register using an XOR gate. The initial state and 3 subsequent states for 3 clock pulses are also g
0
1111
1001
1000

⇒ Consider the following mnemonics

MOV
ADD
LXI

Which of the above are valid for 8085?
1 and 2 only
1 only
1, 2 and 3
1 and 3 only

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index

⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the
resistor R₁
condenser C₂
condenser C₁
inductor L

⇒ In figure the output v(t)
an amplitude modulated signal
a frequency modulated signal
a phase modulated signal
none of the above

⇒ The equivalent inductance seen at terminals A -
14 H
20 H
10 H
4 H

⇒ Which of the following oscillator circuits uses three capacitors in the phase shifting network?
Hartley
Clapp
Colpitt's
Both (b) and (c)

⇒ Which one of the systems described by the following I/P - O/P relations is time invariant
y(n) = n x(n)
y(n) = x(n) - x(n - 1)
y(n) = x(- n)
y(n) = x(n) cos 2pf₀n

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒

Assertion (A): A p-n junction has high resistance in reverse direction.

Reason (R): When a reverse bias is applied to p-n junction, the width of depletion layer increases.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The circuit of figur
positive clipper
negative clipper
combination clipper
either (a) or (b)

⇒ If transmitted power is 10 kW, the field strength at a distance d is 50 mV/m. If transmitted power is reduced to 2.5 kW, the field strength at the same point will be
25 mV/m
12.5 mV/m
6.25 mV/m
3.125 mV/m

⇒

Assertion (A): The forward dynamic resistance of p-n diode varies inversely with current.

Reason (R): The forward dynamic resistance of p-n diode varies with the operating voltage.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The difference between measured value and true value is called
gross error
relative error
probable error
absolute error

⇒ In binomial arrays the elimination of secondary lobes takes place
at the cost of directivity
at the cost of gain
both (a) and (b)
none of the above

⇒ Determine the correctness or otherwise of the following Assertion [a] and the Reason
Both [a] and [r] are true and [r] is the correct reason for [a]
Both [a] and [r] are true but [r] is not the correct reason for [a]
Both [a] and [r] are false
Both [a] and [r] are true

⇒ The function of shunt in an ammeter is to
by pass the current
increase sensitivity of meter
increase resistance of meter
all of the above

⇒ Space wave may be a direct wave or wave reflected from earth.
TRUE
FALSE

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ FM receivers using the standard 88 to 108 MHz band use IF of
8 MHz
9.9 MHz
10.7 MHz
12.2 MHz