Question is ⇒ The two terms used to describe performance of a directional coupler are, Options are ⇒ (A) coupling and directivity, (B) gain and coupling, (C) gain and directivity, (D) gain and isolation, (E) , Leave your comments or Download question paper.

Question is ⇒ The two terms used to describe performance of a directional coupler are, Options are ⇒ (A) coupling and directivity, (B) gain and coupling, (C) gain and directivity, (D) gain and isolation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The two terms used to describe performance of a directional coupler are
A.	coupling and directivity [Correct Answer]
B.	gain and coupling [Wrong Answer]
C.	gain and directivity [Wrong Answer]
D.	gain and isolation [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The curve representing Ohm's law is
linear
a parabola
a hyperbola
sine function

⇒ What is the purpose of a start in RS232 serial communication protocol?
To synchronise receiver for receiving every byte
To synchronise receiver for receiving a sequence of byte
Acts as a parity bit
To synchronise receiver for receiving the last byte

⇒ Consider the following advantages of phase array radar

simple circuitry
ability to track and scan simultaneously
ability to track many targets together
very fast scanning

Which of the above are correct?
1, 2, 3
1, 3, 4
2, 3, 4
1, 4 only

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ Companding is used
to overcome quantising noise in PCM
in PWM receivers to reduce impulse noise
to protect small signals in PCM from quantising noise
none of the above

⇒

Assertion (A): CRO can be used to study waveshape accurately.

Reason (R): Input impedance of a CRO is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒ A ripple counter has 4 bits and uses flip flops with propagation delay time of 25 ns. The maximum possible time for change of state will be
25 ns
50 ns
75 ns
100 ns

⇒

Match the following:

	List I		List II
A.	Electro-encephalograph	1.	Diagnostic tool for heart ailment
B.	Electro-cardiograph	2.	Diagnostic tool for brain ailment
C.	Sphygmomanometer	3.	used for measuring BP
D.	Stethoscope	4.	used to heart pulse/ heart beat

A-2, B-1, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-1, C-4, D-3
A-1, B-2, C-3, D-4

⇒ Two ammeters A and B are connected in parallel in a circuit carrying 100 A. Their resistances are 0.8 mΩ. Their readings will be.
55.56 and 44.44 A respectively
44.44 A and 55.56 A respectively
60 A and 40 A respectively
40 A and 60 A respectively

⇒ Consider a silicon p-n junction at room temperature having the following paramet
0.15 MV.com^-1, directed from p-region to n-region
0.15 MV.com^-1, directed from n-region to p-region
1.80 MV.com^-1, directed from p-region to n-region
1.80 MV.com^-1, directed from n-region to p-region

⇒ Status register in the 8156 contains information about
the timer
the ports
both (a) and (b)
none of the above

⇒ For the system of the given figure the closed loop poles are locate
s = 0 and s = -2
s = 0, s = -l ± j3
s = -1 ± j3
s = -2 and s = -1 ± j3

⇒

Match the following:

	List I		List II
A.	Silicon	1.	Donor Impurity
B.	Antimony	2.	Acceptor Impurity
C.	Gallium	3.	Most Commonly used semiconductor material
D.	Germanium	4.	Atomic number 32

A-3, B-1, C-2, D-4
A-2, B-3, C-1, D-4
A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1

⇒ In the circuit of figure, the current through battery E_{34 A charging
4 A discharging
4 A charging or discharging depending on value of E₃
4 A charging or discharging depending on values of E₁, E₂, E₃}

⇒ If the ratio p(s)/q(s) represents a transfer function then
the degree of p(s) may be as small as zero, independent of degree of q(s)
the degree of p(s) and q(s) must be equal
the degrees of p(s) and q(s) must not be equal
the degrees p(s) and q(s) must differ by at least two

⇒ A periodic voltage has following value for equal time intervals changing suddenly from one value to next... 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. Then rms value of the waveform is
31 V
32 V
insufficient data
none of these

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec

⇒ The average noise temperature of Earth, as viewed from space, is __________ °K.
254
303
100
500

⇒ The relation between bandwidth B, modulating frequency f_m and frequency deviation Δf for a sinusoidally modulated FM signal is
B = Δf + f_m
B = 2(Δf + f_m)
B = f_m - Δf/
B = 2(f_m - Δf)

⇒ The operations which occur most frequently in a computer are
fetch
execute
both (a) and (b)
none of the above

⇒ In a FM waveform, the side bands are spaced at intervals equal to
four times the modulating frequency
twice the modulating frequency
half the modulating frequency
modulating frequency

⇒ In a 3 byte instruction of 8085, the first, second and third byte respectively indicate
operation code, low order byte of data/address and high order byte of data / address
low order byte of data / address, high order byte of data / address and operation code
high order byte of data / address, low order byte of data / address and operation code
high order byte of data / address, operation code and low order byte of data / address

⇒ Which of the following does not show non-linear V-I characteristics?
Schottky diode
Tunnel diode
Thermister, at a fixed temperature
p-n junction diode

⇒ In a FM receiver, amplitude limiter
amplifiers low frequency signals
reduces the amplitude of signals
eliminates any change in amplitude of received FM signals
none of the above

⇒ A Discone antenna is
a combination of disk and cone in close approximity
a combination of disk and cone at λ/4 spacing
a combination of disk and cone far apart
a combination of disk and cone at λ/2 spacing

⇒ Which of the following instruments has non-linear scale?

Moving coil instrument
Moving iron instrument
Electrostatic instrument
Rectifier instrument

Select the answer as per following codes
2 only
2 and 3 only
2, 3 and 1
1, 2, 3 and 4

⇒ If the connection of two-port is such that the transmission matrix of the overall network is the product of the transmission matrices of the individual networks, what type of connection is it?
Series connection
Cascade connection
Parallel connection
None of the above

⇒ The encapsulation of transistor is necessary for
preventing radio interference
preventing photo-emission effects
avoiding loss of free electrons
mechanical ruggedness