Question is ⇒ Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than, Options are ⇒ (A) 500 V, (B) 400 V, (C) 375 V, (D) 250 V, (E) , Leave your comments or Download question paper.

Question is ⇒ Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than, Options are ⇒ (A) 500 V, (B) 400 V, (C) 375 V, (D) 250 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Two voltmeters 0-250 V each having resistances of 5 kΩ and 10 kΩ respectively and are connected in series. To ensure that neither of them goes beyond scale the total voltage which can be applied should be less than
A.	500 V [Wrong Answer]
B.	400 V [Wrong Answer]
C.	375 V [Correct Answer]
D.	250 V [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The write cycle time of memory is 200 nsec. The maximum rate of data which can be stored is
200 words/sec
5 x 10³ words/sec
5 x 10⁶ word/sec
5 x 10⁹ words/sec

⇒ Which of the following is invalid integer variable name in Fortran?
IAEG
I 124
AILG
MI AC

⇒ The life time of a geosynchronous communication
5
10
20
50

⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0

⇒ The read and write cycle times of cache memory are in the range of
1 - 3 ns
25 ns - 45 ns
200 ns - 300 ns
1 μs

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ A waveguide operated below cut off frequency can be used as
phase shifter
an attenuator
an isolator
none

⇒ The conversion or collector circuit efficiency is a measure
how successfully the active device converts D.C. power to A.C. signal power
how much distortion in output is reduced with respect to input
how successfully the active device converts A.C. power to D.C. signal power
none of the above

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ In air friction damping
the air pressure opposes the motion of piston when it is moving inwards
the air pressure opposes the motion of piston when it is moving outwards
the air pressure opposes the motion of piston both when it is moving inwards as well as outwards
the air pressure may oppose or aid the motion of piston depending on the design

⇒ Two rectangular waveforms of duration t₁ and t₂ seconds are convolved. What is the shape of the resulting waveform?
Triangular
Rectangular
Trapezoidal
Semi-circular

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following Boolean algebra rules is correct?
A . A = 1
A + AB = A + B
A + A B = A + B
A(A + B) = B

⇒ The minimum number of equations required to analyze the circuit shown in the figur
3
4
6
7

⇒ For a two port network to be reciprocal
Z₁₁ = Z₂₂
y₁₂ = y₂₁
h₂₁ = - h₁₂
AD - BC = 0

⇒

Assertion (A): A photovoltaic cell is greatly affected by temperature.

Reason (R): Both germanium and silicon can be used for photovoltaic cells.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In 8086
the registers SI and DI are used for string operation
the registers CS and DS are used for string operation
the registers SS and ES are used for string operation
the registers SI and SP are used for string operation

⇒ Vectored interrupt is an interrupt that takes the program to a vector location. TRAP vectors to 0024 FI, RST 7.5 to 003 CH, RST 6.5 to 0034 H and
RST 5.5
RST 6.5
24 H to 48 H
RST 5.5 to 002 CH

⇒

JCOKE
8
11
16
20



⇒ The sinusoidally time varying vector fi
elliptically polarized
circularly polarized
linearly polarized
unpolarized

⇒ In an R-S latch, to set the output to high
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ If reference sound pressure P₀ is 2 x 10^-5 N/m², a sound pressure of 90 dB is equal to
0.632 N/m²
0.707 N/m²
0.835 N/m²
0.925 N/m²

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the characteristic impedance will be
14 Ω
28 Ω
39 Ω
79 Ω

⇒ In 8085 microprocessor system, what will be the total delay provided by the following loop.3.154 msec
3.514 msec
2.644 msec
3.166 msec

⇒ Consider the following statements regarding negative feedback It increases system gain
It improves sensitivity
It improves system stability
 Which of these are not correct?
all
1, 2
1, 3
1 only

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.
variable
low
negative
positive

⇒ Data can be changed from spatial code to temporal code and vice-versa by using
ADC and DAC
shift Register
synchronous counter
timers

⇒ When the carrier is unmodulated, a certain transmitter radiates 9 kW when the carrier is sinusoidally modulated the transmitter radiates 10.125 kW. The modulation index will be
0.1
10.15
0.4
0.5

⇒ Assertion (A): A Smith chart can be used for a number of calculations of a transmission line
Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	



    
	StudySite.org is world's best online study provider, Copyright © 2023 by 
StudySite.org All Rights Reserved