Question is ⇒ A material for permanent magnet should have, Options are ⇒ (A) High retentivity, (B) High permeability, (C) Low hysteresis loss, (D) High hysteresis loss, (E) , Leave your comments or Download question paper.

Question is ⇒ A material for permanent magnet should have, Options are ⇒ (A) High retentivity, (B) High permeability, (C) Low hysteresis loss, (D) High hysteresis loss, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A material for permanent magnet should have
A.	High retentivity [Correct Answer]
B.	High permeability [Wrong Answer]
C.	Low hysteresis loss [Wrong Answer]
D.	High hysteresis loss [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Pascal an array declaration provides information to the Pascal processor to enable it to
identify the variable as an array name
reserve memory locations to store all the components of array
check the values computed for subscripts expressions during program execution with the specified lower and upper limits of subscripts
all of the above

⇒ The distance of a synchronous satellite from Earth's surface is __________ km.
300
10000
35900
5

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒ In a TV receiver the raster is normal but there is no sound and quality of picture is poor. The defective part is
power supply
loudspeaker
AGC, video IF amplifier, RF amplifier
horizontal oscillator

⇒ At resonance, the parallel circuit constituted by an iron-cored coil and a capacitor behaves
open circuit
short circuit
pure resistor of value R
pure resistor of value much higher than R

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ If S represents the carrier synchronization at the receiver and r represents the bandwidth efficiency, then the correct statement for the coherent binary PSK is
r = 0.5, S is required
r = 1.0, S is required
r = 0.5, S is not required
r = 1.0, S is not required

⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA

⇒ The attenuation factor in parallel plane guides is given by
a = power lost/power transmitted
a = 2 x power lost/power transmitted
a = power lost per unit length/2 x power transmitted
a is always constant

⇒

Assertion (A): In design of circuit using BJT, a derating factor is used.

Reason (R): As the ambient temperature increases, heat dissipation becomes slower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒ In 8085 microprocessor, even after a Reset operation which of the following interrupts remains enabled?
INTR
RST 5.5
RST 7.5
TRAP

⇒ In a practical voltage source, the terminal voltage
cannot be less than source voltage
cannot be higher than source voltage
is always less than source voltage
is always equal to source voltage

⇒ An FM signal is modulated by an 8 kHz sine wave and has maximum and minimum frequencies of 100.05 MHz and 99.95 MHz respectively. Its deviation frequency is
100 kHz
100 MHz
500 kHz
108 kHz

⇒ A horizontal output stage is cutoff for retrace and 40% of trace. If time for each horizontal line is 64 μs and retrace time is 12 μs, the transistor is conducting for about
64 μs
6.4 μs
31 μs
3.1 μs

⇒ Typical values of current gains for CE, CB and CC amplifiers are
120, 120 and 1 respectively
120, 1 and 120 respectively
1, 120 and 120 respectively
1, 1 and 120 respectively

⇒ One advantage of using polar plot is that it depicts the frequency response characteristics over the entire frequency.
TRUE
FALSE

⇒ Tape recorders use
cone type loudspeakers
horn type loudspeakers
either cone type or horn type loudspeakers
none of the above

⇒ When a 1 V increase in gate voltage changes the drain current 10 mA in an FET, its g_m equals
10 μμ
100 μμ
1000 μμ
10000 μμ

⇒ In a bistable multivibrator, commutating capacitors are used to
increase the base storage charge
provide ac coupling
increase the speed of response
alter the frequency of the output

⇒ If the valence electron is separated from a copper atom, the remaining part of atom has a net charge of
1
-1
0
3

⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above

⇒ A n-type silicon sample contains a donor concentration of N_d = 2 x 10¹⁶ cm^-3. The minority carrier hole lifetime is t_p0 = 5 μs. The thermal equilibrium generation rate of hole is:
1.125 x 10⁹ cm^-3 s^-1
0.625 x 10⁹ cm^-3 s^-1
4.5 x 10⁹ cm^-3 s^-1
2.25 x 10⁹ cm^-3 s^-1

⇒ As the number of flip flops are increased, the total propagation delay of
ripple counter increases but that of synchronous counter remains the same
both ripple and synchronous counters increase
both ripple and synchronous counters remain the same
ripple counter remains the same but that of synchronous counter increases

⇒ The number of doped regions in a bipolar junction transistor is
1
2
3
4

⇒

Assertion (A): Wien bridge can be used for measuring frequency.

Reason (R): A frequency meter for 50 Hz system has a frequency range of 40 to 60 Hz.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ EEPROM permits
read operation only
read and byte erase operations
read, byte erase and byte write operations
read, byte erase, byte write and chip erase operations

⇒ If the reverse voltage across a p-n junction is increased three times, the junction capacitance
will decrease
will increase
will decrease by an approximate factor of about 2
will increase by an approximate factor of about 2

⇒ If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is
0.04
0.08
0.16
0.32

⇒ Which of the following is the main difference between waveguide and transmission line?
Waveguides cannot be coupled to coaxial lines
Waveguides have no standing wave ratio
Transmission line does not suffer from the effect of low cut off frequency
Waveguides are not distributed like transmission lines