Question is ⇒ The flow rate of electrically conducting liquid without any suspended particle can not be measured by, Options are ⇒ (A) turbine flow meter, (B) electromagnetic flow meter, (C) ultrasonic flow meter, (D) thermistor based heat flow meter, (E) , Leave your comments or Download question paper.

Question is ⇒ The flow rate of electrically conducting liquid without any suspended particle can not be measured by, Options are ⇒ (A) turbine flow meter, (B) electromagnetic flow meter, (C) ultrasonic flow meter, (D) thermistor based heat flow meter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The flow rate of electrically conducting liquid without any suspended particle can not be measured by
A.	turbine flow meter [Wrong Answer]
B.	electromagnetic flow meter [Wrong Answer]
C.	ultrasonic flow meter [Wrong Answer]
D.	thermistor based heat flow meter [Correct Answer]
View Answer 2 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In CB amplifier the distortion of the input voltage waveform may occur due to
very low input resistance of an amplifier
very high input resistance of the amplifier
improper biasing
ripples in power supply

⇒ In a Vidicon camera tube
grid G₁ accelerates electrons
grid G₂ accelerates electrons and grid G₃, slows down electrons
grid G₃ accelerates electrons and grid G₂ slows down electrons
both grids G₂ and G₃ accelerate electrons

⇒

Assertion (A): Intrinsic resistivity of silicon is lower than that of germanium.

Reason (R): Magnitude of free electron concentration in germanium is more than that of silicon.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A bit synchronizer regenerates at the receiver a clock waveform which is
synchronous with original clock waveform
out of phase by 180° with original clock waveform
out of phase by 90° with the original clock waveform
none of the above

⇒ For a plate-modulated class C amplifier the plate supply voltage is E. The maximum plate cathode voltage could be almost high as
2E
3E
4E
6E

⇒ EEPROM is also known as
UVPROM
EAPROM
both UVPROM and EAPROM
none of the above

⇒ A 3 bit up-down counter can count from
000 to 111
111 to 000
000 to 111 and also from 111 to 000
none of the above

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ Circular polarized waves result when
magnitudes are the same
phases are the same
magnitudes are same and phase difference is 90°
magnitudes are same and phase difference is zero

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A three state switch has three outputs. These are
low, low and high
low, high, high
low. floating, low
low, high, floating

⇒ In directional coupler of the given figure, the terms |S₁₄| and |S₂₃| of scattering matrix are ne
1 each
0.5 each
0.1 each
1 and 0.5 respectively

⇒

Assertion (A): An instruction cycle consists of fetch and execute cycles.

Reason (R): Fetch cycle has one machine cycle but execute cycle may have one or more machine cycles depending on length of instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a complex wave, the negative half of the wave is a reproduction of the positive half wave. Then
the wave contains only fundamental and third harmonic
the wave does not contain even harmonics
the wave does not contain odd harmonics
the wave does not contain triple harmonics

⇒ In a half wave voltage doubler circuit the input frequency is 50 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
150 Hz

⇒ Poynting vector is the rate of energy flow having
W/m²
W-m
kWh/s
W/m

⇒ MCVF telegraphy causes
SSB techniques
pulse modulation
Out of bond signalling
FM

⇒ An audio signal of FM radio station is sampled at a rate of 15% above the Nyquist rate. Signal is sampled in 512 levels and bandwidth of the signal is 4 KHz. The minimum bandwidth required to transmit this signal will be
77 K bits/sec
92 K bits/sec
84.8 K bits/sec
82.8 K bits/sec

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R

⇒ What are the values of E_max and E_min displayed on the oscilloscope, when a 1 kV P-P carries is modulated to 50%?
2 kV, 0.5 kV
1 kV, 0.5 kV
0.75 kV, 0.25 kV
0.5 kV, 1.5 kV

⇒ For the system in the given figure, the characteristic equation
s² + s(3 + 6a) + 6 = 0
s² + s(3 + 12a) + 12 = 0
s² + 3s = 0
s² + 6s = 0

⇒ A rare gas has N atoms per m³. If electronic polarizability of single atom of this gas is a_e, then
∈_r = Na_e
∈₀∈_r = Na_e
∈₀(∈_r - 1) = Na_e
∈₀(∈_r - 2) = Na_e

⇒ Pirani gauge is used to measure
very low pressure
high pressure
pressure in the range of 1 atmosphere
fluid flow

⇒ The modulation index of an AM wave is measured using a CRO. The waveform is as shown in figure, the modulation index is nea
0.43
0.3
0.23
0.17

⇒ To make antenna more directional, either its size must be increased or
the number of its feed horns must be increased
the frequency of its transmission must be increased
its effective isotropic radiated power (EIRP) must be increased
its footprint must be increased

⇒

Assertion (A): FET has characteristics very similar to that of pentode.

Reason (R): Both FET and pentode are voltage controlled devices.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Magnetic deflection sensitivity is defined as
deflection/flux density
(deflection/flux density)^0.5
(Deflection)^0.5/flux density
none of the above

⇒ Which TM mode in rectangular waveguide has lowest cutoff frequency?
TM₁₁
TM₀₁
TM₁₀
TM₂₁

⇒ The dead zone in a pyrometer is 0.125% of span. The calibration is 400°C to 1000°C. What temperature change might occur before it is detected.
0.125°C
0.75°C
0.4°C
1°C