Question is ⇒ A transistor is said to be in a quiescent state when, Options are ⇒ (A) the amplitude of input and output signal is equal, (B) the phase of input and output signal is identical, (C) no signal is applied to the input, (D) the transistor is unbiased, (E) , Leave your comments or Download question paper.

Question is ⇒ A transistor is said to be in a quiescent state when, Options are ⇒ (A) the amplitude of input and output signal is equal, (B) the phase of input and output signal is identical, (C) no signal is applied to the input, (D) the transistor is unbiased, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A transistor is said to be in a quiescent state when
A.	the amplitude of input and output signal is equal [Wrong Answer]
B.	the phase of input and output signal is identical [Wrong Answer]
C.	no signal is applied to the input [Correct Answer]
D.	the transistor is unbiased [Wrong Answer]
View Answer 3 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A p matching network for coupling the transmitter output of the antenna is shown in figu
minimum D.C. plate current
maximum D.C. plate current
maximum RF antenna current
specified value of the D.C. plate current

⇒ A moving coil instrument has a resistance of 0.5 Ω and a full scale deflection of 0.1 A. To convert it into an ammeter of 0-10 A the shunt resistance should be
0.004 Ω
0.005 Ω
0.05 Ω
0.1 Ω

⇒ In microwave communication, some times, microwave signals reach large distances by following the earth curvature. This phenomenon is called
tropospheric scatter
faraday effect
ionospheric reflection
ducting

⇒ A virtual ground is a ground for
voltage
current
both voltage and current
voltage but not for current

⇒ In Pascal the repeat and while loops will terminate
only when the logical expression controlling the loop becomes true for both repeat and while loops
only when the logical expression controlling the loop becomes false for both repeat and while loops
only when the logical expression controlling the loop becomes true for repeat loop and false for while loop
only when the logical expression controlling the loop becomes false for repeat loop and true for while loop

⇒ The current due to thermionic emission is given by Richardson Dushman equation.
TRUE
FALSE

⇒ In any two port network, input impedance is independent of load impedance.
TRUE
FALSE

⇒ Fill in the suitable word in the blanks is the following questions. The electron in the outermost orbit is called __________ electron.
valence
covalent
acceptor
donor

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
0.0125
0.025
-0.0125
-0.025

⇒ Most of the communication satellites are stationed to the West of their service areas in order to reduce their
eclipse period
loss of power
battery power provision
mass of station-keeping fuel

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above

⇒ The purpose of connecting a coupling capacitor in the output circuit of an amplifier is
to increase voltage gain
to increase collector current
to block dc collector voltage
all of the above

⇒ The simplest mixer circuit for public address system uses
fixed resistances
variable resistances
inductances
capacitances

⇒ Two coils X of 1000 turns and Y of 2000 turns are placed such that 60% of the flux produced by coil X links coil Y. A current of 1 A in coil X produces 0.1 wb flux. The mutual inductance between coils is
0.12 H
0.08 H
0.06 H
0.04 H

⇒ In figure, the switch is closed at t = 0. At t = 0⁺, di/dt = 4 A/s. Then
10 V
20 V
40 V
80 V

⇒ Figure shows an RC potentiometer to measure ac voltage. It is desired that V₀/V_i should be independent of frequency. The value of C should
10 μF
11 μF
0.1 μF
0.09 μF

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ The minimum energy of a photon required for intrinsic excitation is equal to
energy of bottom of conduction band
energy of top of valence band
forbidden gap energy
Fermi energy

⇒ If a sample of germanium and a sample of silicon have the same impurity density and are kept at room temperature
both will have equal value of resistivity
both will have equal negative resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than that of germanium

⇒ Which of the following is a circularly polarized antenna?
Horn
Dipole
Helical
Pyramidal

⇒ In a tungsten filament lamp
the current at the instant of switching is less than operating current
the current at the instant of switching is more than operating current
the current at the instant of switching is equal to operating current
the current at the instant of switching may be less than or equal to operating current

⇒ A CE amplifier is the most common BJT amplifier.
TRUE
FALSE

⇒ Find V_th in the cir
100 V
10 V
0 V
5 V

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The ROC of sequence in the Z.T. of sequence x[n] = aⁿ ∪ [n] is
z > a
z < a
|z| > a
|z| < a

⇒ Earth's curvature affects the effective height of antenna.
TRUE
FALSE

⇒ For a junction FET in the pinch off region as the drain voltage is increased, the drain current
becomes zero
abruptly decreases
abruptly increases
remains constant

⇒ In a flip-flop with RS latch a high S and a low R set the output to __________ and a low S and a high R set the output __________ .
low, low
high, high
low, high
high, low

⇒

Assertion (A): A higher level language is less efficient that machine language but more efficient than assembly language.

Reason (R): It is easier to learn and use higher level language than machine language.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct