Question is ⇒ Which of the following is not correct in respect of electrostatic instrument?, Options are ⇒ (A) It is essentially a voltmeter, (B) It is suitable for only high voltages, (C) It has a uniform scale, (D) It can be used for both ac and dc, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is not correct in respect of electrostatic instrument?, Options are ⇒ (A) It is essentially a voltmeter, (B) It is suitable for only high voltages, (C) It has a uniform scale, (D) It can be used for both ac and dc, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is not correct in respect of electrostatic instrument?
A.	It is essentially a voltmeter [Wrong Answer]
B.	It is suitable for only high voltages [Wrong Answer]
C.	It has a uniform scale [Correct Answer]
D.	It can be used for both ac and dc [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit of figure, Thevenin's resistance is 10 &
25 Ω
10 Ω
13.33 Ω
6 Ω

⇒ Dual slope ADC uses an op amp comparator.
TRUE
FALSE

⇒ In 8085 stack pointer is
4 bit register
8 bit register
16 bit register
32 bit register

⇒ Which of the following 8085 instructions do not effect CY flag?
SEE M
SEE R
DCRM
ADC M

⇒ Consider the following statements as regards SAW filter

The centre frequency is determined by the pitch of IDT comb shaped electrodes
The response can be modified shaping the overlap of comb electrodes
The response is maximum when acoustic wave has its wavelength equal to pitch
When a number of identical electrodes are arranged at the same pitch, the frequency characteristics of the filter is expressed by (sin x)/x

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3 only
1, 2, 4 only
2, 3, 4 only

⇒

Assertion (A): The root locus of a control system is symmetrical about real axis.

Reason (R): For all polynomials with real coefficients, complex poles always occur in conjugate pairs.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ For low impedance SAW filter the most suitable material for substrate of SAW filter is
PZT ceramics
ZnO
Lithium titanate
Lithium neobate

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ The amount of dielectric heating is inversely proportional to frequency.
TRUE
FALSE

⇒ For AM receivers the standard IF frequency is
106 kHz
455 kHz
1.07 MHz
10.7 MHz

⇒ The attenuation characteristics of a loaded line is similar to that of
low pass filter
high pass filter
band pass filter
band stop filter

⇒ For an RC admittance function Y, the slope dY/dσ
is positive
is negative
may be positive or negative
0

⇒ The factor n in the equation for calculating current for a silicon diode is
1
2
2.5
2 for low levels of current and 1 for high levels of current

⇒ By connecting external resistances to a differential amplifier we can adjust
voltage gain
bandwidth
both voltage gain and bandwidth
none of the above

⇒ The simplest standing wave is due to the value of reflection co-efficient is
-1
zero
unity
infinity

⇒ Which of the following methods does not cause any reduction in instruction length?
Using program counter
Common source and destination address
Implicit source and destination address
Machine language programming

⇒ The radiation resistance of a resonant long wire antenna of half wavelength (λ/2) is given
73 Ω
120 p
377 Ω
7.3 Ω

⇒ An increase of reverse voltage decreases the junction capacitance.
TRUE
FALSE

⇒ Which of the following codes provides parity checks?
CCITT-2
EBCDIC
ASCII
Baudot

⇒ The counter which require maximum number of FF for a given mod counter is
Ripple counter
BCD counter
Ring counter
Programmed counter

⇒ Some features of RF stage in good radio receivers is

It increases sensitivity by providing amplification to RF signal
It eliminates image frequency interference
It increases selectivity
It reduces noise level

Which of the above are true?
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only
1, 2, 3, 4

⇒ Data from a satellite is received in serial form (1 bit after another). If this data is coming at a 5 MHz rate and if the clock frequency is 5 MHz how long will it take to serially load a word in a 32-bit shift register?
1.6ms
3.2ms
6.4ms
12.8ms

⇒ A Darlington pair is used for
low distortion
high frequency range
high power gain
high current gain

⇒ The difference between measured value and true value is called
gross error
relative error
probable error
absolute error

⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω

⇒ Which one of the following pairs is not correctly matched?
NaCl : Diamagnetic
Gd : Paramagnetic
Ferrite : Ferrimagnetic
Cr₂ O₃ : Ferromagnetic

⇒ Which of the following is used to obtain output position in a position control system?
Strain gauge
Load cell
Synchro
Thermistor

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ Which data transfer scheme is used when large block of data is to be transferred in a computer?
DMA
Programmed data transfer
Either (a) or (b)
Neither (a) nor (b)

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey