Question is ⇒ The effective channel length of a MOSFET in saturation decreases with increase in, Options are ⇒ (A) gate voltage, (B) drain voltage, (C) source voltage, (D) body voltage, (E) , Leave your comments or Download question paper.

Question is ⇒ The effective channel length of a MOSFET in saturation decreases with increase in, Options are ⇒ (A) gate voltage, (B) drain voltage, (C) source voltage, (D) body voltage, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The effective channel length of a MOSFET in saturation decreases with increase in
A.	gate voltage [Correct Answer]
B.	drain voltage [Wrong Answer]
C.	source voltage [Wrong Answer]
D.	body voltage [Wrong Answer]
View Answer 1 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Degaussing in a picture tube means
Adding magnetism in mask and mounting frame
Removing residual magnetism in mask, shield etc...
Increasing resistance of coils to decrease time constant
Decreasing resistance of coils to increase time constant.

⇒ Light dependent resistors are
highly doped semiconductor
intrinsic semiconductor
lightly doped semiconductor
either (a) or (c)

⇒ As per temperature limits, the number of categories of solid dielectrics are
7
6
8
5

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ n type semiconductors
are negatively charged
are produced when indium as impurity is added to germanium
are produced phosphorus as impurity is added to silicon
none of the above

⇒

Assertion (A): Industrial robots improve productivity.

Reason (R): Robots can handle monotonous and complex jobs without error in operation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index m_t
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is not valid integer variable in FORTRAN 77?
MBR
LOTS
JAMMU
BRG

⇒ An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about
20 μV
5μV
14.14 μV
10 μV

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ In an op-amp a common mode signal is applied to
inverting terminal
non-inverting terminal
both terminals
one or both the terminals

⇒ Sometimes the rotating devices in a room having fluorescent lamps appear to be any station. This is due to
defect in the lamp
low voltage
high voltage
stroboscopic effect

⇒ Which of the following are donor impurities?

Select the correct answer using the following codes
1, 2, 3
1, 2, 4, 6
3, 4, 5, 6
2, 4, 5

⇒ Pirani gauge is used to measure
very low pressure
high pressure
pressure in the range of 1 atmosphere
fluid flow

⇒ n channel FETs are better as compared to p-channel FET because
they are more efficient
they have high switching time
they have higher input impedance
mobility of electrons is more than that of holes

⇒ In an R-L-C circuit, v(t) = 20 sin (314 t + 5 p/6) and i(t) = 10 sin (314 t + 2p/3). The p.f of the circuit is
0.5 lead
0.866 lag
0.866 lead
0.5 lead

⇒ The kinetic energy of free electrons in a metal is (where k is the de-Broglie wave number of the electron)
inversely proportional to k
inversely proportional to square of k
proportional to k
proportional to the square of k

⇒ Feedback factor may be less or more than 1.
TRUE
FALSE

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ A person with a receiver is 5 km away from the transmitter. What is the distance that this person must move further to detect at 3 dB decrease in signal strength?
942 m
2070 m
4978 m
5320 m

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ In an end fire array, the radiation pattern
is in the plane of array
is at right angles to array
is at an angle to the plane of array
either (b) or (c)

⇒ According to Barkhausen criteria in order to sustain the oscillations
loop gain of the circuit must be negligible
loop gain of the circuit must be equal to unity
the phase shift around the circuit must be 180°
none of the above

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ The frequency range of 300 kHz to 3000 kHz is known as
low frequency
medium frequency
high frequency
very high frequency

⇒

Assertion (A): In TE mode for rectangular waveguide.

Reason (R): In TM mode for rectangular waveguide.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the circuit of figure the switch is closed at t = 0, At t = 0⁺ this current through inductanc
0
0.416666666666667
6.67 A
5.1 A

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ Public address systems generally use electret microphones.
TRUE
FALSE