Question is ⇒ An antenna array pattern is to used for increasing, Options are ⇒ (A) gain, (B) directivity, (C) directive gain, (D) all, (E) , Leave your comments or Download question paper.

Question is ⇒ An antenna array pattern is to used for increasing, Options are ⇒ (A) gain, (B) directivity, (C) directive gain, (D) all, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	An antenna array pattern is to used for increasing
A.	gain [Wrong Answer]
B.	directivity [Wrong Answer]
C.	directive gain [Wrong Answer]
D.	all [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following microphones is the cheapest?
Moving coil
Condenser
Ribbon
Carbon

⇒ In a JK Master slave flip flop
both master and slave are positively clocked
both master and slave are negatively clocked
master is positively clocked and slave is negatively clocked
master is negatively clocked and slave is positively clocked

⇒ Frequency band used for radar is generally
VLF
VHF
UHF
EHF

⇒ Consider the following statements regarding negative feedback

It increases system gain
It improves sensitivity
It improves system stability

Which of these are not correct?
all
1, 2
1, 3
1 only

⇒ For the given figure C(s)/R(s<
K
0.5 K
2 K
0.25 K

⇒ Which gives minimum probability of error?
ASK
FSK
PSK
DPSK

⇒ For a sine wave the average value is calculated over half the cycle.
TRUE
FALSE

⇒ A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be
correlated
statistically independent
uncorrelated
orthogonal

⇒ Radiation resistance of half-wave dipole (λ/2) antenna is in free space
73 Ω
120 p
36.5 Ω
70 Ω

⇒ In a programmable counter
the starting number for counting can be programmed
the modulus can be programmed
both the starting number and modulus can be programmed
either the starting number or modulus can be programmed

⇒ In 2's complement representation, a certain negative number - N is 1011. The representation for + N is
100
101
110
11

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ Which of the following modes can exist in a rectangular waveguide?
TM₁₀
TE₁₀
TM₀₀
TM₀₁

⇒ If initial value of PROD is zero and a program adds X to PROD, Y times we get the result
X + Y
XY
X / Y
X - Y

⇒ The damping coefficient for the given circuit is _______
42737
42739
2
1

⇒ Which of the following is a valid logical expression in Pascal?
2.5 : = A
(A + B) < < (C + D)
A = < B
A > = B

⇒ An AC circuit has two branches in parallel. The current in one branch is 5 A. Then the current source
must be less than 5 A
must be more than 5 A
may be equal or more or less than 5 A
0.208333333333333

⇒ Figure represen
Tunnel diode
PNP transistor
Photo sensitive diode
Photo emissive diode

⇒ Consider the following statements for a driving point function F(jω):
Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.
Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒ In TE₁₀mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)

⇒ Which of the following is not a specification of D/A and A/D converters?
Gain
Drift
Speed
Accuracy

⇒ A compiler is a software programme which
change high level Programming language into low level machine language
change the program into binary form
assembles the program
executes the program

⇒ For an insulating material, dielectric strength and dielectric loss should be respectively
high and high
low and high
high and low
low and low

⇒ If interrupt service request have been received from all of the following interrupts, then which one will be serviced last?
RST 5.5
RST 6.5
RST 7.5
None of these

⇒ If all bubbles are removed, what are the new RAM locati
(8000)_H - (83FF)_H
(80AA)_H - (80FF)_H
(FF00)_H - (FFFF)_H
none of the above

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒
Match the following:
List I (Operator in C) List II (Priority of Operation)
A. ! 1. 1
B. < > 2. 2
C. ∗ 3. 3
D. = 4. 4

A-1, B-2, C-3, D-4
A-1, B-3, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4

⇒ A parallel plate capacitor with air as dielectric has a capacitance C. If the dielectric has a dielectric constant ∈_r and the remaining dimensions are the same, the capacitance will be
C/∈_r
∈_rC
∈²_rC
∈³_rC

⇒ In 8085 microprocessor, when TRAP interrupt is triggered program control is transferred to location
0020 H
0024 H
0028 H
002 CH

⇒ Which one of the following compounds is widely used for making ferrites?
FeO
CuO
MgO
Fe₂O₃

	List I (Operator in C)		List II (Priority of Operation)
A.	!	1.	1
B.	< >	2.	2
C.	∗	3.	3
D.	=	4.	4

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math