Question is ⇒ For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input, Options are ⇒ (A) 0°, (B) 90°, (C) -90°, (D) ± 180°, (E) , Leave your comments or Download question paper.

Question is ⇒ For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input, Options are ⇒ (A) 0°, (B) 90°, (C) -90°, (D) ± 180°, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input
A.	0° [Wrong Answer]
B.	90° [Wrong Answer]
C.	-90° [Wrong Answer]
D.	± 180° [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The propagation delay in ECL is minimum

Reason (R): Transistors used in ECL switch between active and cutoff regions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The circuits with active pull up are preferred because of their stability for
wired - AND operation
wired - OR operation
bus operated system
reasonable dissipation and speed of operation

⇒ If the plate supply voltage for a plate modulated class C amplifier is E, the maximum plate cathode voltage could be almost as high as
E
2 E
3 E
4 E

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε₀. The surface charge density on the conductor is ((ε₀ = 10^-9/36p)F/m)
0 c/m²
2 c/m²
1.8 x 10^-11 c/m²
1.14 x 10^-9 c/m²

⇒ How many maximum number of functions can be defined with two symbols which are Boolean in nature:
4
8
2
16

⇒ During day time ionosphere consist of
D, E, F₂ layers
D, E, F layers
D, E, F₁, F₂ layer
none

⇒ The binary number 101100.110 in octal number will be
152.6
154.6
145.6
174.6

⇒ A woofer should be fed from the input through a
low pass filter
high pass filter
band pass filter
band stop filter

⇒ The circuit in figure is
resonant commutation
self commutation
load commutation
auxiliary commutation

⇒ The property is not valid for basic singularity function is
it is even signal
convolution of any arbitary function x(t) and an impulse is the original function itself
the sum of two impulses at same location is the impulse with the strength equal to the summation of individual strengths.
none of these.

⇒ In ionic bonding, the valence electron is donated by one atom and accepted by the other atom.
TRUE
FALSE

⇒ The number of doped regions in PIN diode is
1
2
3
1 or 2

⇒ If the intrinsic resistivity at 300°K is 0.37 ohm-m and the electron and hole mobilities at 300°K are 0.28 and 0.15 m²/volt-sec, then the intrinsic carrier concentration of Germanium is __________ .
2.92 x 10¹⁹/m³
2.92 x 10^-19/m³
1.92 x 10¹⁹/m³
3.92 x 10¹⁹/m³

⇒ Separation property of state-transition matrix is
φ(t - t₀) = φ(t) φ(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)
φ(t - t₀) = φ(t) φ^-1(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)

⇒ Transistor are free from which type of noise?
Resistance noise
Partition noise
Flicker noise
Shot noise

⇒ Frequency response approach is a simple approach to control system design.
TRUE
FALSE

⇒ A 50 Hz current has an amplitude of 10 A. The rate of change of current at t = 0.005 after i = 0 and is increasing is
2221.44 A/s
0
- 2221.44 A/s
- 3141.6 A/s

⇒

Assertion (A): Mnemonics are used in assembly level program.

Reason (R): Computer cannot understand mnemonics.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The orientation polarization of a polyatomic gas is inversely proportional to absolute temperature.
TRUE
FALSE

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ Which of the following microphones has maximum distortion?
Ribbon
Condenser
Crystal
Carbon

⇒ Which of the following has highest conductivity?
Silver
Aluminium
Tungsten
Platinum

⇒ What does the operator ( ) mean in C?
Function expression
Array expression
Structure operator
Increment / Decrement

⇒ In figure, V_{0zero
5.7 V
6.9 V
12.6 V}

⇒ Magnetic field intensity has the dimensions
IL
I²L
IL^-1
IL^-2

⇒ The power input and output in a device are 3650 W and 3385 W with each reading in doubt by ± 10 W. The percentage uncertainty in losses is
± 7.55%
± 3.77%
± 11.32%
± 15.09%

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9

⇒ A series circuit has fixed resistance and variable reactance. The impedance locus will be a straight line parallel to Y-axis.
TRUE
FALSE

⇒ ICs are
analog
digital
both analog and digital
mostly analog

⇒ Which of the following statements in FORTRAN 77 is non executable?
GO TO
RETURN
STOP
PARAMETER