Question is ⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti, Options are ⇒ (A) 0.02 V/μsec, 1.59 KHz, (B) 0.04 V/μsec, 1.59 KHz, (C) 0.02 V/μsec, 3.58 KHz, (D) 0.02 V/μsec, 1.59 KHz, (E) , Leave your comments or Download question paper.

Question is ⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti, Options are ⇒ (A) 0.02 V/μsec, 1.59 KHz, (B) 0.04 V/μsec, 1.59 KHz, (C) 0.02 V/μsec, 3.58 KHz, (D) 0.02 V/μsec, 1.59 KHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
A.	0.02 V/μsec, 1.59 KHz [Correct Answer]
B.	0.04 V/μsec, 1.59 KHz [Wrong Answer]
C.	0.02 V/μsec, 3.58 KHz [Wrong Answer]
D.	0.02 V/μsec, 1.59 KHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a signal f(t/2) has energy is E/n then energy of the signal f(nt) is equal to __________ (n is constant)
E/2n²
2E/n²
E/n²
2En²

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒

Assertion (A): Feedback control systems offer more accurate control than open loop systems.

Reason (R): The feedback path establishes a link for comparison of input and output and subsequent error correction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A transistor amplifier has pole
s₁
s₁ + s₂ + s₃ + s₄
s₁ + s₄
s₄

⇒ On which bands, do the optical fibers operate?

Ultra violet band
Ultra high frequency band
Visible light band
Infrared band

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ The dimensions of EMF are
ML²I^-1T^-3
M^-1T^-3
ML²I^-2T^-3
ML³I^-1T^-3

⇒ What is output 'Z' of an EX-OR gate, whose all inputs are set at A?
Z = A
Z = 1
Z = 0
Z = A

⇒ If a_ac for transistor is 0.98 then β_ac is equal to
51
49
47
45

⇒ To draw ac equivalent circuit for a CE amplifier we should
Reduce all dc sources to zero
Short all capacitors
Reduce all dc sources to zero and short all capacitors
Reduce all dc sources to zero and open all capacitors

⇒ Contents of RAM cannot be altered.
TRUE
FALSE

⇒ Consider the following expression for the driving point imped
2 and 4
1 and 3
1 and 4
2 and 3

⇒ In a superheterodyne receiver, the IF stage has better selectivity than RF stage because
of higher frequency
of lower frequency
of high L/C ratio
of constant passband

⇒ Which of the following is correct (FDM means Frequency Division Multiplexing and TDM means Time Division Multiplexing)?
FDM requires lower bandwidth but TDM has more noise immunity
FDM has more noise immunity and requires lower bandwidth than TDM
FDM requires channel synchronization while TDM has more noise immunity
FDM requires more multiplexing while TDM requires band pass filter

⇒ The IF amplifier in a superheterodyne receiver is
single-stage single-timed amplifier
two stage of single tuned amplifier
double tuned amplifier
class-C amplifier

⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
100
50
10
5

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
- sin ω₁t + cos ω₂t

⇒ In amplitude modulation, the magnitude of side bands is
ma/2 times the carrier amplitude, E_c
ma times the carrier amplitude, E_c
2ma times the carrier amplitude, E_c
4ma times the carrier amplitude, E_c

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒

Assertion (A): Hay's bridge in particularly suitable for measuring inductance having a comparatively low resistance.

Reason (R): In Hay's bridge the value of frequency supply must be known.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ In the stabilized reactance modulators AFC system
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency the better the oscillator frequency stability
the discriminator frequency must not be too low, or the system will fail
phase modulation is converted into FM by the equalizer circuit

⇒ In a display specified as 600 x 400 the number of pixels across the display screen is
600
400
240000
either (a) or (b)

⇒ A series resonant circuit has R = 10 Ω, L = 1 μH and C = 1 mF. If R is increased to 20 Ω the resonant frequency
increases
decreases
remains constant
may increases or decreases

⇒ For a series resonant circuit at low frequency circuit impedance is __________ and at high frequency circuit impedance is _______
capacitive, inductive
inductive, capacitive
resistive, inductive
capacitive, resistive

⇒ Two CE stages, 1 and 2 are coupled through a capacitor. V_CC is the same for both. Base resistances R_B1 and R_B2 are such that R_B1 > R_B2. Then
base currents for both stages are equal
base current of stage 1 is more than that of stage 2
base current of stage 2 is more than that of stage 1
either (b) or (c)

⇒ The elements which become superconducting at extremely low temperatures are
good conductors at room temperature
ferromagnetic at room temperature
relatively poor conductors at room temperature
insulators at room temperature

⇒ What will be conversion time of a successive approximation A/D converter which uses 2 MHz clock and 5 bit binary ladder containing 8 V reference.?
2.5 μ sec
25 μ sec
3 μ sec
4 μ sec

⇒ Symbol shown in figure represen
P-channel enhancement MOSFET
N-channel DEMOSFET
UJT with P-type base
UJT with N-type base

⇒ What is the address space of 8086 CPU?
One Megabyte
256 Kilobytes
1 K Megabytes
64 Kilobytes