Question is ⇒ The distributors for residential areas are, Options are ⇒ (A) single phase, (B) three phase three wire, (C) three phase 4 wire, (D) (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ The distributors for residential areas are, Options are ⇒ (A) single phase, (B) three phase three wire, (C) three phase 4 wire, (D) (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The distributors for residential areas are
A.	single phase [Wrong Answer]
B.	three phase three wire [Wrong Answer]
C.	three phase 4 wire [Correct Answer]
D.	(a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Value of Z_L for maximum power transfe
R
R + jωL
R - jωL
None of these

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ The peak factor is the ratio of
peak and rms values
peak and average values
rms and average values
none of the above

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is
in the off-state
in the ON state
reverse biased
at the point of breakdown

⇒ If a_ac for transistor is 0.98 then β_ac is equal to
51
49
47
45

⇒ The main function of a balanced modulator is to
produce balanced modulation of a carrier wave
produce 100% modulation
suppress carrier signal in order to create a single-sideband or double sideband
limit noise picked by a receiver

⇒ It is desired to reduce distortion in a CE amplifier circuit. We should
reduce emitter current
reduce collector current
reduce ac base voltage
reduce base emitter voltage

⇒

Assertion (A): CCIR-B system has 625 scanning lines per frame and 2 : 1 interlace.

Reason (R): The aspect ratio is 4 : 3

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Wave A starts its positive half cycle at ωt = 30° and wave B starts its positive half cycle at ωt = 75° then wave B is leading wave A by 45°.
TRUE
FALSE

⇒ Figure represen
NPN transistor
PNP transistor
Zener diode
Power diode

⇒ Terra-watt is equal to
10³ W
10⁶ W
10⁹ W
10¹² W

⇒ If x₁(t) = 2 sin pt + cos 4 pt and x₂(t) = sin 5 pt + 3 sin 13 pt then
x₁, x₂ both periodic
x₁ x₂ both not periodic
x₁ periodic, x₂ not periodic
x₁ is not periodic ; but x₂ is periodic

⇒ Which of the following is not an assembler directive in 8085?
D S
D B
D Q
E Q U

⇒ The minimum number of 2 input NAND gates required to implement Boolean function A B C is A, B, C are available is
2
3
5
6

⇒

Assertion (A): Electronic and Ionic polarization in a polyatomic gas are independent of temperature.

Reason (R): The orientation polarization is independent of temperature.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ (1111.11)₂ is
(1.01)₁₀
(0.75)₁₀
(15.3)₁₀
(15.75)₁₀

⇒ Which of the following conditional statements is not valid in Pascal?
If A > = B then B : = C + D + X
If (N = 45) THEN X : = X + 2 ELSEX : = 0
If A < = B then A : = C * D
If (A > = B) X : Y else X : = Z

⇒ The resistance in the circuit of the moving coil of a dynamometer wattmeter should be
very low
low
high
almost zero

⇒ A casual LTI system is described by the difference equat
|a| = 2 |β| < 2
|a| > 2 |β| > 2
|a| < 2 any value of β
|β| < 2, any value of a

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ Which of the following is correct?
Voltages across a capacitance can change instantaneously
Voltages across a capacitance cannot change instantaneously
Charge across a capacitance is always constant
Charge across a capacitance can change instantaneously

⇒

Match the following:

	List I (Characteristic equation)		List II (Degree of damping)
A.	s² + 15s + 56.25	1.	Undamped
B.	s² + 5s + 6	2.	Underdamped
C.	s² + 20.25	3.	Critically damped
D.	s² + 4.55s + 42.25	4.	Overdamped

A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-1, B-2, C-4, D-3

⇒ The characteristic equation of an SR flip-flop in given by
Q_n+1 = S + RQ_n
Q_n+1 = RQ_n + SQ_n
Q_n+1 = S + RQ_n
Q_n+1 = S + RQ_n

⇒ The n state variables can be considered as n components of a state vector.
TRUE
FALSE

⇒ In figure, the power associated with 3 A sourc
36 W
24 W
16 W
8 W

⇒ Consider the following logical IF statement in Fortran 77 IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 13, 11, 11
IF (SALT - PEPPER) 13, 13, 11
IF (SALT - PEPPER) 11, 13, 13

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ The cut in voltage of a diode is nearly equal to
applied forward voltage
applied reverse voltage
barrier potential
none of the above

⇒

Assertion (A): Resistivity of a perfect single crystal of a metal goes to zero as T approaches zero.

Reason (R): Scattering of electrons is due to deviations from perfect periodicity of lattice.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder