Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | In a JFET |

A. | drain current is very nearly equal to source current [Correct Answer] |

B. | drain current is much less than source current [Wrong Answer] |

C. | drain current may be equal to or less than source current [Wrong Answer] |

D. | drain current may be even more than source current [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ In a full bridge single phase inverter feeding RLC load

one thyristor and one diode conduct simultaneously

two thyristors conduct simultaneously

two thyristors or two diodes conduct simultaneously

four thyristors conduct simultaneously

⇒ In setting up 'for' loops in Pascal, the initial and final values of index may be

integer constants

Integer constants or integer variable names

integer constants or integer variable names or integer expressions

integer constants or real constants

⇒ Which quantity controls the effectiveness of LED in emitting light?

Applied voltage

Current

Extent of doping

Temperature

⇒ The characteristics of a non-linear resistance is

*i*=

*kv*

^{4}. If

*i*becomes 100 times,

*v*becomes

about 100 times

about 10 times

about 3 times

about twice

⇒ The polar plot of G(

*j*ω) = 1/

*j*ω is

positive imaginary axis

positive real axis

negative imaginary axis

negative real axis

⇒ For a second order system, the position of poles is in the shaded region shown in the given figure. The variation in damping facto

from 0 to 1

from about 0.3 to 0.7

from 1 to 5

from 0 to 3

⇒

**Assertion (A):** If an event A can happen in *m* ways and another event B can happen in *n* ways, both can happen in *mn* ways.

**Reason (R):** Two events are mutually exclusive if happening of either precludes the occurrence of other.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is true, R is false

A is false, R is true

⇒ If σ standard deviation, probable error

σ

± 1.19 σ

± 0.6745 σ

± 0.4125 σ

⇒ Armstrong F.M. transmitter performs frequency multiplication in stages

to increase the overall S/N

for convenience

to reduce the bandwidth

to find the desired value of carrier frequency with frequency deviation

⇒ The early effect in a BJT is caused by

fast turn on

fast turn off

large collector base reverse bias

large emitter base forward bias

⇒ A wire has a resistance R ohm. If another wire of the same material and same weight has double the diameter (as compared to the first wire), the resistance of the second wire will be

0.5 R

0.25 R

0.125 R

R/16

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10

^{-19}C, thermal voltage = 26mV and electron mobility = 1350 cm

^{2}

2.16 x 10

^{4}A/cm

^{2}

1.08 x 10

^{4}A/cm

^{2}

4.32 x 10

^{3}A/cm

^{2}

6.48 x 10

^{2}A/cm

^{2}

⇒

**Assertion (A):** An ac regulator uses natural commutation

**Reason (R):** An ac regulator can be used for static on load tap changing of transformer.

Both A and R are correct and R is correct explanation of A

Both A and R correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ For a D/A converter, inputs and outputs are given. The output corresponding to digital input 01

2.0 V

2.5 V

3.0 V

4.0 V

⇒ A small signal source

*v*(

_{i}*t*) = A cos 20

*t*+ B sin10

^{6}

*t*is applied to a transistor amplifier as shown below. The transistor has β = 150 and

*h*= 3 kΩ. Which expression best approximates V

_{ie}_{0}(

*t<*

v

v

v

V

v

_{0}(*t*) = -1500 (A cos 20*t*+ B sin 10^{6}*t*)v

_{0}(*t*) = -150 (A cos 20*t*+ B sin 10^{6}*t*)v

_{0}(*t*) = -1500 B sin 10^{6}*t*V

_{0}(*t*) = -1500 sin 10^{6}*t*

⇒ Binary number 1101.101 is equivalent to decimal number?

13.5

13.75

13.625

13.875

⇒ The following table gives some Laplace transforms and the functions

le>Of these the correctly matched pairs are

2 and 4

1 and 4

2 and 4

1 and 2

⇒ An 8156 has A

80 H

85 H

82 H, 83 H

80 H to 85 H

⇒ In a single phase cycloconverter with centre tapped transformer

all thyristors carry currents for equal duration

the durations of currents in all thyristors may or may not be equal

the durations of currents in all thyristors cannot be equal

the duration of currents in all thyristors must be equal for satisfactory operation

⇒ A JK flip flop can be converted to D flip flop by

Connecting both J and K terminals to D

Connecting J terminal to D and leaving K open

Connecting K terminal to D and leaving J open

Connecting J terminal to D and K terminal to D through an inverter

⇒ Which of the following statement is correct?

Decimal 9 is represented as 1011 in Excess-3 code

Decimal 9 is represented as 1001 is BCD code

Decimal 10 is represented as 1100 is Gray code

Decimal 10 is represented as 1001 in binary code

⇒ A permeable substance is one

which is strong magnet

which is a weak magnet

which is a good conductor

through which magnetic lines of force can pass easily

⇒ The subtraction of a binary number Y from another binary number X, done by adding the 2's complement of Y to X results in a binary number without overflow. This implies that the result is

-ve and is in normal form

-ve and 2's complement form

+ve and is in normal form

+ve and in 2's complement

⇒ In a CE amplifier circuit, the output voltage

is very small

is always constant

depends on β

none of the above

⇒ Consider the following statements in connection with CMOS inverter in figure where both the MOSFET are of enhancement type and both have a threshold voltage of

Only statement 1 is true

Only statement 2 is true

Both the statement are true

Both the statements are false

⇒ FM broadcast is used in

VHP range

UHF range

MF range

both VHP and UHF range

⇒ In an unloaded transformer, the fluxes limiting the primary and secondary are 30 mWb and 20 mWb. The coefficient of coupling is

1

0.1

0.33

0.67

⇒ Find equivalent resistance. Each resistance is l &Om

5/12 Ω

5/6 Ω

6/5 Ω

6/10 Ω

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat

⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy

curve 1 shows highest gain margin and curve 2 shows poorest gain margin

gain margins shown by the three curves are equal

curve 1 shows poorest gain margin and curve 3 shows highest gain margin

curve 3 shows poorest gain margin while curve 1 shows highest gain margin

⇒ Binary number 1101.101 is equivalent to decimal number?

13.5

13.75

13.625

13.875

⇒ The following table gives some Laplace transforms and the functions

f(t) | F(s) | |

1. | δ(t) | s |

2. | u(t) | 1/s |

3. | tu(t) | 2/s^{2} |

4. | t^{2}u(t) | 2s^{3} |

2 and 4

1 and 4

2 and 4

1 and 2

⇒ An 8156 has A

_{15}connected to its CE input. A_{14}to A_{8}are unconnected, and AD_{7}to AC_{0}are connected.Ignoring shadows, the port addresses80 H

85 H

82 H, 83 H

80 H to 85 H

⇒ In a single phase cycloconverter with centre tapped transformer

all thyristors carry currents for equal duration

the durations of currents in all thyristors may or may not be equal

the durations of currents in all thyristors cannot be equal

the duration of currents in all thyristors must be equal for satisfactory operation

⇒ A JK flip flop can be converted to D flip flop by

Connecting both J and K terminals to D

Connecting J terminal to D and leaving K open

Connecting K terminal to D and leaving J open

Connecting J terminal to D and K terminal to D through an inverter

⇒ Which of the following statement is correct?

Decimal 9 is represented as 1011 in Excess-3 code

Decimal 9 is represented as 1001 is BCD code

Decimal 10 is represented as 1100 is Gray code

Decimal 10 is represented as 1001 in binary code

⇒ A permeable substance is one

which is strong magnet

which is a weak magnet

which is a good conductor

through which magnetic lines of force can pass easily

⇒ The subtraction of a binary number Y from another binary number X, done by adding the 2's complement of Y to X results in a binary number without overflow. This implies that the result is

-ve and is in normal form

-ve and 2's complement form

+ve and is in normal form

+ve and in 2's complement

⇒ In a CE amplifier circuit, the output voltage

is very small

is always constant

depends on β

none of the above

⇒ Consider the following statements in connection with CMOS inverter in figure where both the MOSFET are of enhancement type and both have a threshold voltage of

Only statement 1 is true

Only statement 2 is true

Both the statement are true

Both the statements are false

⇒ FM broadcast is used in

VHP range

UHF range

MF range

both VHP and UHF range

⇒ In an unloaded transformer, the fluxes limiting the primary and secondary are 30 mWb and 20 mWb. The coefficient of coupling is

1

0.1

0.33

0.67

⇒ Find equivalent resistance. Each resistance is l &Om

5/12 Ω

5/6 Ω

6/5 Ω

6/10 Ω

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat

*AB**BC**CD**BD*⇒ The given figure shows log magnitude versus ω plots of a system for different values of gain. For this sy

curve 1 shows highest gain margin and curve 2 shows poorest gain margin

gain margins shown by the three curves are equal

curve 1 shows poorest gain margin and curve 3 shows highest gain margin

curve 3 shows poorest gain margin while curve 1 shows highest gain margin