Question is ⇒ In the given figure RC = RL = 1 kΩ, then V0</su, Options are ⇒ (A) 5 V, (B) 2.5 V, (C) 1 V, (D) 0 V, (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure RC = RL = 1 kΩ, then V0</su, Options are ⇒ (A) 5 V, (B) 2.5 V, (C) 1 V, (D) 0 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure R_C = R_L = 1 kΩ, then V₀
A.	5 V [Wrong Answer]
B.	2.5 V [Correct Answer]
C.	1 V [Wrong Answer]
D.	0 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ If p is the probability of success and q is the probability of failure, then the probability that there are r successes in n trails is
ⁿc_r p^r qⁿ ^- ^r
ⁿc_r p^{n -} ^r q^r
ⁿc_r p^r qⁿ ⁺ ^r
ⁿc_r pⁿ qⁿ ^{- r}

⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0

⇒ If the thermal resistance of a transistor is lower it means
higher junction temperature
lower junction temperature
higher or lower junction temperature depending on circuit conditions
higher or lower junction temperature depending on transistor

⇒ A pure tone at 1000 Hz has a dB level of 50 dB. If two such tones exist simultaneously the dB level is about
50 dB
53 dB
100 dB
200 dB

⇒ Binary multiplication 1 x 0 =
1
0
10
11

⇒ The purpose of incorporating a pre-selector stage in a receiver is to
provide higher selectivity
provide higher fidelity
improve linearity
larger passband

⇒ In the circuit of figure for sinusoidal input the waveform of the output will be as show
figure A
figure B
figure C
figure D

⇒ In a second order undamped system, the poles are on
positive real axis
imaginary axis
negative real axis
either (a) or (c)

⇒ Find 'X' in the circuit be
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15)
0
Σ(14)
1

⇒ Schering bridge operates at a high voltage of about 10 kV.
TRUE
FALSE

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ Which op-amp circuit uses a diode as one of the circuit components?
Integrating amplifier
Differentiating amplifier
Logarithmic amplifier
Summing amplifier

⇒ In the circuit shown in the given figure, the current flowing through resistance of 100 Ω woul
8 mA
10 mA
20 mA
100 mA

⇒ The number of variables in a function is odd and the number of minterms with even number of 0's are same as the number of minterms with odd number at 1's, the expression formed can be represented in __________ as well as __________ form.
Ex - OR, NOR
Equivalence, Ex - OR
AND, Coincidence
OR, Ex - OR

⇒ Consider the following DO statement in Fortran 77 10
2
5
zero

⇒ Decimal 43 in hexadecimal and BCD number system is respectively.
B2, 01000011
2B, 01000011
2B, 00110100
B2, 01000100

⇒ Which is a valid Java variable?
1 a b
56 a
a 56
5 a 6

⇒ Feedback factor may be less or more than 1.
TRUE
FALSE

⇒ In which of the following logical group instructions of 8085 is the addressing mode 'immediate'?
ANA r
ANA M
ANI data
XRA r

⇒ A compensated wattmeter has its reading corrected for error due to which one of the following parameters?
Frequency
Friction
Power consumed in current coil
Power consumed in pressure coil

⇒ The Table given below is the mark obtained by 2 students in 8 different subjec
y + 0.57x = 9.7558
y - 0.57x = 9.758
033y + x = 6.335
0.33y - x = 6.335

⇒ In a single stage differential amplifier, the output offset voltage is basically dependent on the mismatch of
V_BE, I_B and β
V_BE and I_B
I_B and β
V_BE and β

⇒ The colour code on a carbon resistor is brown-black-red-gold. The value of resistance is
100 Ω
1000 Ω
1000 Ω ± 5%
1000 Ω ± 10%

⇒ In an underdamped RLC series circuit, the natural frequency is ω_n. The frequency of damped oscillations is
ω_n
less than ω_n
more than ω_n
2 ω_n

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In the given figure x_{6de(ax₁ + bx₂ + cx₃)
(a + b + c) (x₁ + x₂ + x₃) (d + e)
(ax₁ + bx₂ + cx₃) (d + e)
a b c d e (x₁ + x₂ + x₃)}

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ An image uses 512 x 512 picture elements. Each element can take any of eight distinguishable levels. The maximum entropy in the above image will be
2097152 bits
786432 bits
648 bits
144 bits

⇒ One XOR gate can work as
one bit magnitude comparator
two bit magnitude comparator
either (a) or (b)
neither (a) nor (b)