Question is ⇒ The deflection sensitivity of a CRO is generally expressed in, Options are ⇒ (A) meter/V, (B) cm/V, (C) V/meter, (D) V/cm, (E) , Leave your comments or Download question paper.

Question is ⇒ The deflection sensitivity of a CRO is generally expressed in, Options are ⇒ (A) meter/V, (B) cm/V, (C) V/meter, (D) V/cm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The deflection sensitivity of a CRO is generally expressed in
A.	meter/V [Correct Answer]
B.	cm/V [Wrong Answer]
C.	V/meter [Wrong Answer]
D.	V/cm [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An ideal Op-amp is an ideal
voltage controlled current source
voltage controlled voltage source
current controlled current source
current controlled voltage source

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): Radio transmission is by sky waves

Reason (R): Waves having frequencies higher than 30 MHz penetrate the atmosphere and do not return to earth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A system has poles at 0.01 Hz, 1 Hz and 80 Hz, zeros at 5 Hz, 100 Hz and 200 Hz. The approximate phase of the system response at 20 Hz is
-90°
0°
90°
-180°

⇒ In the circuit shown below, the op-amp is ideal, the transistor has V_BE = 0.6 V and β = 150. Decide whether the feedback in the circuit is positive or negative and determine the voltage V at the output of the op
Positive feedback, V = 10 V
Positive feedback, V = 0 V
Negative feedback, V = 5 V
Negative feedback, V = 2 V

⇒ The advantage of pulse modulation is
the transmitted power can be concentrated into short bursts
the time intervals between pulses can be filled with sample values from other message
pulse wave may obtain appreciable D.C. and low frequency content
all of the above

⇒ When a JFET is cut off, it's like an __________ switch and when it is saturated, it's like a __________ switch.
closed, open
open, closed
open, open
closed, closed

⇒ In a 3 phase full wave regulator feeding a star connected resistance load the input voltage is 400 V line to line. The firing angle is 160°. The line to line output voltage would be
400 V
about 100 V
about 20 V
zero

⇒ Which one is discrete time periodic signal?
sin 3pn
cos 2pn
sin 3pn
all

⇒ Panel type instruments are used in
power stations
automobiles
industries
all of the above

⇒ If f(t) = A d(t - a), F(s) is
A e^-as
A e^as
A a e^-as
Aa e^as

⇒ In an ac network, Thevenin's impedance and Norton's impedance are
always the same
generally the same
sometimes the same
always different

⇒ In the given figure shows a negative logic AND gate. If positive logic is used this gate is equivalen
AND gate
OR gate
NOR gate
NAND gate

⇒ Which of the following stage is not present in AM receiver as compared to FM receiver?
AM amplifier
Demodulator
Amplitude limiter
AF amplitude

⇒ While forming Routh's array, the situation of a row of zeros indicates that the system
has symmetrically located roots
is not sensitive to variations in gain
is stable
is unstable

⇒

Assertion (A): A branch with no current through it can be replaced by an open circuit or short circuit.

Reason (R): Reciprocity theorem is applicable only if the circuit has one source.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The output characteristics of a bipolar transistor has three distinct regions. They are known as
saturation region, active region and breakdown region
inactive region, active region and breakdown region
inactive region, saturation region and active region
inactive region, saturation region and breakdown region

⇒ The subcarrier frequency for transmission of colour difference signals in TV systems in India is
9.47 MHz
4.43 MHz
2.06 MHZ
1.3 MHz

⇒ For input and later stages, BI-FET op-amp use
JFETs and MOSFETs respectively
MOSFETs and JFETs respectively
JFETs and BJTs respectively
BJTs and JFETs respectively

⇒ Which one of the following statements is wrong. The radar cross-section of a target?
depends on frequency
may be reduced by special coating of non-spherical target
depends on the aspect of target if it is non-spherical
is equal to actual cross-sectional area for small targets

⇒ L [f(t - a)] = F(jω) e^-jωa
TRUE
FALSE

⇒ Wave guides are pressurised above normal atmospheric pressure for
increasing the power handling capacity
improving conductivity of walls
preventing higher modes from propagation
varying the wave impedance

⇒ A total of 16 equally probable events exist. If it is required to select one out of them, the number of required bits is
2
4
3
5

⇒ The most important primary force of attraction in the formation of solids is
electromagnetic
electrostatic
quantum-electrostatic
quantum electromagnetic

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ In figure the zener has a resistance of 5 ohms. As the load resistance is varied, the output vol
will remain constant at 12 V
will vary between 12.05 and 12.65 V
will vary from 10 to 20 V
will remain constant at 12.05 V

⇒

Assertion (A): Demorgan's first theorem replaces a NOR gate by bubbled AND gate.

Reason (R): Double complement of a variable equals the variable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The circuit of figure is generally employed
bridge
low-pass filter
peaking network
high-pass filter

⇒ Circular polarization
is useful in reducing depolarization effect on received wave
involves critical alignment of transmitting and receiving antenna
is useful in discrimination between reception of adjacent beams
none of the above

⇒ The V_TH at terminals A and B is equa
0 V
5 V
-5 V
none